16.00EUR

Opto Gas Engine Kill Switch
[SETOKW]


This kill switch is double Optically Coupled to isolate your ignition system from your radio system (No Interference!!). It also consist an additional safety functions.

Device features
• Includes a remote mountable ultra bright LED to indicate when the ignition is armed or not, or if the safety sequence protection is active.
• The LED diode informs also if Fail-Safe occured during flight (even after landing).
• Safety sequence protection for engine ignition powering up after model preparation.
• Double optically Coupled input/output is Isolated.
• Turning engine ignition ON or OFF directly from RC Transmitter
• No need to use additional mechanical switch for disconnecting ignition battery.
• 8 Bit microcontroller powered directly from RC receiver.
• 3,0 - 24,0 Volt Li-Po/Li-Ion/A123/Ni-Mh/NiCad Input (receiver side).
• 3,0 - 20,0 Volt Li-Po/Li-Ion/A123/Ni-Mh/NiCad MOSFET Output (ignition side).
• Possible to use one battery setup (independent two batteries setup by default).
• Max. current output: 5 Amp continous, 16 Amp peak
• Fail-Safe engine kill when interference or signal lose is longer then 1 second. (this function can be turned OFF).
• PPM-PCM 2048 – 1024 & 2.4Ghz Interface Support.
• Low Voltage Drop – Less than 150mv.
• 100% Surface Mount Technology.
• Heavy Gauge Wires 22AWG, universal connectors Futaba/JR.
• Small and light weight – only 15 Grams!

This device plugs into a spare receiver channel.

This is a must have safety device for any gas powered plane! This device allows you to safely kill your engine at anytime (on the ground, or inthe air!)


temporarily out of stock
temporarily out of stock

Reviews

Customers who bought this product also purchased
Spark motor OS nº 3
Spark motor OS nº 3

