69.90EUR 59.90EUR

SPS SafetyPowerSwitch 34V 60/120A
[EMCA72000]


Electronic safety switch with anti flash protection. The original! From the inventor of the "gas cap" switch.

Electronic safety power switch for electric power systems. An anti-flash-circuitry prevents the dreaded sparks during connecting the battery.

Separates the motor from the battery. The electric motor drive remains inactive and therefore non hazardous until activation. Finally you can work on your model without the fear of suddenly running motors.

High-class silicone connection cable of 4mm² (AWG11) thickness. 6-fold multilayer-board with up to 9mm² copper width.

For 2S up to 8S LiPo batteries (6V to 34V). 60A continuous current and 120A peak current - perfect for electric gliders, motor models and helicopters.

Attention: The flash protection function of the SPS does not pre-charge the capacitor within the motor controller! Some manufacturers require the pre-charging of this capacitor. Perhaps the SPS might not work properly in this special case.

NOTE: When using the following Graupner products the galvanic isolation of receiver and drive circuit is not possible. So the SPS Safety Power Switch cannot be used with these modules:
- Electric Air Module2-14S, Vario HoTT (Item no. 33620)
- General Engine-Module 2-6S Gr. HoTT (Item no. 33610)
- General Air-Module 2-6S, Vario Gr. HoTT (Item no. 33611)
- Voltage Module 2-4S, EH (Item no. 33630)
- Voltage Module 2-4S, XH (Item no. 33631)

Attention: The total capacity of all capacitors inside the ESC including additional capacitors must not exceed the value of 1500µF. In case of doubt ask the ECS's manufacturer.

Delivery includes desired switch actuator with keyring pendant, screws, EMCOTEC 3D sticker, operating instructions.



few units
few units

Reviews
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
Manufacturers
Manufacturer Info
Emcotec
Emcotec Homepage
Other products
Languages
Español English
Currencies