Features:
- SRS – Serial Receiver System provides the ability to use receivers with a serial interface, such as those made by Spektrum DSM2 and DSMX, Multiplex M-LINK, Futaba S-BUS and Jeti R_SAT.
- For Spektrum and Jeti satellites, Futaba S-BUS Multiplex M-LINKand HoTT receivers
- All channels from the receiver are transferred using a three-core lead
- Complete receiver redundancy, double the security
- Complete battery redundancy: two batteries, two electronic switches, redundant output voltage with dual regulation
- Spektrum with four satellites, Futaba with two S-Bus receivers, Multiplex with two M-Link receivers, HoTT, Jeti with two satellites
- High-resolution graphic OLED screen with 128 x 64 pixels
- Ultra-simple menu-based programming using the SensorSwitch
- Eleven channels + one channel for door sequencer
- Downlink channel transmission for Spektrum and MPX
- Unrestricted channel assignment for all output sockets, (channel output mapping)
- Synchronised servo outputs for totally simultaneous servo movements
- Four-stage user-variable servo frame rate (9ms, 12 ms, 15 ms, 18 ms, 21 ms)
- Integral freely programmable door sequencer
- The unit saves receiver data, such as "lost frames" and "failsafes", for all connected receivers - whether Spektrum, Futaba, Multiplex, Jeti. Data can be read out after the flight on the OLED screen
- Four match-channels for two servos each; both servos individually variable
- 16-bit processor for high-speed, high-resolution signal processing
- Signal amplification for a total of 12 channels and 21 servos
- Direct transmission of battery voltages and capacities to the transmitter (downlink channels)
- On-screen voltage display for each battery separately, with bar indicator
- Residual capacity display for both batteries separately
- User-variable servo voltage: choice of 5.9 V or 7.4 V
- Minimum value memory shows any voltage collapses
- Large-area heat-sink for high regulator capacity
- Regulator monitor and regulator error indicator
- Supports three battery types: LiPo, LiIon, NiMH / NiCd, LiFePo
- Suppression of any servo feedback currents which might occur
Specification:
- Operating voltage: 4,0 Volts to 9,0 Volts
- Power source:
2 x two-cell LiPO batteries 7,4 Volts
2 x five-cell NiCd or. NiMH batteries
2 x two-cell LiFePo batteries (A123)
- Current drain:
switched on - approx. 130 mA
switched off - approx. 15 µA
- Dropout voltage: approx. 0.25 V
- Max. receiver and servo current: 2 x 3 A (stabilised) according to cooling , Peak 2 x 20 A
- Servo signal resolution: 0,5 µs
- Signal repeat rate: 9 ms, 12 ms, 15 ms, 18 ms, 21 ms (frame rate)
- Screen: OLED 128 x 64 pixels, graphic
- For: Spektrum, Futaba, Multiplex, Jeti, HoTT.
- Servo sockets: 21 Sockets, 12 channel
- Temperature range: - 30 °C to + 75 °C
- Dimensions: 110 x 72 x 24 mm
- Weight: 115 g
- SensorSwitch: 15 g
- EMV approval: EN 55014-1:2006
- CE approval: 2004/108/EG
- WEEE Reg. No.: DE 639 766 11