258.00EUR

DUPLEX 2.4EX Central Box 210
[JETCB210]


JETI Duplex 2.4EX Central Box 210
Product description and features
The Central Box 210 is the successor to the popular Central Box 200. Especially for the use of powerful and power-hungry servos, the Central Box 210 uses an aluminum housing and avoids the over current protection of the servo slots. The Central Box 210 offers true battery redundancy, DITEX servo telemetry, JETI EX telemetry and up to three receiver inputs (2x 2.4GHz and 1x 900MHz) for full power and RF signal redundancy.
Configuration via JETI Duplex DS/DC transmitters
With JETI Duplex DC/DS transmitters, the full potential of the Central Box 210 can be fully exploited. The device overview of the JETI Duplex DS/DC transmitter makes it easy to perform the entire configuration of the servo outputs, DITEX servo and JETI EX telemetry, function assignment, and more.
Compatibility with Futaba
The Central Box 210 can also be used with two S.Bus receivers (e .g Futaba R7003SB). Setting up and reading out the telemetry values must, however, be realized with a separatly available JETIBOX.
Switching on and off The switching on and off process of the Central Box 210 is done with the supplied magnetic switch.
Recommended receivers
As receiver e. g. 2 RSat2 or REX3 receivers can be used. Optionally, the use of a REX Assist receiver in combination with a RSat2 receiver is possible, so you get a Central Box with gyro stabilization.
Features
Configurable servo outputs
Battery connections 2x MPX connector system
Robust aluminum housing for extra cooling and protection
Firmware upgradeable via JETI USB adapter and JETI Studio
Wireless programming via the device overview of the DC/DS transmitters
Up to 3 independent receiver inputs (R1, R2, E1/R3)
Up to 15 servo slots (suitable for DITEX servo telemetry)
Up to 3 telemetry sensor inputs (E1/R3, E2/15, E3/14)
Input for supplied magnetic switch or optional RC switch
Optional over current protection
The Central Box 210 is not equipped with the built-in overload protection of the servo slots. To protect critical servos such tow coupling servos, retractable landing gears or spoiler servos, the optional overload protection DPSI OCP (Accessories tab) can be used.
Feature
Servo outputs 15
Protected servo outputs (for servos with up to 30kg/cm)
Protected servo outputs (for servos with up to 30kg/cm)
Receiver inputs up to 3
Satellite receiver support Yes
Telemetry Yes
DITEX servo telemetry Yes
Battery inputs 2
Supply voltage [V] 4 up to 8.4
Voltage regulator No
Permanent current [A] 20
Peak current (approx. 2 seconds) [A] 90
Idle current [µA] 180
Operating temperature [°C] ([°F]) -20 to 75 (-4 to 167)
Dimensions [mm] ([in]) 66 x 42 x 18 (2.6 x 1.65 x 0.71)
Weight [g] ([oz]) 59 (2.08)


