Top » Catalog » Acces. for Motors » Starters/CDi » SETOKW

16.00EUR

Opto Gas Engine Kill Switch
[SETOKW]

This kill switch is double Optically Coupled to isolate your ignition system from your radio system (No Interference!!). It also consist an additional safety functions.

Device features
• Includes a remote mountable ultra bright LED to indicate when the ignition is armed or not, or if the safety sequence protection is active.
• The LED diode informs also if Fail-Safe occured during flight (even after landing).
• Safety sequence protection for engine ignition powering up after model preparation.
• Double optically Coupled input/output is Isolated.
• Turning engine ignition ON or OFF directly from RC Transmitter
• No need to use additional mechanical switch for disconnecting ignition battery.
• 8 Bit microcontroller powered directly from RC receiver.
• 3,0 - 24,0 Volt Li-Po/Li-Ion/A123/Ni-Mh/NiCad Input (receiver side).
• 3,0 - 20,0 Volt Li-Po/Li-Ion/A123/Ni-Mh/NiCad MOSFET Output (ignition side).
• Possible to use one battery setup (independent two batteries setup by default).
• Max. current output: 5 Amp continous, 16 Amp peak
• Fail-Safe engine kill when interference or signal lose is longer then 1 second. (this function can be turned OFF).
• PPM-PCM 2048 – 1024 & 2.4Ghz Interface Support.
• Low Voltage Drop – Less than 150mv.
• 100% Surface Mount Technology.
• Heavy Gauge Wires 22AWG, universal connectors Futaba/JR.
• Small and light weight – only 15 Grams!

This device plugs into a spare receiver channel.

This is a must have safety device for any gas powered plane! This device allows you to safely kill your engine at anytime (on the ground, or inthe air!)

