16.00EUR

Opto Gas Engine Kill Switch
[SETOKW]

This kill switch is double Optically Coupled to isolate your ignition system from your radio system (No Interference!!). It also consist an additional safety functions.

Device features
• Includes a remote mountable ultra bright LED to indicate when the ignition is armed or not, or if the safety sequence protection is active.
• The LED diode informs also if Fail-Safe occured during flight (even after landing).
• Safety sequence protection for engine ignition powering up after model preparation.
• Double optically Coupled input/output is Isolated.
• Turning engine ignition ON or OFF directly from RC Transmitter
• No need to use additional mechanical switch for disconnecting ignition battery.
• 8 Bit microcontroller powered directly from RC receiver.
• 3,0 - 24,0 Volt Li-Po/Li-Ion/A123/Ni-Mh/NiCad Input (receiver side).
• 3,0 - 20,0 Volt Li-Po/Li-Ion/A123/Ni-Mh/NiCad MOSFET Output (ignition side).
• Possible to use one battery setup (independent two batteries setup by default).
• Max. current output: 5 Amp continous, 16 Amp peak
• Fail-Safe engine kill when interference or signal lose is longer then 1 second. (this function can be turned OFF).
• PPM-PCM 2048 – 1024 & 2.4Ghz Interface Support.
• Low Voltage Drop – Less than 150mv.
• 100% Surface Mount Technology.
• Heavy Gauge Wires 22AWG, universal connectors Futaba/JR.
• Small and light weight – only 15 Grams!

This device plugs into a spare receiver channel.

This is a must have safety device for any gas powered plane! This device allows you to safely kill your engine at anytime (on the ground, or inthe air!)

temporarily out of stock

Reviews

Customers who bought this product also purchased

Spark motor OS nº 3

temporarily out of stock

Quick Find

Shopping Cart

1 x	Blade Holder Full (3 blades)
1 x	4 blades set
1 x	LA500 rotor head core
1 x	4 mm M3 red control terminal (4 pcs)
1 x	Circlik for shaft 1.9 mm (10 pcs)
1 x	EC5-Set male, simple quality, 2 x female pin, 1 x blue housing
1 x	33 x 8 mm cylidric hinge Ø 2,5 mm (10 pcs)
1 x	Gold antispark 5,5 mm plug
1 x	Circlik for shaft 2.3 mm (10 pcs)
1 x	M3-M4 rubber washer (8 pcs)
1 x	25 mm reinforced hinge
1 x	SIMtransmitter 6 Mode 2
1 x	Breatex™ Non-woven absorber 300 g/m² Roll 41 m
1 x	Carbon fabric 200 g/m² (Aero, plain weave) 100 cm x 5m
1 x	AIREX® Sheets C 70.55 (YELLOW) 1200x550x1.2 mm (5 pcs)
1 x	Smoke set "Glider"
1 x	ABS 500 x 400 x 2,0 mm (white)
1 x	Socket head long ball link M3 (2 uds)
1 x	AIREX® Sheets C 70.55 (YELLOW) 1200x550x4.0 mm (5 pcs)
1 x	Pad self adhesive, up to 3mm / 0.12″, (10 pcs)
1 x	M2,5 / 5Diam metal short ball link V3 (2 pcs)
1 x
1 x	Tape GFK 38 mm
1 x	Ball link M3 (10 pcs)
1 x	Initior Transmitter FTX2 Wireless
1 x	Long ball link M3 (6 uds)
1 x	6 mm hexagonal ball link M3 (10 pcs)
1 x	Initior Receiver FRX2 Wireless
1 x	SE Ring 330 mm (4 pcs)
1 x	AX-60 starters (5 pcs)
1 x	Red smoke bombs AX-60 (5 pcs)
1 x	ABS 500 x 400 x 1,5 mm (white)
1 x	Tape GFK 50 mm
1 x	Tape GFK 25 mm
1 x	Carbon fabric 68 g/m² (style 493 aero, plain weave) 100 cm
1 x	Green smoke canister 140 g
1 x	Sun Cover PC 21 XXL (JMB Jets)
1 x	37 mm PVC transparent battery termo-retract (1 m)
1 x	APM2.6 Power module with 5.3V DC BEC
1 x	3 copper lacquer wire Ø0,2 mm (1 m)
1 x	12,7x1000 mm 2:1 green termoretract tube
1 x	Connector Sub-D 2+5 Male
1 x	U Profile ABS 2,0x4,0x1000 mm
1 x	Oracover Black 10 m
1 x	Carbon fiber rod 16 mm x 1000 mm
1 x	Support Flush MPX Conector (6 pcs)
1 x	Glases Innovation Plus
1 x	Extension 100 cm (Futaba)
1 x	"Y" charging 4mm wire (2 IN-1 OUT).
1 x	165 mm PVC transparent battery termo-retract 165 mm (1 m)
1 x	ABS "T" angle 10.0x10.0x1000 mm
1 x	Futaba Female 40 cm extension
1 x	Cabling for Fox MDM1 wings
2 x	Servo Controller Fibra optica
1 x	Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm)
1 x	Carbon fiber rod 1.5 mm x 1000 mm
1 x	Aluminum Bayonet / strongal D12 mm / 0.5 m
1 x	Hard aluminium thin-walled tube with fibreglass case ø30x1mm, 1m
1 x	Wing-connector: Glass / Carbon tube (13.7/12.5) x 1000 mm
1 x	Propeller diller for DLE111 and DA85-150
1 x	DLA 116 crankshaft
1 x	GLOW 2C + accesories
1 x	GLOW 5C + accesories
1 x	Opto Gas Engine Kill Switch
1 x	Quick hose connector 6-4 mm
1 x	T-Hose connector 3-3-3 mm
1 x	Gasket electric Fuel Pump
1 x	Electric Fuel Pump 12V
1 x	Y-Hose connector 4-4-4mm
1 x	T- Fittings blue color (2pcs)
1 x	1000 ccm complete gasoline fuel tank
1 x	FESTO connector M7 Quick 4 mm
1 x	Conector FESTO M3 Quick 3mm 90º
1 x	Electric Fuel pump
1 x	Fuel tank 1500ml (50oz)
1 x	Conector FESTO G1/8 Quick 4mm 90º
2 x	Fuselage Autogyro RAINBOW
1 x	Hexagonal Nut M4 (10 pcs)
2 x	3 blades set
1 x	Carbon fiber flat 1000x3.0x1.0 mm
1 x	Carbon fiber flat 1000x3.0x1.0 mm
1 x	Extension silicon 30 cm female (Futaba)
1 x	Cable silicona macho batt. receptor 30 cm (Graupner)
1 x	Adaptador USB - YGE
1 x	Cabel "Y" 15 cm
1 x	servo adapter lead, JST-SH socket - JR male Pin, for GR-12SH+HoT
1 x	Futaba Female 40 cm extension
1 x	Interface Realflight Simulator
1 x	Tube Pitot to PIXHAWK
1 x	PIX Hawk with accesories
1 x	Digital Air Speed Sensor And Pitot Tube Set
1 x	Motor Scorpion HKIII 4035-560 Kv
1 x	Jeti Black cap
1 x	800TVL CMOS camera for FPV
1 x	Camera Sony 4140+673 CCD with Built-in 200mw TX + antenna
1 x	PPM Encoder Module
1 x	Servo NARO Max Std
1 x	MPX PCB "Gender-Changer (5 pcs)
1 x	Sun Cover BULL Mo1 2.6 (Hispano Aviacion)
1 x	Power supply NT 40 Amp.

4,279.11EUR