4.50EUR

CA Glue fast 20g
[R1501032]

Superglue (fast) is a normal type Cyanoacrylate adhesive with fast setting, high flow abilit, and good penetration characteristics.

It has been specially formulated to achieve the strongest possible bond between well-mated, non-porous surfaces, such as rubber, metals, plastics, glass, etc.

Single-component
Transparent
Very low viscosity, high setting speed
Bonds obtain hand strength after 2-15 seconds
Special bottle*
*A metal needle is fitted in the lid, which is pressed into the opening of the bottle's dosing attachment when it is screwed on. This reliably prevents leakage, drying out and sticking of the opening. The dosing attachment allows a fine dosing of the adhesive.

Physical properties
Liquid state
Base Ethyl Cyanoacrylat
Colour clear
Specific Gravity (at 20 °C) 1.053~1.060
Refraction Index (n 20 D) 1.439
Flash Point (°C) >80 °C
Boiling Point (°C) 65/6mm Hg
Viscosity (cP) 3-5
Cured state
Colour clear
Specific Gravity (at 20 °C) 1.1~1.3
Processing temperature -55 - 80 °C
Refraction Index (n 20 D) 1.49
Dielectric Constant (bei 10 MHz) 3.5
Dielectric Loss (bei 10 MHz) 0.067
Soluble in Acetone, Dimethyl formamide,Nitromethame and Dimethyl sulfoxide.
Bond strength (Tensile shear strength, cured for 24 hours at 20-25 °C)
kg/cm²
Rigid PVC to rigid PVC 40-60
ABS to ABS 50-70
Polycarbonate to polycarbonate 80-120
Polystyrene to polystyrene 30-45
Natural rubber to natural rubber 5-9
Steel to steel 190-210
Stainless steel to stainless steel 200-220
Aluminum to aluminum 160-180
Copper to copper 150-170
Steel to rigid PVC 50-60
Stainless steel to neoprene 5-10
SBR to SBR 5-10
Cure speed
Seconds
ABS to ABS 4-5
Wood to wood 50-60
ABS to stainless steel 5-10
NBR to stainless steel 3-5
NBR to NBR 3-5
Stainless steel to stainless steel 3-5
ABS to NBR 3-5
Wood to ABS 5-10
Storage and shelf life:
Our superglue can be stored in a cool and dark place for about 1 year (for example in the refrigerator at + 5 °C).
At room temperature about 6 months. At temperatures above 20 °C the shelf life is further reduced (e. g. in the summer months)

temporarily out of stock

Reviews

Customers who bought this product also purchased

Sparkplug NGK CM6 temporarily out of stock	TYGON tubo 1 m Diam. 3.4 x 2.0 mm temporarily out of stock	Tygon tube 6.35 - 3.18 mm 1m temporarily out of stock
Propeller MENZ-S 23x8 temporarily out of stock	XT-60 connector (female) temporarily out of stock	XT-60 connector (male) temporarily out of stock

