186.00EUR

PowerBox Smokepump JETs 2x outside
[POWER8015]


PowerBox Smokepump JETs 2x outside
Product description

The PowerBox Smokepump has been developed by PowerBox-Systems specifically for pumping smoke oil in model aircraft. The mechanical system and electronics are manufactured on our own premises, and the unit's high standard of quality is evident from its long effective life: the PowerBox Smokepump is the world's most durable smoke oil pump, as has been demonstrated in several long-term tests.

The mechanical pump system is assembled entirely from high-quality aluminium and brass parts. All our pumps are subjected to a running-in procedure during manufacture, ensuring that the gears mesh perfectly, and that the pump is 100% leak-free. Tight manufacturing tolerances eliminate the need for a separate cut-off valve with the PowerBox Smokepump.

The electronic circuit is infinitely variable within the range 0%-100%, allowing the pilot to fine-tune the flow rate to match the exact requirements of the model. The Smokepump can be powered either by a PowerBox or a separate battery.

If a separate battery is used, the electronic circuit switches to a "stand-by" mode if the receiver fails to pick up a signal. This means that it is not necessary to provide a separate switch to isolate the PowerBox Smokepump from the battery when you switch the model off.

The PowerBox Smokepump is available in a Standard version and a Jet version, the later with higher throughput and twin outlets.

The maximum flow rate of the Smokepump (Order No. 8010) is around 750 ml./min., while the Smokepump Jet (Order No. 8015) is capable of around 950 ml. The set includes all the necessary connecting leads and a length of heat-resistant hose. The standard set also contains a Y-piece which can be used to connect both silencers of an opposed-twin (boxer) engine.

Features
Durable metal-geared pump
Infinitely variable flow rate from 0-100%
No external cut-off valve required
High maximum flow rate
Can be operated directly from the receiver power supply
Stand-by cut-off when used with separate battery
Compact design
Low current drain
Mounting facility

Technical Data
Operating voltage 4.0V - 9.0V
Current drain Power-on state approx. 1.8 Ampere at 100%
Current drain Standby 10µA
Max. flow rate max. 950ml/min
Smoke medium Smokeöl „blue Max“ or 3W Smokeöl
Dimensions 79 x 31 mm
Weight 128g
Temperature range -30°C to +75°C


