59.00EUR

Glases Innovation Plus
[CMINNOVATIONP]



Set de gafas, cristales, funda y trapo
Do you have to wear prescription glasses? Fed up with seeing your buddies turn up at the field with great looking and practical glasses you just can't wear? We have the answer in the form of these stylish prescription model flying sunglasses, which have been especially developed for radio control model use.

At the heart of the design is a polycarbonate frame that houses your prescription lenses; this clips onto a main frame, which in turn houses the coloured shades that simply clip on to a hinged section. These hinges allow you to temporarily turn up the outer lenses in order to closely inspect a model in the pits etc.

Innovation Plus are polarised sunglasses. The polarised cristals greatly reduce glare, which is an effect caused by light hitting horizontally flat surfaces. Polarised lenses filter out this light to greatly enhance your visibility.

The de-centred, scratch resistant lenses have been optically balanced to negate the effects their curvature would otherwise have on your vision. Conforming to US ANSI Z80.3 plus British and European safety standard EN1836, our sunglasses are factory impact-tested, and offer great protection against flying debris should you suffer a mishap. All of our glasses carry the CE (European Union standard) compliance mark. The interchangeable lenses are: yellow (category 1) low light - these actually enhance light and contrast; beige (category 2) average sunlight; smoked mirror (category 3) bright sunlight; dark smoked (category 4), very bright conditions.

The glasses come with the interchangeable lenses, a cleaning cloth and a superb carry case with belt clip. All frames and the carry case display our 'Model Glasses' logo.

WILL THEY WORK FOR ME? - If you have a prescription (SPH) requirement that's less than plus or minus 4.00, our glasses will work just fine for you. Stronger prescriptions can cause distortion, due to the curvature of the tinted lenses when placed in front of the flat prescription clip. The de-centring calibration loses its effect where stronger prescriptions are required. If you have a requirement greater than plus or minus 4, please do not buy these glasses. Bi-focals, varifocals and prismatic lenses can be added - if in doubt, please consult your optician for advice.

IMPORTANT NOTE
When wearing Innovation Plus, some users may find they cannot see certain types of LCD or other electronic / digital transmitter displays. This is a normal cause of wearing polarised glasses. We recommend using the glasses with the front section flipped up, or the glasses removed, when model trimming prior to use.


few units
few units

Reviews

Customers who bought this product also purchased
Tape GFK 50 mm
Tape GFK 50 mm

few units
few units

Tape GFK 25 mm
Tape GFK 25 mm

few units
few units

MAX BEC
MAX BEC

few units
few units

Fiberglass plate 350x150x0.5 mm
Fiberglass plate 350x150x0.5 mm

few units
few units

Connectors DEANS (T)
Connectors DEANS (T)

few units
few units

Conector FUTABA Servo male  (10 pcs)
Conector FUTABA Servo male (10 pcs)