temporarily out of stock
temporarily out of stock

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x GLOW 2C + accesories
1 x DLE 30 complete electronic ignition
1 x GLOW 5C + accesories
1 x Adaptadores carga 6s JST-XH
1 x Electric Landing Gear "Black Edition" ULTIMATUM 3.0 (Elektron Re
2 x Starter EM Gear Power 80
1 x Compact on-board starting system (9715)
2 x Servo GO-1035MG 16 kg.cm 0.08s/60º
1 x Compact on-board starting system (9713)
1 x Encendido CDI RCAME 1/4*32 Single 120º
1 x Selfstarr DLE55, EME55/60, DLA56, SE 55
1 x Compact on-board starting system (9724)
1 x EXTRA NG 74" white/red/blue (Skywing RC)
1 x Ignition bed V2 Red color
2 x Recess mount-rem. glow plug set
1 x Conector MR-60 (pareja)
1 x Electromotor starter EME 35cc
1 x Extension MPX-MPX 20 cm
1 x Black "FUEL VENT" round aluminum overflow socket
1 x EXTREME FLIGHT BLUE MAGNETIC ROUND FILLER PLUG
1 x 
1 x 550 cc gasoline fuel tank complet
1 x Electron 22 mm Fitting barb
1 x Conector FESTO M3 Quick 3mm 90º
1 x 700 ml complete glow fuel tank
1 x Bob airtrap set
1 x 22m Fitting barb
1 x Blue "FUEL VENT" round aluminum overflow socket
1 x Check valve quick hose connector 4-4 mm
1 x Black "FUEL VENT" round aluminum overflow socket
1 x 18m Fitting barb
1 x Deposito DUBRO 3000cc-100oz
1 x EXTREME FLIGHT BLACK MAGNETIC ROUND FILLER PLUG
1 x Deposito combustible tipo "turbina" 330 ml
1 x Conector FESTO G1/8 Quick 4mm 90º
1 x "Taxi Tank" Fuel Tank
1 x EXTREME FLIGHT RED MAGNETIC ROUND FILLER PLUG
1 x 7.94 x 4.76 mm tygon tube 1 m
1 x 1/4 x 1/8" VITON tube for gas, kerosene, smoke (30 cm)
1 x Dubro Fuel Tank Cap/Fittings 2-24oz Tanks Gas
1 x Check valve V2
1 x 500 ccm gasoline fuel tank
1 x Deposito DUBRO 1800cc-60oz
1 x Reductora IPS 150 DX2BB-FXCS 11,8:1
1 x Excentric gearbox BB for motor 600, 3,2mm axis (2,8:1)
1 x Sparkplug 1/4-32
1 x Aluminium wide washer M3 blue (4 pcs)
1 x Carbon fiber rod 0.5 mmx1000 mm
1 x 6 mm red aluminium threaded horn with patella
1 x Threaded coupler ALU M2,5 Ø 4 (2 uds)
1 x 500 ml sealer (DOPE)
1 x Solvent Plasti Dip 1000 ml
1 x Recessed MPX connector support (6 pcs)
1 x Foil for sticking flaps and ailerons
1 x PVC 0,14 qmm servos wire JR/Graupner (5 m)
1 x 20 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x Aro pasacable Ø25 mm (4 pcs)
1 x PVC 0,08 qmm Graupner servos wire (5 m)
1 x 20x200 mm battery rings
1 x White silicone 0,25 qmm wire (100 m)
1 x Black copper lacquer wire Ø0,2 mm (5 m)
1 x TrainerCord (master-learner)
1 x Carbon tube (L 1000 mm, Ø1.5 mm, Ø0.7 mm)
1 x PVC 0,14 qmm servos wire Hitec/Mpx (5 m)
1 x ABS tube 8.0x7.0x1000 mm
1 x Zurich Sport Sunglasse Dark Sensity MAGENTA Glasses
1 x PVC 0,35 qmm servos wire Graupner (100 m)
1 x Micro screw-lock pushrod conn snap Ø 1 mm (2 uds)
1 x 14x60 mm Mini rings Tie Wraps (4 pcs)
1 x Glases Nimbus "Black"
1 x SINGLE FUELING VALVE GASOLINE MK2 SMALL
1 x Flap hinge (6 pcs)
1 x 165 mm PVC transparent battery termo-retract 165 mm (10 m)
1 x 1,2x1000 mm 2:1 red termoretract tube
1 x 3.2 mm Prop Adapter M6
1 x Indoor hinge with servo arm integraded
1 x Nylon hinge for flaps/gates 27x10,5 (2 pcs)
1 x AIREX® Sheets C 70.55 (YELLOW) 1200x550x2.0 mm (20 pcs)
1 x Cierre cabina aluminio Ø4, I=10 mm
1 x Carbon fibre tape 125 g/m², 3k, UD (25 mm) roll/ 50 m
1 x 4,8x1000 mm 2:1 black termoretract tube
1 x 3 mm Prop Adapter M6
1 x 4,8x1000 mm 2:1 blue termoretract tube
1 x Extra Hard Titanium Herxagon Screwdrivers
1 x Straightened rod Ø 1.5 mm x 1500 mm
1 x Smoke set "S"
1 x EXTRA NG 74" yello/blue/red (Skywing RC)
1 x Oracover Black 2 m
1 x Large flex hinge (12 uds)
1 x Miniature brass strap hinge, 1 m
1 x Blue smoke canister 100 g
1 x White smoke bombs AX-18 (5 pcs)
1 x White smoke bombs AX-9 (10 pcs)
1 x DYNAMOMETER S-1580
1 x Angle of incidence meter
1 x Field folding model stand
1 x Field folding model stand SebArt
1 x RCEXL Electronic ignition twin CM-6
1 x Compact on-board starting system (9525)
1 x Aluminium ignition bad (red)
7,724.94EUR
Manufacturers
Manufacturer Info
SETLO
SETLO Homepage
Other products
Languages
Español English
Currencies