10.33EUR

Filter Capacitor JR
[EMCA18000]

- Filter Capacitor, directly connected to the receiver
- Effectively blocks short voltage peaks as well as voltage breaks
- Assures for constant power supply even under extreme conditions
- Especially recommended when using digital servos (“dynamo effect”)

few units

Reviews

Customers who bought this product also purchased

Motor DLE 35 RA few units	Porex gasoline filter few units	PH6 adapter for 6mm M10 AXI for AXI41xx few units
Propeller APC 11x7 Electric few units	Propeller APC 11x5.5 Electric few units	Propeller APC 10x5 Electric few units

Quick Find

Shopping Cart

1 x	SE Ring 400 mm (2 pcs)
1 x	20 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x	SE Ring HACKER 300 mm (2 pcs)
1 x	13 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x	5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x	Cable-Tie 1.66x71mm / 0.07x2.8″ (20 pcs)
1 x	SE Ring 300 mm (2 pcs)
1 x	SE Ring 200 mm (2 pcs)
1 x	20x200 mm battery rings
1 x	13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x	10 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x	SE Ring 350 mm (2 pcs)
2 x	Cinta Goldfix 1m
1 x	Pad self adhesive, up to 3mm / 0.12″, (10 pcs)
1 x	SE Ring 250 mm (2 pcs)
1 x	Tape GFK 38 mm
1 x	Tape GFK 50 mm
2 x	26 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x	14x60 mm Mini rings Tie Wraps (4 pcs)
1 x	Pad Screw Mount M3, up to 3mm / 0.12″, (10 pcs)
1 x	SE Ring 450 mm (2 pcs)
1 x	SE Ring 330 mm (4 pcs)
1 x	Stainless steel cable Ø 0.88 mm - 60 kp (10 m)
1 x	Covered closure or fairings
1 x	Micro screw-lock pushrod conn snap Ø 1 mm (2 uds)
2 x	Stainless steel cable Ø 0.62 mm (10 m)
1 x	Canopy Lock V1 M3 Red (2 pcs)
1 x	Steering arm 12 mm Ø 3 mm (2 uds)
2 x	Stainless steel cable Ø 0.5 mm (20 m)
1 x	Cap closure 33/23.5mm (2 uds)
1 x	Steering arm 16 mm Ø 3 mm
1 x	Steering arm 16 mm Ø 4 mm (2 uds)
1 x	Locking cable tie 4.6x203 (uds)
1 x	Locking cable tie 2.5x100 (uds)
1 x	Crimping sleeves for cable 0.70 mm (10 pcs)
2 x	Stainless steel cable Ø 0.5 mm (2 m)
1 x	Cabin latch Fox MDM1 4m (pair)
1 x	Screw-lock connector M2 (2 uds)
2 x	Crimping sleeves for cable 1.3 mm (10 pcs)
2 x	Aluminium alloy coupler for carbon tube 6/M4
1 x	Cockpit plastic closing
1 x	One touch canopy lock
1 x	Steering arm 16 mm Ø 4 mm
1 x	Cierre cabina aluminio Ø4, I=10 mm
1 x	Horizontal cockpit anchor "tipe F3A" (2 pcs)
1 x	Crimping sleeves for cable 0.85 mm (10 pcs)
1 x	Stainless steel cable Ø 0.52 mm - 15 kp (10 m)
1 x	Extinguisher CO2 - 2 Kg
1 x	Surface Indicator Gauge Small
1 x	XH female balance (5S) connector (2 pcs)
1 x	Connectors banna oro 3 mm (M/F)
1 x	Vacuum bag, 1200 mm x 50 m
1 x	Smoke set "Glider"
1 x	Tape GFK 25 mm
1 x	Ring 320 mm length (5 pcs)
1 x	Aluminun wheel collar 2.5 mm Ø (4 uds)
1 x	Pushrod greyline 3/2 with coupler M2 L: 1000 mm
1 x	Pushrod octagone 3/2
1 x	Tip wing protector 28x10x12 (2 pcs)
1 x	Steering arm 12 mm Ø 4 mm
1 x	Pushrod greyline 4/3 with coupler M3
1 x	Sanyo RX Battery Eneloop 6,0 V JR
1 x	Electric spoiler 250 mm (2 pcs)
1 x	DPS Switch JR/JR
1 x	DPSI RV Mini 6 Magic with Gas-Cap switch
1 x	Y Cable
1 x	Canopy Latch
1 x	DPSI RV Mini 6 Magic
1 x	DPSI RV Mini 5 Magic
1 x	Canopy Lock V1 M3 Blue (2 pcs)
1 x	DPSI V-Match
1 x	Vertical cockpit anchor "tipe F3A" (2 pcs)
1 x	Interface Realflight Simulator
1 x	11 mm Rubber pads (14 pcs)
1 x	MPX Sub-D Adaptor
1 x	Prop Shaft Adapter 8 mm/M12 "long"
1 x	EWC3 40 cm wing connector
1 x	DPSI Micro MPS

2,763.71EUR