Reviews
We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x PPM Encoder Module
1 x Conector AS150 7mm antichispazo (Set: 2 pares)
1 x Threaded coupler ALU Left M2,5 Ø 3 (2 uds)
1 x Red smoke canister 100 g
1 x Cierre cabina aluminio Ø5, I=16 mm
1 x Initior Transmitter FTX2 Wireless
1 x White smoke canister 100 g
1 x Aluminum Bayonet / strongal D12 mm / 0.5 m
1 x Support Flush MPX Conector (6 pcs)
2 x Decorative caps, multicoloured
2 x Futaba S-Bus Rx/Gyro Link Lead
1 x Support pumb/filter Xicoy X45
1 x MULTIPLEX ALUMINUM CASE "M-LINK"
2 x Transmitter Balancer Futaba FF9-DX7-JR-Hitec
1 x Aro pasacable Ø20 mm (4 pcs)
1 x TX-Tray V1 (L) (Red)
2 x Switch Cap L (Blue)
1 x Receiver bed (Blue)
2 x Switch Cap L (Red)
2 x Futaba Neckstrap
1 x Support Filtro FESTO
2 x Frontal Adapter for AXI53xx
1 x Tube Pitot to PIXHAWK
1 x MR30 connector male
2 x Conector XT-30 (macho)
1 x Connector CAN 15
2 x XH female balance (7S) connector (2 pcs)
1 x 2 mm male connector (2 pcs) with safety connector
1 x XH male balance (4S) connector (2 pcs)
1 x XH female balance (5S) connector (2 pcs)
1 x Connectors MPX black male
1 x XH male balance (2S) connector (2 pcs)
1 x Fiberglass heat shield Ø 8 mm 1000 mm
1 x Protective Cover for wires Ø 6 mm 1000 mm
1 x Connectors DEANS (T) micro
1 x Militarian pilot "Kamikaze" size 9cm (Slimline)
1 x Pilot "Goose" (Slimline)
1 x 1/6 Pilot "Buddy"
1 x Pilot WWII US Navy Pacific 12" Scale 1/6-1/5
1 x Carbon tube (L 1000 mm, Ø1.5 mm, Ø0.7 mm)
1 x 20 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
2 x 26 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x Tape GFK 50 mm
2 x SE Ring 360 mm (2 pcs)
1 x Cable servo PREMIUM 1 m (blanco/rojo/negro) AWG21 + AWG26 TPE
1 x Protective Cover for wires Ø 10 mm 1000 mm
1 x Transmitter Balancer SPK DX-8
1 x Transmitter Stick Ends V5 Red - M4 JR/DX7
1 x 50m servo "Premium" wire (white/red/blue)
1 x Transmitter Balancer Futaba T-10CG
1 x Receiver GRAUPNER GR-12 HoTT
1 x VARIO module Hott
1 x POWER PEAK D7 EQ-BID 12V/230V-Duo Charger
1 x Futaba S-Bus Rx/Gyro Link Lead
1 x Adap/Exten for Futaba 12-14C
1 x Switch Cap L (silver)
1 x SWTU2 switch
1 x Transmitter Balancer HITEC Aurora 9, JR and Spectrum (blue)
1 x Transmitter Stick Ends V5 Rojo - M3 Futaba/Hitec/Spektrum DX8 (2
1 x Transmitter Stick Ends V5 Blue - M3 Futaba/Hitec/Spektrum DX8 (2
1 x Transmitter Stick Ends V4 Blue/Silver - M3 (2 pcs)
1 x Switch Cap M (blue)
1 x Transmitter Stick Ends V1 Red - M3 (2 pcs)
1 x Transmitter Stick Ends V1 Silver - M3 (2 pcs)
1 x Futaba Aero Large Case - Internal Foam
1 x 1/12 Pilot "Tom"
1 x Transmitter Stick Ends V3 Red - M3 (2 pcs)
1 x Switch Cap L (black)
1 x Switch Cap M (black)
1 x Antenna Hole Cap V1 (Silver)
1 x Switch Cap M (silver)
1 x Switch Cap M (red)
1 x Antenna FUTABA 2.4GHz 3PM/8FG/14SG/18SZ/18M
1 x Charger HITEC CG-42 TX 7.2v/ RX 4.8v (80 mA)
1 x Antenna holder bracket double
1 x Transmitter Stick Ends V5 Blue - M4 JR/DX7
1 x Receptor GRAUPNER GR-24 HoTT
1 x Receiver GRAUPNER GR-16 HoTT
1 x TX Tray V1 Hand Rests only
1 x BLUE Colored Liquid smoke for turbine 0.75 l
1 x Turbina X45 H "Light Version"
1 x Turbina XICOY X95 compact
1 x Telemetria XYCOY adapter
1 x Turbina X132 H "Compact Version"
1 x Motor Mega AC 16/07/08
1 x Motor Mega AC 16/07/12
2 x 
1 x Conector JR/Uni Servo male BLUE silicon (10 pcs)
1 x SE Ring 330 mm (4 pcs)
2 x SE Ring 200 mm (2 pcs)
1 x Quick hose connector 4-4 mm
1 x FESTO connector M5 Quick 4 mm
1 x T-Hose connector 4-4-4mm
1 x FESTO connector M7 barb fitting 4mm
1 x 14x60 mm Mini rings Tie Wraps (4 pcs)
1 x 13 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x Cable-Tie 1.66x71mm / 0.07x2.8″ (20 pcs)
1 x A50 Backmountset complete V3/V4
1 x Motor A60-7XS V4 28-pole kv330
1 x Motor A30-14 M V2 6 Poles
1 x Motor Mega AC 16/35/01
1 x Motor Mega AC 22/45/02 E
1 x Motor Mega AC 16/30/01
1 x Motor A20-20 L EVO
1 x Motor A40-10 L V2 14-Pole Glider
1 x 50N turbine start protection tube
1 x Motor Mega AC 16/25/04 COMBAT
1 x Motor A20-20 L EVO
1 x PH6 adapter for 6mm M10 AXI for AXI41xx
1 x Motor Mega AC 16/25/01E 3.17mm
1 x IKARUS plane
1 x PC-21 2.880 mm (w/o oracover)
1 x FELIX JR Red/Yellow 1750 mm
1 x MB339 Freece PNP 1790 mm
1 x Conector MR-60 (pareja)
1 x Conector JR Servo male (10 pcs)
1 x Connectors banna oro 4 mm (M/F) (ultralight)
1 x XPower XC4226/12 LS
1 x Conector JR Servo female (50 pcs)
1 x Connectors DEANS (T)
1 x Red 4 mm connector holder
1 x Soporte carbono MR30 (2 pcs)
1 x Festo Adaptor Tygon Large/4mm
1 x Quick hose connector 4-3 mm
1 x Y-Hose connector 4-4-4mm
1 x Quick hose connector 3-3 mm
1 x Racor 4/3 mm
1 x Quick hose connector 3-3 mm
1 x Racor 2/3 mm
1 x Racor 3/3 mm
1 x FESTO Filter 6 mm
1 x Y-Hose connector 4mm
1 x T-Hose connector 2-2-2 mm
1 x FESTO Filter 4 mm
1 x Y-Hose connector 6-6-6 mm
1 x FESTO connector M7 barb fitting XL Tygon
1 x Conector FESTO M3 Quick 3mm 90º
1 x Motor Mega AC 22/30/03
1 x 20x1000 mm Ring Strap Back To Back
1 x 13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x SE Ring 400 mm (2 pcs)
1 x 5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x SE Ring HACKER 300 mm (2 pcs)
1 x 10 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x RUDDOG Protection and Heat Shield Tape (2mx50mm)
1 x Marker ties (20 pcs)
1 x Ring 320 mm length (5 pcs)
1 x Foil for sticking flaps and ailerons
1 x Waterproof adhesive tape, width 19mm, length 25m
1 x Spikes Band (5 m)
1 x Cinta Goldfix 1m
1 x Tape GFK 38 mm
1 x SE Ring 250 mm (2 pcs)
1 x GPS, Vario and altitude Sensor SBS-01G
15,850.62EUR
Manufacturers
Manufacturer Info
Jeti
Jeti Homepage
Other products
Languages
Español English
Currencies