Reviews
We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Gates hinge 30x16 mm (2 pcs)
1 x 48 x 10 mm cylidric hinge Ø 3,0 mm (10 pcs)
1 x 67 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs)
1 x Pin type hinge Al 4,5x70 mm to wire (2 pcs)
1 x Gates hinge
1 x Cylidric hinge 33 mm Ø 2 mm (5 pcs)
1 x Nylon hinge for flaps/gates 27x10,5 (2 pcs)
2 x Unmounted aluminium pin 6x98 mm (2 pcs)
1 x Gates hinge aluminium (1 pcs)
2 x Nylon hinge 20x20x0,3 (10 pcs)
1 x Pin type hinge Al 6x98 mm (2 pcs)
1 x 15 mm reinforced hinge
1 x Fast'n EZ-CA-Hinge (12 uds)
1 x Nylon hinge for flaps 33x9 (2 pcs)
1 x Pin type hinge Al 3,0x50 mm demount (2 pcs)
3 x 76 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs)
2 x Nylon hinge 20x15x0,3 (10 pcs)
1 x Small pinned hinge (12 uds)
1 x Fast'n EZ-CA-Hinge, lite (12 uds)
1 x Flap hinge (6 pcs)
2 x 18 mm reinforced hinge
1 x Nylon hinge 15x0,3 (10 pcs)
1 x Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs)
1 x Prolongador S-Bus JR/JR 10cm
1 x Premium servo extension 75cm
3 x Cabel "Y" 15 cm
1 x Extension silicon 100 cm (Graupner)
3 x Extension 30 cm (Futaba)
2 x Extension silicon 10 cm (Futaba)
1 x Futaba male 40 cm extension
2 x Extension 15 cm (Futaba)
2 x Cabel "Y" 30 cm (graupner)
3 x Extension PVC 150 cm (Graupner)
2 x Extension silicon 30 cm female (Futaba)
2 x Cabel "Y" 30 cm (Futaba)
2 x Extension silicon 35 cm male (Futaba)
2 x Prolongador S-Bus JR/JR 20cm
1 x Premium servo extension 100cm
1 x Extension silicon 10 cm (Graupner)
3 x Circlick securite
1 x servo adapter lead, JST-SH socket - JR male Pin, for GR-12SH+HoT
2 x Futaba Female 40 cm extension
2 x 0,14 mm PVC servo wire extension, ZH micro conector.
1 x ABS Strip 1.5x6.0x1000 mm
1 x Propeller POWER-PROP 14x9 Izda
1 x Paramotor BackPack XXS 2
1 x Windsock Ozone L - 700 mm
1 x Red copper lacquer wire Ø0,2 mm (5 m)
1 x Copper lacquer wire Ø0,2 mm (5 m)
1 x Red aluminium servo arm V2-Futaba 1,5" inch M3
1 x SERVO DES 806 Pignons
1 x Red aluminium servo arm V2-Futaba 1,25" inch M3
1 x Angle support XT60 conector
2 x Support Filtro FESTO
1 x Pasacables rectangular 40x15 mm (4 pcs)
1 x Servo MKS HBL380
1 x Servo SAVOX SV-1260 MG
2 x Savox Brushless Servo SC-1267 SG
2 x Savox HV Brushless Servo SB-2270SG (Swashplate)
1 x Soporte filtro FESTO (4 pcs)
2 x Servoarm SH-81, two sides, aluminium
1 x 33 x 8 mm cylidric hinge Ø 2,5 mm (10 pcs)
3 x 57 mm micro-mini servo cover
3 x Servo TOPMODEL DS9010 T
2 x Servo TOPMODEL S7520 MG
1 x Extension silicon 75 cm (Graupner)
1 x Extension 100 cm (Futaba)
1 x Extension lead 15 cm Multiplex
3 x Cable silicona macho batt. receptor 30 cm (Graupner)
1 x Pin type hinge Al 4,5x70 mm (2 pcs)
1 x 48 mm cylidric hinge Ø 2,5 mm (5 pcs)
1 x Extension silicon 30 cm female (Graupner)
1 x Extension silicon 30 cm male (Futaba)
1 x Extension silicon 50 cm (Graupner)
1 x Extension S-Bus 1-2 silicon 120 cm FUTABA
1 x Long pinned hinge (12 uds)
2 x Large flex hinge (12 uds)
1 x Cable silicona female batt. receptor 30 cm (Futaba)
1 x Extension silicon 25 cm (Graupner)
1 x Futaba Female 40 cm extension
