184.00EUR

VAGABOND 1500 mm ARF V2 (Red)
[HC1220R]

Description:
Great wings across the wingspan and floating elevator allow unlimited flying maneuvers model. The increased surface of the fuselage gives the Vagabond ability to fly at sufficient speed even knife flight. For even more aerobatic performance wings and tail surfaces are coated with smooth foil. All this together makes Vagabond extremely powerful aerobatic slope glider with which you can fly on otherwise inaccessible hard slopes.

Vagabond extremely powerful aerobatic slope glider with whih you can fly on otherwise inaccessible hard slopes.

Needed To Complete:
4 channel RC kit, 4 Micro Servos 9g D-90, HS-55, Accu Pack 5cells NiMh or Li-Pol 800-1300mAh 2S.
CA glue and activator spray.

temporarily out of stock

Reviews

Quick Find

Shopping Cart

1 x	13 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x	10 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
2 x	Tape GFK 38 mm
2 x	RUDDOG Protection and Heat Shield Tape (2mx50mm)
1 x
1 x	SE Ring 350 mm (2 pcs)
1 x	5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x	13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
2 x	Tape GFK 50 mm
1 x	Field folding model stand
3 x	Pad self adhesive, up to 3mm / 0.12″, (10 pcs)
1 x	20 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x	Cinta Goldfix 1m
1 x	Angle measurer
1 x	Medidor ángulos y/o incidencias
2 x	Spikes Band (5 m)
1 x	Field folding model stand SebArt
1 x	Truck-trailer for gliders 720 x 239 mm
1 x	Angle of incidence meter
1 x	20x200 mm battery rings
1 x	Covered closure or fairings
1 x	Stainless steel cable Ø 0.88 mm - 60 kp (10 m)
2 x	Hard aluminium thin-walled tube with fibreglass case ø30x1mm, 1m
2 x	Wing-connector: Glass / Carbon tube (13.7/12.5) x 1000 mm
1 x	Steering arm 16 mm Ø 3 mm (2 uds)
1 x	Locking cable tie 4.6x203 (uds)
1 x	Crimping sleeves for cable 0.85 mm (10 pcs)
2 x	67 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs)
1 x	Nylon hinge 20x20x0,3 (10 pcs)
1 x	48 x 10 mm cylidric hinge Ø 3,0 mm (10 pcs)
2 x	Large flex hinge (12 uds)
2 x	Small pinned hinge (12 uds)
2 x	Nylon hinge 20x15x0,3 (10 pcs)
1 x	Gates hinge aluminium (1 pcs)
1 x	Unmounted aluminium pin 6x98 mm (2 pcs)
1 x	Pin type hinge Al 3,0x50 mm (2 pcs)
1 x	Long pinned hinge (6 uds)
2 x	Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs)
2 x	Gates hinge 30x16 mm (2 pcs)
2 x	Nylon hinge for flaps 33x9 (2 pcs)
1 x	Gates hinge black 30x16 mm (2 pcs)
1 x	33 x 8 mm cylidric hinge Ø 2,5 mm (10 pcs)
1 x	Long pinned hinge (12 uds)
1 x	Aluminium cap bolt washer M3 black (8 pcs)
1 x	Spring lock washer 4.1 mm (20 pcs)
1 x	Circlik for shaft 1.2 mm (10 pcs)
1 x	L-Connector 4.0 mm x 1000 mm
1 x	Civilian pilot "Gramps" size 9cm (Slimline)
