145.00EUR

Jet Afterburner Simulator NF-Jet3 RY
[NF-Jet3]


The NF-Jet3 module serves to simulate flame on the output of the jet engine unsing red and yellow ulttra bright LEDs (Light-Emitting Diodes) 3 or 5 mm. The input of te module has to be connected in paralell with the engine controller. The intensity of the flame follows the power of engine. First color starts to light in the beginning of "gas" range. The second color starts on the middle fo the range. To increase the reality of the flame the light intensity chages in pseudo-rabndom period. The frequence of changes speeds up when increasing the engine power.

The module is connected to receiver by Graupner, Hitec type connector. The module can also be connected as an uncontrolled unit when disconnecting the cable to a receiver. In this case the light intensity is 100% (full gas).

The module has two outputs for light rings. Each output drives two colors. Usually the first color is red and the second one is yellow. The wires use the same colors system. The brown wire in the middle is ground. This is a common negative pole of LEDs (cathodes) for both colors.

The NF-Jet3 units are optimized to work with LEDs circles with a diameter of 105 mm and has 72 LEDs. The unit has two concentric circles. both circles can work from 7 to 12 V (10 to 12 is optimum). The modules has an over-current protection. The NF-Jet3 has a current limitation at 200 mA. Pretection circuits needs approx. 2V reverse, so the optimal conditions for unit are from 12 to 14 V (10xMiNH or 3xLiPo).
It implements Red-Yellow colors.


temporarily out of stock
temporarily out of stock

Reviews
We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x LUCAS pilot ARTF
1 x Trike XL motor set (motor+esc+prop)
1 x Windsock Ozone L - 700 mm
1 x Para-RC "RC-Evo-Cross" Rescue
1 x Para-RC Mix
1 x Parachute BACKUP X100
2 x Wing OXY 5,0 m2
1 x Para-RC Trike "RC-Bullix"
1 x Wing OXY 0,5 pulgadas2
1 x Paramotor BackPack XXS (without accessories)
1 x Opale Rucksack
1 x Rescue 1,8m2 / BackPack
1 x Ballast 700gr OPALE
1 x Set cintas unión paracaídas 145 cm
1 x Windsock Ozone L -1200 mm
1 x Parachute PV6 for F3J
1 x Parachute P4
1 x Protective Cover for wires Ø 10 mm 1000 mm
1 x Smoke set "Glider"
1 x Plastic caps for AIR BURTS (30 pcs)
1 x Pilot "Duke" Legends Series (Slimline)
1 x Clip mini fixing for wing (2 pcs)
1 x 250 mm / 16 mm Airbrakes
1 x Ventral support for AX-18/AX-60
1 x "M" set
1 x Pilot JAN 1/4 Saiplanes
1 x Extension silicon 50 cm (Graupner)
1 x PPM Encoder Module
1 x Aluminun wheel collar 3 mm Ø (4 uds)
1 x Cable silicona macho batt. receptor 30 cm (Futaba)
1 x White smoke canister 140 g
1 x Extension silicon 30 cm male (Graupner)
1 x White smoke canister 100 g
1 x Cap closure 33/23.5mm (2 uds)
1 x Nylon hinge 15x0,3 (10 pcs)
1 x Gates hinge
1 x Cable set PREMIUM , fuselage/wing one4one
1 x Ferrita 17x10x6.5 mm
1 x 48 mm cylidric hinge Ø 2,5 mm (5 pcs)
1 x 140 mm rods set for direction control
1 x Mixers smoke bombs AX-60 (5 pcs)
1 x Cable servo PREMIUM MAXI 200m (blanco/rojo/azul) PVC
1 x Support pump Xicoy X45
1 x Piloto JET 1:3,5
1 x Black large kwik link (10 pcs)
1 x Support Flush MPX Conector (6 pcs)
1 x Cierre cabina aluminio Ø5, I=16 mm
1 x 1/6 Pilot "Tony"
1 x 1/4 Pilot "Heidi"
1 x Allen wheel collar M3x5
1 x Ferrita 27x14x7 mm
1 x PT 20x13 EL Propeller
1 x PT 22x10 EL Propeller
1 x PT 16x10 E Propeller
1 x PT 21x13 EL Propeller
1 x Xoar Electric Beechwood Prop 16x7
1 x Xoar Electric Beechwood Prop 12x6
1 x Xoar Electric Beechwood Prop 20x10
1 x Xoar Electric Beechwood Prop 21x10
1 x Xoar Electric Beechwood Prop 15x8
1 x Xoar Electric Beechwood Prop 24x8
1 x WingFix ULTRA Black Edition
1 x Z type of cable coupler Ø 1 (2 uds)
1 x FPV Station for SE TX-Tray V1
1 x POWERBOX Magic Jeti Switch
1 x Faucet FESTO
1 x Aluminun wheel collar 2.5 mm Ø (4 uds)
1 x Glider retract undercarriage 8-16 Kg 2.5-3.2(127 mm wheel)
1 x Transmitter Balancer HITEC Aurora 9, JR and Spectrum (blue)
1 x Landing gear axle Ø 4 mm (2 uds)
1 x PowerBox Competition
1 x 1/6 Pilot "Cindy"
1 x PowerBox DigiSwitch V2 MPX/JR
1 x Truck-trailer for gliders 720 x 239 mm
1 x Piloto Jet "Green" 1/6 Scale
1 x Neck strap Double V2
1 x Aluminun wheel collar 2 mm Ø (4 uds)
1 x Transmitter Balancer Futaba T-10CG
1 x Aluminun wheel collar 5 mm Ø (4 uds)
1 x Angle of incidence meter
1 x wire tensioner (black)
1 x Rubber bushing with bracket "A" type (2 pcs)
1 x Threaded coupler M2,5 Ø 3 mm (10 pcs)
1 x Threaded coupler M2 (10 uds)
1 x Turnbuckle M2x22/35 (2pcs)
1 x Threaded coupler ALU M2,5 Ø 4 (2 uds)
1 x VBar NEO VLink 6.x Express, neon-yellow
1 x Spinner NUT M4
1 x BlueCom™ Adapter (iOS)
1 x Three-function control switch by FUTABA
1 x 2 mm Prop Adapter M5
1 x Antenna Hole Cap V1 (Silver)
1 x Teacher-student connector T12FG/FX-30
1 x Landing gear axle Ø 5 mm (2 uds)
1 x Air pressure gauge
1 x PowerBox MagSensor black connector SRS/Champion
1 x Transmitter Balancer Futaba V
1 x Landing gear strap large (4 uds)
1 x 1/12 Pilot "Tom"
1 x PowerBox iGyro SRS
1 x Maleta transporte FUTABA 10PX
1 x Aluminun wheel collar 3.5 mm Ø (4 uds)
7,413.45EUR
Manufacturers
Manufacturer Info
Night Fly
Night Fly Homepage
Other products
Languages
Español English
Currencies