1 x Pin type hinge Al 3,0x50 mm (2 pcs)
1 x Cylidric hinge 43 mm Ø 2,5 mm (5 pcs)
1 x Extension 90 cm (Futaba)
1 x Extension silicon 75 cm (Futaba)
1 x Softshell Hispano Aviación
1 x LightBox SR
1 x Ka-8b ELECTRIC 6000 mm ARF 1:2.5 (Phoenix Models)
1 x Elevator VENTUS 2cx 4.5m
1 x LS-8 GFK 6m Glider
1 x Fox 4000 mm (Airwold)
1 x ASW 20 5000 mm with winglets (Airwold)
1 x Fox MDM 1 4000 mm DeLuxe,Fox 1:4 set of instruments for the f
1 x LO 100 Scale 1:2 - Modellbau Bruckmann
1 x LED wire (orange - 2pcs)
1 x Fournier RF-4D
1 x DINO Glider ARC
1 x LO 100 ARC 3.3m,cabina
1 x Kobuz 5000 mm (Airwold)
1 x LED wire (white - 2pcs)
1 x FOX MDM-1 3.500 mm ARF White
1 x Digital Air Speed Sensor And Pitot Tube Set
1 x Battery LiFe TopFuel 3100 mAh 4s MTAG 30C
1 x JR silicone servo wire 0,35 qmm / 5m
1 x Cable servo PREMIUM MAXI 100m (blanco/rojo/azul) PVC
1 x Battery LiFe TopFuel 3100 mAh 3s MTAG 30C
1 x PVC 0,14 qmm servos wire Graupner (100 m)
1 x PVC 0,14 qmm servos wire Hitec/Mpx (5 m)
1 x Silicone red 0,25 mm² wire (25 m)
1 x Tube Pitot to PIXHAWK
1 x Aro pasacable Ø25 mm (4 pcs)
1 x Aro pasacable Ø20 mm (4 pcs)
1 x Extinguisher CO2 - 2 Kg
1 x 58 mm micro servo cover
1 x Servo SAVOX SV-1261 MG
1 x SAVOX SH 0254 servo
2 x Servo TOPMODEL STANDARD S3217
1 x Servo mounting frame SV-1260MG
1 x Spinner INO 63 mm Chrome (Imitacion metal)
1 x Extension 7.5 cm
1 x Dean "T" - Futaba Adapter
1 x Support ECU Xicoy X-45
1 x Support pump Xicoy X45
1 x Support XT60 conector (2 pcs)
1 x Support pumb/filter Xicoy X45
1 x Support Pitot JETI
1 x Support conector MPX (6 pcs)
1 x Towing hook
1 x Support FUEL DOT V3
1 x Soporte grifo FESTO (2 pcs)
1 x Recessed MPX connector support (6 pcs)
1 x Tapa estado carga XT-60 (6 pcs)
1 x Servo BLUE Bird BLS-H71B v2
1 x LOWER TOW HOOK
1 x Servo SAVOX SA-1258 TG
1 x Servo SAVOX SA-1256 TG
2 x 50x45 mm micro-mini servo cover
1 x SAVOX SH 1250 MG servo digi
1 x Servo SAVOX SV-1254 MG HiVolt Low Profile
1 x 18 mm wing servo holder
1 x Servo SAVOX SV-0236 MG HV
1 x Servo SAVOX SH 0257 MG
2 x 90x60 mm standart servo cover
1 x Servo SAVOX SV-1270 TG
1 x Servoarm Aluminium SH-82
1 x Servo SAVOX SA-128S SG
2 x 11 mm wing servo holder
1 x Savox Brushless Servo SC-1251 MG
1 x SAVOX SH 0255 MG servo
1 x Servo SAVOX SV-1273 TG
2 x Servo TOPMODEL DS1413 T
1 x Piñones SAVOX SH-0350
1 x SAVOX SH 1290 MG servo digi
2 x 90x75 mm standart servo cover
1 x Servo SAVOX SB-2290 SG
1 x Extension MPX-MPX 20 cm
1 x Spinner INO 51 mm Chrome (Imitacion metal)
1 x Smoke Oil Blue 5 l
1 x Vest clothes Hispano Aviación
1 x PowerBox Smokepump JETs 2x outside
1 x Spinner INO 82 mm Chrome (Imitacion metal)
1 x 51 mm white plastic spinner for fixed propeller / 4,0 mm axi
1 x 82 mm INO spinner (carbon imitation)
1 x Cable servo PREMIUM MAXI 10m (blanco/rojo/azul) PVC
1 x Cable set PREMIUM Maxi, SUB-Done 4three fuselage/wing 200 cm
1 x Extension for LC-Display 50cm
1 x Spinner Alumin. fixed propeller 45 mm / 5,0 mm
1 x 75 mm INO spinner (carbon imitation)
20,955.35EUR
Manufacturers
Languages
Español English
Currencies