1 x	Bidule 55 V3 2460 mm
1 x	Extension silicon 100 cm (Futaba)
1 x	Horn 5/15 with M2 Bearing
1 x	A50 Motor Mount Alu complete set
1 x	Battery LiPo GENS 5500 mAh 2S 7.6V 120C (Gens Ace Hard Case)
1 x	Battery LiPo GENS 5000 mAh 6S 22.2V 60C (Gens Ace)
1 x	Battery LiPo GENS 2200 mAh 4S 14.8v 25C (Gens Ace)
1 x	Battery LiPo GENS 450 mAh 3S 11.1V 25C (Gens Ace)
1 x	Battery LiPo GENS 3300 mAh 3S 11.1v 25C (Gens Ace)
1 x	Battery RX JETI LiIon RB 2600 7.2v
2 x	SE Ring HACKER 300 mm (2 pcs)
1 x	SE Ring 480 mm (2 pcs)
1 x	Tape GFK 25 mm
2 x	Pin type hinge Al 4,5x70 mm to wire (2 pcs)
1 x	Pin type hinge Al 6x98 mm (2 pcs)
1 x	Micro flex hinge (12 uds)
1 x	Wing-connector: Glass / Carbon tube (26.5/25 x 25/23) x 1000 mm
1 x	Wing bolts M3 Steel screw blue (2 pcs)
1 x	Press fitting for 0,5 diam. steel cable (10 pcs)
1 x	Cable grommet Ø 6.4 mm (4 uds)
1 x	WingFix ULTRA Black Edition
1 x	Ring 320 mm length (5 pcs)
1 x	Snap for floding prop for 2 mm axi
1 x	80 mm rods set for direction control
1 x	Cockpit latch closing I=10 mm
1 x	45 mm rods + T patellas set for direction control
1 x	Wing bolts M6 Steel screw Red (2 pcs)
1 x	Clip fixing for wing (2 pcs)
1 x	Aluminum Bayonet / strongal D35 mm / 1 m
1 x	Split pin 1.6x16 mm (10 uds)
1 x	SE Ring 250 mm (2 pcs)
1 x	SE Ring 360 mm (2 pcs)
1 x	Pin type hinge Al 4,5x70 mm demount (2 pcs)
1 x	Propeller balancer
1 x	Landing gear frontal support 25x32x16
1 x	67 mm cylidric hinge Ø 4,5 mm (5 pcs)
1 x	Steering arm 12 mm Ø 4 mm (2 uds)
1 x	Allen wheel collar M4x6
1 x	Lead with adhesive (2 pcs)
1 x	15 mm reinforced hinge
1 x	Allen wheel collar M3x3
1 x	Nylon hinge for flaps/gates 27x10,5 (2 pcs)
1 x	76 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs)
1 x	Steering arm 16 mm Ø 4 mm
1 x	Civilian pilot "Curt" size 9cm (Slimline)
1 x	Pilot "Goose" (Slimline)
1 x	Pilot "Duke" Legends Series (Slimline)
1 x	Civilian pilot "Joe" size 9cm (Slimline)
1 x	1/12 Pilot "Cougar"
1 x	Militarian pilot "Fly Boy" size 9cm (Slimline)
1 x	Pilot WWII US Navy Pacific 12" Scale 1/6-1/5
1 x	Pilot "Adolf" Legends Series (Slimline)
1 x	LiPo Storage Box Type "BIG"
1 x	Battery bed V2_S (black)
1 x	Flap hinge (6 pcs)
1 x	Cockpit plastic closing
1 x	1/12 Pilot "Tom"
1 x	Snap pin for micro clevis (10 uds)
1 x	Piloto Jet "Green" 1/6 Scale
1 x	Gates hinge
1 x	Pin type hinge Al 3,0x50 mm demount (2 pcs)
1 x	67 mm cylidric hinge Ø 5 mm (4 pcs)
1 x	Canopy Latch
1 x	25 mm reinforced hinge
1 x	18 mm reinforced hinge
1 x	Fast'n EZ-CA-Hinge (12 uds)
1 x	Boomerang SPRINT V2 Red/White/Blue
1 x	TURBINATOR 2 RED/WHITE 1778 mm Combo
1 x	Aluminium Hub for folding Props 35 mm M8 Shaft 6 mm
1 x	Cable servo PREMIUM 1 m (blanco/rojo/negro) AWG21 + AWG26 TPE
1 x	Xoar Electric Beechwood Prop 21x10

6,372.75EUR