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Extractor piñones 2.3/3.2 mm
2 x Flap hinge 33x9 mm (6 pcs)
1 x Nylon hinge for flaps 33x9 (2 pcs)
2 x 48 mm cylidric hinge Ø 2,5 mm (5 pcs)
1 x Small pinned hinge (12 uds)
2 x Large flex hinge (12 uds)
2 x Cylidric hinge 43 mm Ø 2,5 mm (5 pcs)
1 x Nylon hinge 15x0,3 (10 pcs)
1 x 67 mm cylidric hinge Ø 5 mm (4 pcs)
2 x Pin type hinge Al 3,0x50 mm demount (2 pcs)
1 x 48 x 10 mm cylidric hinge Ø 3,0 mm (10 pcs)
1 x Long pinned hinge (6 uds)
1 x 18 mm reinforced hinge
2 x Nylon hinge 20x20x0,3 (10 pcs)
2 x 43 x 10 mm cylidric hinge Ø 2,5 mm (10 pcs)
1 x 33 x 8 mm cylidric hinge Ø 2,5 mm (10 pcs)
1 x 15 mm reinforced hinge
2 x Nylon hinge for flaps/gates 27x10,5 (2 pcs)
2 x Gates hinge black 30x16 mm (2 pcs)
2 x Pin type hinge Al 3,0x50 mm (2 pcs)
2 x Nylon hinge 20x15x0,3 (10 pcs)
1 x Gates hinge aluminium (1 pcs)
2 x 25 mm reinforced hinge
2 x Gates hinge 30x16 mm (2 pcs)
1 x Pin type hinge Al 4,5x70 mm (2 pcs)
1 x Gates hinge
1 x 67 mm cylidric hinge Ø 4,5 mm (5 pcs)
2 x Micro flex hinge (12 uds)
1 x Mahogany wood slat 1.5x1.5x1000 mm
1 x Walnut wood slat 3.0x3.0x1000 mm
1 x Beech dowels 3.0 x 1000 mm
1 x Pine wood slat 3.0x10.0x1000 mm
1 x BALSA trip 6.0x6.0x1000 mm
1 x Pine wood slat 3.0x7.0x1000 mm
1 x Mahogany wood slat 2.0x2.0x1000 mm
1 x Liston HAYA 8 x 8 x 1000 mm
1 x BALSA triangular 10x10x1000 mm
1 x Pine wood slat 6.0x6.0x1000 mm
1 x Walnut wood slat 1.5x1.5x1000 mm
1 x Pine wood slat 2.0x10.0x1000 mm
1 x OBECHI sheet 2.0x3.0x1000 mm
1 x Liston HAYA 10 x 10 x 1000 mm
1 x Beech dowels 10 mm x 1000 mm
1 x BALSA triangular 8x8x1000 mm
1 x Straightened rod Ø 3.0 mm x 1000 mm
2 x Brass hexagonal rod Ø 5 mm x 1000 mm
2 x Straightened rod Ø 14.0 mm x 1000 mm
1 x Straightened rod Ø 4.0 mm x 1000 mm
1 x Straightened rod Ø 5.5 mm x 1000 mm
2 x Straightened rod Ø 1.0 mm x 1000 mm
1 x Straightened rod Ø 1.5 mm x 1000 mm
1 x Brass hexagonal rod Ø 4 mm x 1000 mm
1 x Straightened rod Ø 0.5 mm x 1000 mm
2 x Straightened threaded rod M2-1m
1 x Brass hexagonal rod Ø 3 mm x 1000 mm
2 x Brass rod Ø 1.0 mm x 1000 mm
1 x Straightened rod Ø 5.0 mm x 1000 mm
2 x Brass rod Ø 0.8 mm x 1000 mm
1 x Straightened rod Ø 6.0 mm x 1000 mm
1 x Threaded coupler ALU M2 Ø 4 (2 uds)
1 x Carbon fiber rod 20 mmx1000 mm
1 x Wing-connector: Glass / Carbon tube (13.7/12.5) x 1000 mm
1 x Extension silicon 30 cm male (Futaba)
1 x Pin hinge 34x16 mm (10 uds)
4 x Long pinned hinge (12 uds)
1 x Pin type hinge Al 4,5x70 mm to wire (2 pcs)
2 x Fast'n EZ-CA-Hinge (12 uds)
1 x Robart Door Hinge (Pk2)
2 x Unmounted aluminium pin 6x98 mm (2 pcs)
2 x Flap hinge (6 pcs)
1 x Aluminium coupler M2/2 with ball bearing (1 pcs)
