16.00EUR

Opto Gas Engine Kill Switch
[SETOKW]

This kill switch is double Optically Coupled to isolate your ignition system from your radio system (No Interference!!). It also consist an additional safety functions.

Device features
• Includes a remote mountable ultra bright LED to indicate when the ignition is armed or not, or if the safety sequence protection is active.
• The LED diode informs also if Fail-Safe occured during flight (even after landing).
• Safety sequence protection for engine ignition powering up after model preparation.
• Double optically Coupled input/output is Isolated.
• Turning engine ignition ON or OFF directly from RC Transmitter
• No need to use additional mechanical switch for disconnecting ignition battery.
• 8 Bit microcontroller powered directly from RC receiver.
• 3,0 - 24,0 Volt Li-Po/Li-Ion/A123/Ni-Mh/NiCad Input (receiver side).
• 3,0 - 20,0 Volt Li-Po/Li-Ion/A123/Ni-Mh/NiCad MOSFET Output (ignition side).
• Possible to use one battery setup (independent two batteries setup by default).
• Max. current output: 5 Amp continous, 16 Amp peak
• Fail-Safe engine kill when interference or signal lose is longer then 1 second. (this function can be turned OFF).
• PPM-PCM 2048 – 1024 & 2.4Ghz Interface Support.
• Low Voltage Drop – Less than 150mv.
• 100% Surface Mount Technology.
• Heavy Gauge Wires 22AWG, universal connectors Futaba/JR.
• Small and light weight – only 15 Grams!

This device plugs into a spare receiver channel.

This is a must have safety device for any gas powered plane! This device allows you to safely kill your engine at anytime (on the ground, or inthe air!)