temporarily out of stock

Reviews

Customers who bought this product also purchased

Spark motor OS nº 3

temporarily out of stock

Quick Find

Shopping Cart

1 x	2000A 12V Lithium Jump Starter with 150PSI Air inflator
1 x
2 x	Hovercraft sailcloth
1 x	Monokote BLANCO jet (1.8x0.65m)
1 x	1,6x1000 mm 2:1 black termoretract tube
1 x	20 g tin paste
1 x	Angled clevis with threaded rod M3
1 x	Clevis plastico I=44 mm / hole 3mm / pin 2 (2 pcs)
1 x	Spray YELLOW Inca Lexan 150ml
1 x	PARTALL® Hi-Temp Wax, 340 g
1 x	4 mm M3 red control terminal (4 pcs)
1 x	Oracover Brown 2 m
1 x	Hobbylite Filler, Balsa colour
1 x	Couple M4 for wire (10 pcs)
1 x	Nitroverdu 500 ml
1 x	37 mm PVC transparent battery termo-retract (1 m)
1 x	1,2x1000 mm 2:1 red termoretract tube
1 x	Aluminium coupler M2,5/2 with ball bearing (1 pcs)
1 x	Ball link Aluminio M3 (2 pcs)
1 x	1,6x1000 mm 2:1 red termoretract tube
1 x	Kwik link AL M3 L:40 mm (2 pcs) + Pin Ø 2,5 mm
1 x	19 mm 2:1 black termoretract tube
1 x	165 mm PVC transparent battery termo-retract 165 mm (10 m)
1 x	Aluminium blue ball links M3 V1 (10 pcs)
1 x	Painting GHT Lexan Black 150 ml
1 x	2,4x1000 mm 2:1 black termoretract tube
1 x	ORACOVER Ferrari red (2 m)
1 x	Kwik link AL M2,5 L:23 mm (2 pcs) + Pin Ø 1,6 mm
1 x	33 x 8 mm cylidric hinge Ø 2,5 mm (10 pcs)
1 x	Clevis plastico I=30 mm / hole 2.5mm / pin 1 (2 pcs)
1 x	Ball link Aluminio M3 x 3 x 5 x 18mm (6 uds)
1 x	500 ml sealer (DOPE)
1 x	Kwik link AL M4 con Clip (2 pcs)
1 x	1,2x1000 mm 2:1 black termoretract tube
1 x	Cable coupler M2 (10 uds)
1 x	ABS 500 x 400 x 1,5 mm (white)
1 x	ABS Strip 1.5x8.0x1000 mm
1 x	Carbon fibre tape 125 g/m², 3k, UD (25 mm) roll/ 50 m
1 x	Surface Indicator Gauge Small
1 x	Connector CAN 15
1 x	Lock washer 3.2 mm (20 pcs)
1 x	Cable silicona macho batt. receptor 30 cm (Futaba)
1 x	ABS Strip 1.0x2.0x1000 mm
1 x	Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 50 m
1 x	Round Rod 2,0x1000 mm
1 x	Aluminium wide washer M4 Gold (4 pcs)
1 x	Double conector with JR adapter and 200 mm extension
1 x	Strip ABS 2.0x10.0x1000 mm
1 x	Simulador RealFlight RF-9.5 S (sin emisora)
1 x	"Y" charging 4mm wire (2 IN-1 OUT).
1 x	Truck-trailer for gliders 720 x 239 mm
1 x	Spring lock washer 2.6 mm (20 pcs)
1 x	Circlik for shaft 1.5 mm (10 pcs)
1 x	ABS Strip 1.5x4.0x1000 mm
1 x	Conector FUTABA Servo male BLUE silicon (10 pcs)
1 x	Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm)
1 x	Round Rod 1,25x1000 mm
1 x	Xplorer4 anemometro
1 x	3 LiPo XH>EH adapter
1 x	Cable silicona macho batt. receptor 30 cm (Graupner)
1 x	Connector Sub-D 2+5 Female
1 x	Round Rod 2,5x1000 mm
1 x	AIREX® Sheets C 70.55 (YELLOW) 1200x550x2.0 mm (20 pcs)
1 x	Conector MT-60 (pair)
1 x	Towing hook
1 x	Conector male bateria 1s Kavan/Walkera 10cm cable
1 x	ABS I Strip 10x5x1000 mm
1 x	TopFuel LiPo 20C-ECO-RX 500mAh 2S
1 x	TP/TopFuel - JST-EH 4/5S Adapter
1 x	Battery Protection Circuit Board 22.2v 6s
1 x	AXI 2808/16 V2 Long
1 x	TopFuel LiPo 20C-ECO-X 4500mAh 3S
1 x	LiPo Storage Box Standard 1 Type 1
1 x	Motor A40-10 L V2 14-Pole Glider
1 x	Motor A30-14 L V4
1 x	Sparkplug 1/4-32 EVO 10GX
1 x	AXI 2826/8 V2 Long
1 x	LiPo TopFuel ECO-X 3800mAh 2s 20C MTAG
1 x	TopFuel LiPo 35C-ECO-X 2400mAh 3S MTAG
1 x	AXI 2814/12 V2 Long
1 x	Motor A50-12 L Glider
1 x	TopFuel LiPo 25C-ECO-X 900mAh 2S
1 x	TopFuel LiPo 20C-ECO-X 2400mAh 2S MTAG
1 x	AXI 2820/12 V2
1 x	AXI 2814/20 V2
1 x	Spark plug key NGK MVVS
1 x	TopFuel LiPo RX 25C-ECO-X 800mAh 2S
1 x	Motor B20-10 L + 4:1 gearbox
1 x	A40-10S V2 8-Pole + 6,7:1 PG
1 x	Shaft for A60-L V4
1 x	Motor A50-14 L 8-Polos Electric turbine
1 x	Radial mount for electric 2.5-5.6
1 x	Motor A40-14 L 14-Pole V4
1 x	Axle for motor A20-S (3 uds)
1 x	AXI 2217/20 V2 Long "F5J"
1 x	TopFuel LiPo 20C-ECO-X 5000mAh 6S
1 x	Aluminium battery holder red
1 x	AXI 2212/12 V2
1 x	TopFuel LiPo 25C-ECO-X 1800mAh 2S
1 x	Motor A10-7 L 4,4:1
1 x	AXI 2814/6D V2
1 x	Battery bed V2_S (black)
1 x	AXI 2826/10 V2 Long
1 x	TopFuel LiPo 35C-X 5000mAh 6S
1 x	AXI 2808/20 V2 Long
1 x	Motor A60-7XS V4 28-pole kv330
1 x	LiPo TopFuel ECO-X 5000 mAh 3s 20C MTAG
1 x	Battery bed V2_M (black)
1 x	Motor B20-18 L + 4:1 gearbox
1 x	Motor A20-6 XL 10-Pole EVO + 4,4:1
1 x	Compact on-board starting system (9715)
1 x	Compact on-board starting system (9724)
1 x	1804 2400KV Brushless Motor Qav 250 mini

5,252.23EUR