1 x A/C quality beech plywood 600x300x6.0 mm
1 x Balsa panel 3.0x100x1000 mm
1 x A/C quality beech plywood 600x300x5.0 mm
1 x Balsa panel 6.0x100x1000 mm
1 x quality beech plywood BIRCH 600x300x2.0 mm
1 x Balsa panel 2.5x100x1000 mm
1 x Birch plywood plate 600x300x1.5 mm
1 x A/C quality beech plywood 1520x750x4.0 mm
1 x Birch plywood plate 600x300x2.0 mm
1 x Birch plywood plate 600x300x4.0 mm
1 x BALSA triangular 6x6x1000 mm
1 x A/C quality beech plywood BIRCH 600x300x1.0 mm
1 x Miniature brass strap hinge, 1 m
1 x Glases Nimbus
1 x Straightened threaded rod M3 - 1m
1 x ROBART POINT HINGE 4,7mm (5 pcs)
1 x PILATUS PC-6 Turbo Porter 33% 5.290 mm
1 x 9x4.7 * 22x12 carbon propeller
1 x Propeller APC 10x7 Electric
1 x Propeller APC 12x6 Electric Pusher
1 x Reductora IPS 150 DX2BB-DXCS 9,7:1
1 x Propeller 3x3
1 x Reductora IPS 150 DX2BB-FXCS 11,8:1
1 x Propeller APC 12x8 SF
2 x Propeller 9x7 SlowFlyer
1 x Small flex hinge (12 uds)
1 x Fast'n EZ-CA-Hinge, lite (12 uds)
1 x Small pinned hinge (6 uds)
1 x Round flex hinge (12 uds)
1 x CARBON CUB 15cc ARF 2280 mm
1 x Bidule 111 3000 mm
1 x CARBON CUB FX-3 100-200CC ARF, 165" - 4200 mm (Hangar9)
1 x Zurich Sport Sunglasse Dark Sensity BROWN Glasses
1 x Bidule 55 V3 2460 mm
1 x SKY MASTER 3.000 mm ARF
1 x Sun Cover ULTIMATUM 2.0 (Hispano Aviacion)
1 x Suncover 100cc Red
1 x Foam wheel Ø 351 mm (2 pcs)
2 x Propeller 3x2
1 x Propeller APC 11x3.8 SF
1 x Propeller 11x4,7 SlowFlyer
1 x Propeller 9x4,7 SlowFlyer
1 x Propeller 8x4,3 SlowFlyer
1 x Propeller APC 14x12 Electric
1 x Foam wheel Ø 38 mm (2 pcs)
1 x Reductora IPS 150 DX2BB-BXCS 7:1
1 x Propeller APC 13x6.5 Electric Pusher
1 x Propeller APC 13x4 Electric
1 x Propeller APC 11x7 Electric
1 x Propeller 10x4,7 SlowFlyer
1 x Propeller APC 13x4 Electric Pusher
1 x Transmitter Crystal 35 Mc/s Ch 77
1 x Rocket cardboard tube 50mm x 48mm x 250mm
1 x Crystal Universal RX 35.150 Ch 75
1 x Actro 32-3 Heli MAX 5mm
1 x Motor PERMAX BL-O 3520-920 (Extra 330 SC)
1 x Motor OS MAX 65 AX (incl. muffler)
1 x Receiver Crystal 35 Mc/s Ch 62
1 x Rocket D9-7
1 x Rocket cardboard tube 25mm x 24mm x 230mm
1 x 24x8 BIELA propeller
1 x Propeller MASTER 5,5x4
1 x 8x6 tree blades propeller
1 x Vess propeller 11x7 S
1 x FALCON 27X11 CARBON PROPELLER (GAS)
1 x Propeller MASTER 5,5x4,5
1 x Glases Nimbus "Black"
1 x Straightened rod Ø 4.5 mm x 1000 mm
1 x Straightened rod Ø 2.0 mm x 1000 mm
1 x 3-blades 30x12 carbon prop Super Silence
1 x 28x16 BIELA propeller (3-blades) Corsair Scale
1 x 3-blades 20x10 carbon prop Super Silence
1 x 28x12 prop Super Silence
1 x 3-blades 27x12 carbon prop Super Silence
1 x Propeller MEJLIK 29x10S
11,556.68EUR
Manufacturers
Languages
Español English
Currencies