Quick Find

Shopping Cart

1 x	Nylon hinge 15x0,3 (10 pcs)
1 x	Fast'n EZ-CA-Hinge, lite (12 uds)
1 x	67 mm cylidric hinge Ø 5 mm (4 pcs)
1 x	33 x 8 mm cylidric hinge Ø 2,5 mm (10 pcs)
1 x	25 mm reinforced hinge
1 x	Pin type hinge Al 3,0x50 mm (2 pcs)
1 x	15 mm reinforced hinge
1 x	Nylon hinge 20x15x0,3 (10 pcs)
1 x	Pin type hinge Al 4,5x70 mm (2 pcs)
1 x	Cylidric hinge 33 mm Ø 2 mm (5 pcs)
1 x	Fast'n EZ-CA-Hinge (12 uds)
1 x	Long pinned hinge (12 uds)
1 x	Long pinned hinge (6 uds)
1 x	Gates hinge aluminium (1 pcs)
2 x	Cylidric hinge 43 mm Ø 2,5 mm (5 pcs)
1 x	Gates hinge
1 x	18 mm reinforced hinge
1 x	Small pinned hinge (12 uds)
1 x	Miniature brass strap hinge, 1 m
1 x	67 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs)
1 x	Threaded coupler ALU M2 Ø 3 (2 uds)
1 x	Threaded coupler ALU M3 Ø 4 (2 uds)
1 x	6 mm aluminium horn with patella
1 x	Horn 5/10 with M2 Bearing
1 x	Cable control set
1 x	Horn 6/20 with M3 Bearing
1 x	Horn with ball 55x40
1 x	SlowFlyer control horn (3 pcs)
2 x	Threaded coupler ALU M2,5 Ø 4 (2 uds)
1 x	Threaded coupler ALU Left M3 Ø 4 (2 uds)
1 x	Small aluminium horn red (2pcs)
1 x	Stickers-digit for marking
1 x	Threaded coupler ALU M3 Ø 6 (2 uds)
1 x	Threaded coupler ALU M2,5 Ø 6 (2 uds)
1 x	Horn 6/27 with M3 Bearing
1 x	800TVL CMOS camera for FPV
1 x	Camera Sony 4140+673 CCD with Built-in 200mw TX + antenna
1 x	Circlik for shaft 1.2 mm (10 pcs)
1 x	Aluminium wide washer M3 gold (4 pcs)
1 x	Brass hexagonal rod Ø 4 mm x 1000 mm
1 x	Aluminium tube (L 1000 mm, Ø3.0 mm, Ø2.1 mm)
1 x	APM2.6 Power module with 5.3V DC BEC
1 x	Extension S-Bus 1-2 silicon 30 cm FUTABA
1 x	Propeller balancer
1 x	Nylon hinge for flaps/gates 27x10,5 (2 pcs)
1 x	Large flex hinge (12 uds)
1 x	Adapter 3,0 mm M6
1 x	3 mm Short Prop Adapter M5
1 x	2,3 mm Prop Drive Günther M4
1 x	Threaded coupler M3 (10 uds)
1 x	Threaded coupler M2,5 Ø 2 mm (10 pcs)
1 x	2 mm Prop Adapter M5
1 x	Adapter 3,0 mm M6 for spinner 40 mm fixed propeller
1 x	Threaded coupler ALU M2 Ø 4 (2 uds)
1 x	Couple M4 for wire (10 pcs)
1 x	Horn 16,5x20 mm (2 pcs)
1 x	Horn for flap control (1 pcs)
1 x	Pin type hinge Al 4,5x70 mm to wire (2 pcs)
1 x	Cable with accesories
1 x	Brass control horn M3 short for wire (2 pcs)
1 x	Fully Threaded Steel Rod alumin 40 mm M2,5 (2 pcs)
1 x	Fully Threaded Steel Rod Duralumin 120 mm M3 (2 pcs)
1 x	Fully Threaded Steel Rod alumin 60 mm M3 (2 pcs) knurled
1 x	Fully Threaded Steel Rod Duralumin 130 mm M3 (2 pcs)
1 x	Fully Threaded Steel Rod alumin 90 mm M3 (2 pcs) knurled
1 x	Glow filter
1 x	PARTENAVIA 2020 mm ARC with Flaps
1 x	Fiberglass motor-holder for electric motors
1 x	DH82 Tiger Moth Scale 1:3.3 Panel Instrum. trasero
1 x	Wheel FEMA 70 mm / 5 mm
1 x	Wheel FEMA 152 mm / 8 mm
1 x	DUBRO - 102MM / 4" DIA BIG WHEELS (400RV) - 2PCS
1 x	Wheel 75 mm with electromagnet and brake disk (2 uds)
1 x	Nose wheel 62 mm
1 x	Wheel FEMA 178 mm / 8 mm
1 x	Wheel 115 mm with electromagnet and brake disk + E-Brake (2 uds)
1 x	USB Mini Camera endoscope
1 x	Carbon fabric 160 g/m² (plain weave) 100 cm x 3 m

1,857.88EUR