temporarily out of stock

Reviews

Customers who bought this product also purchased

Spark motor OS nº 3

temporarily out of stock

Quick Find

Shopping Cart

4 x	Glases Nimbus "Black"
2 x	Glases Ace
2 x	Glases Flitemaster
1 x	Glases Moritz
2 x	Zurich Sport Sunglasse Dark Sensity BROWN Glasses
2 x	Glases Nimbus
1 x	Glases Stratus
1 x	Glases Innovation Plus
1 x	Silicone 0,25 qmm servos wire Graupner (5 m)
1 x	Silicone 0,35 qmm servos wire Graupner(100 m)
2 x	PVC 0,08 qmm Graupner servos wire (5 m)
1 x	White silicone 0,25 mm² wire (25 m)
2 x	PVC 0,08 qmm Futaba servos wire (5 m)
1 x	PVC 0,35 qmm servos wire Graupner (100 m)
1 x	PVC 0,25 qmm servos wire Graupner (5 m)
1 x	RF9 Flight Simulator with Spektrum Controller
1 x	Cable servo PREMIUM MAXI 200m (blanco/rojo/azul) PVC
1 x	Cable servo PREMIUM MAXI 1 m (blanco/rojo/azul) PVC
1 x	Silicone red 0,25 mm² wire (25 m)
1 x	Black silicone 0,25 mm² wire (25 m)
1 x	Silicone 0,50 qmm servos wire Futaba (100 m)
2 x	100m servo "Premium" wire (white/red/blue)
1 x	10m servo "Premium" wire (white/red/blue)
2 x	Silicone 0,14 qmm servos wire Graupner (5 m)
1 x	PVC 0,14 qmm servo wire Futaba (5 m)
1 x	Cable Cargador FUTABA
1 x	PVC 0,14 qmm servos wire Graupner (100 m)
1 x	Silicone 0,35 qmm servos wire Futaba (100 m)
1 x	Silicone 0,50 qmm servos wire Graupner(100 m)
1 x	White silicone 0,25 qmm wire (150 m)
1 x	200m servo "Premium" wire (white/red/blue)
1 x	Cable servo PREMIUM MAXI 50m (blanco/rojo/azul) PVC
1 x	Cable servo PREMIUM MAXI 10m (blanco/rojo/azul) PVC
1 x	Slave-cable USB Easy Sim
1 x	Silicone 0,50 qmm servos wire Graupner(5 m)
1 x	Interface Jack Adapter IKARUS
1 x	Softshell Hispano Aviación
2 x	Vest clothes Hispano Aviación
1 x	Straightened rod Ø 14.0 mm x 1000 mm
1 x	Propeller POWER-PROP 14x9 Izda
1 x	Sandwich carbon + poplar 3mm + carbon 480x290 mm
1 x	FALCON 20X9 CARBON PROPELLER (GAS)
1 x	Sandwich carbon + poplar 4mm + carbon 480x290 mm
1 x	Propeller POWER-PROP 14x9
1 x	Steering arm 12 mm Ø 4 mm
2 x	Canopy Lock V1 M3 Blue (2 pcs)
1 x	Stainless steel cable Ø 0.52 mm - 15 kp (10 m)
1 x	Cierre cabina aluminio Ø5, I=16 mm
1 x	Stainless steel cable Ø 1.3 mm (10 m)
1 x	One touch canopy lock
2 x	Cabin latch Fox MDM1 4m (pair)
1 x	SUS wire 3m (nylon coated)
2 x	Electric spoiler 250 mm (2 pcs)
1 x	Screw-lock connector Ø 2 mm (2 uds)
1 x	Steering arm 16 mm Ø 3 mm (2 uds)
1 x	Vertical cockpit anchor "tipe F3A" (2 pcs)
1 x	Stainless steel cable Ø 0.62 mm (10 m)
2 x	Micro screw-lock pushrod conn snap Ø 1 mm (2 uds)
1 x	Cap closure 33/23.5mm (2 uds)
1 x	Steering arm 16 mm Ø 4 mm (2 uds)
2 x	Stainless steel cable Ø 0.5 mm (2 m)
1 x	Locking cable tie 2.5x100 (uds)
2 x	Screw-lock connector M2 (2 uds)
1 x	Crimping sleeves for cable 0.70 mm (10 pcs)
1 x	PIX Hawk with accesories
1 x	Digital Air Speed Sensor And Pitot Tube Set
1 x	PPM Encoder Module
1 x	Tube Pitot to PIXHAWK
1 x	Glases Aspen
2 x	Zurich Sport Sunglasse Dark Sensity MAGENTA Glasses
1 x	1,2x1000 mm 2:1 red termoretract tube
1 x	Straightened rod Ø 4.0 mm x 1000 mm
1 x	Protective Cover for wires Ø 6 mm 1000 mm
1 x	Silicone red 0,5 qmm wire ( 1 m)
1 x	Silicone black 4,0 qmm wire ( 1 m)
1 x	SIMtransmitter 6 Mode 2
1 x	Protective Cover for wires Ø 20 mm 1000 mm
1 x	Protective Cover for wires Ø 6 mm 1000 mm
1 x	10 mm Quick clamp_L (6 pcs)
1 x	Fiberglass heat shield Ø 8 mm 1000 mm
1 x	Fiberglass heat shield Ø 4 mm 1000 mm
1 x	Transmitter Crystal 35 Mc/s Ch 77
2 x	Transmitter Crystal 35 Mc/s Ch 62
1 x	CellPRO 4S Adaptader (GP/KO up to 4S)
1 x	Crystal Universal RX 35.040 Ch 64
1 x	Green silicone 0,25 qmm wire (50 m)
1 x	Crystal Universal RX 35.140 Ch 74
1 x	Cap Hispano Aviación
1 x	Shirt Hispano Aviación
1 x	Thixotropic agent tin/ 15 g (approx. 350ml)
1 x	GlassBubbles 2.5 g/cm³ Panda, tin (approx. 1 l)
1 x	2,3 mm Prop Drive Günther M4
1 x	PH6 adapter for 6mm M10 AXI for AXI41xx
2 x	JR silicone servo wire 0,35 qmm / 5m
1 x	5 mm Prop Adapter M8
1 x	Silicone 0,25 qmm servos wire Graupner (100 m)
1 x	Glass Bubbles 0.20 g/cm³ Panda, tin/ 100 g (approx. 1 l)
1 x	5 line servos wire black (1 m)
1 x	Split M1,2x10 (10 pcs)
1 x	Pushrod octagone 4/3
1 x	Locking cable tie 3.2x142 (uds)
1 x	L cockpit anchor "tipe F3A" (2 pcs)
1 x	Fully Threaded Steel Rod SUS303 70mm M3 (2 pcs)
1 x	11 mm Rubber pads (14 pcs)
1 x	38x4,5 mm wires output (2 pcs)
1 x	Clip mini fixing for wing (2 pcs)
1 x	Aluminun wheel collar 2.5 mm Ø (4 uds)
1 x	Pushrod greyline 3/2 with coupler M2 L: 1000 mm
1 x	Allen wheel collar M3x3
1 x	Mobile Terminal
1 x	SINGLE FUELING VALVE GASOLINE MK2 SMALL
1 x	Screw-lock pushrod conn snap Ø 1.5 mm (2 uds)
1 x	Fully Threaded Steel Rod alumin 80 mm M3 (2 pcs)
1 x	Snap long M2 (10 uds)
1 x	Pushrod octagone 3/2
1 x	HOPPER tank Digitech 250 ml (Festo nipples 6 mm)
1 x	Aluminun wheel collar 2 mm Ø (4 uds)
1 x	Aluminun wheel collar 5 mm Ø (4 uds)
1 x	Blind nut M4 (10 pcs)
1 x	OS 40-FG 4T Motor
1 x	Steering arm 12 mm Ø 3 mm (2 uds)
1 x	TMM 1210-3S heli
1 x	SKY RC Temperature Sensor
1 x	ESC RAY G2 R-20B BEC

6,185.54EUR