59.00EUR

Glases Innovation Plus
[CMINNOVATIONP]



Set de gafas, cristales, funda y trapo
Do you have to wear prescription glasses? Fed up with seeing your buddies turn up at the field with great looking and practical glasses you just can't wear? We have the answer in the form of these stylish prescription model flying sunglasses, which have been especially developed for radio control model use.

At the heart of the design is a polycarbonate frame that houses your prescription lenses; this clips onto a main frame, which in turn houses the coloured shades that simply clip on to a hinged section. These hinges allow you to temporarily turn up the outer lenses in order to closely inspect a model in the pits etc.

Innovation Plus are polarised sunglasses. The polarised cristals greatly reduce glare, which is an effect caused by light hitting horizontally flat surfaces. Polarised lenses filter out this light to greatly enhance your visibility.

The de-centred, scratch resistant lenses have been optically balanced to negate the effects their curvature would otherwise have on your vision. Conforming to US ANSI Z80.3 plus British and European safety standard EN1836, our sunglasses are factory impact-tested, and offer great protection against flying debris should you suffer a mishap. All of our glasses carry the CE (European Union standard) compliance mark. The interchangeable lenses are: yellow (category 1) low light - these actually enhance light and contrast; beige (category 2) average sunlight; smoked mirror (category 3) bright sunlight; dark smoked (category 4), very bright conditions.

The glasses come with the interchangeable lenses, a cleaning cloth and a superb carry case with belt clip. All frames and the carry case display our 'Model Glasses' logo.

WILL THEY WORK FOR ME? - If you have a prescription (SPH) requirement that's less than plus or minus 4.00, our glasses will work just fine for you. Stronger prescriptions can cause distortion, due to the curvature of the tinted lenses when placed in front of the flat prescription clip. The de-centring calibration loses its effect where stronger prescriptions are required. If you have a requirement greater than plus or minus 4, please do not buy these glasses. Bi-focals, varifocals and prismatic lenses can be added - if in doubt, please consult your optician for advice.

IMPORTANT NOTE
When wearing Innovation Plus, some users may find they cannot see certain types of LCD or other electronic / digital transmitter displays. This is a normal cause of wearing polarised glasses. We recommend using the glasses with the front section flipped up, or the glasses removed, when model trimming prior to use.


few units
few units

Reviews

Customers who bought this product also purchased
Fiberglass plate 350x150x0.5 mm
Fiberglass plate 350x150x0.5 mm

few units
few units

Tape GFK 50 mm
Tape GFK 50 mm

few units
few units

Tape GFK 25 mm
Tape GFK 25 mm

few units
few units

MAX BEC
MAX BEC

few units
few units

Conector FUTABA Servo female BLUE silicon (10 pcs)
Conector FUTABA Servo female BLUE silicon (10 pcs)

few units
few units

Connectors DEANS (T)
Connectors DEANS (T)

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Hot Glue Stick RED
2 x Cut tube
1 x Crimping tool
1 x Vacuum pump P1-N
2 x Vacuum Connection VA 1 (for hose Ø 6 mm)
1 x PROXXON - SANDING BELTS FOR BSL 220/E 120 GRIT (5 pcs)
1 x PROXXON - SANDING BELTS FOR BSL 220/E 80 GRIT (5 pcs)
1 x 1,5x50 mm allen screwdriver
2 x Starter EM Gear Power 80
3 x Z Bender - S Type Tool
2 x Screwdriver for Torx® TX6
2 x Crimping tool
2 x Starter 12v (Max 180 and 30ccm)
1 x Starter Sullivan-STAR 603 DINATRON
1 x Screwdriver for Hexagon 1,27mm
1 x 2,0x50 mm allen screwdriver
1 x 
2 x Starter Sullivan-STAR 601
1 x 2,5x60 mm allen screwdriver
1 x Vacuum pump 12 CFM
2 x Z Bender - S Type Tool
3 x Starter 12v (Max 90 and 15ccm)
1 x Rigid coupling brass Ø 4.0 / 3.2 mm L: 25 mm
1 x Propeller RABOESCH M3 50 mm (3 Blades pr) (Left hydropropeller)
1 x U Profile ABS 5,0x10,0x1000 mm
1 x Rigid coupling brass Ø 5 mm L: 25 mm
1 x Propeller RABOESCH M4 45 mm (3 Blades pr) (Right)
1 x T-Connector 4.0 mm x 1000 mm
1 x 290 mm M5 Prop shaft
1 x U Profile ABS 2,0x4,0x1000 mm
1 x Propeller RABOESCH M4 40 mm (3 Blades) (Left hydropropeller)
1 x Rigid coupling brass Ø 3 mm L: 20 mm
1 x RF9 Flight Simulator with Spektrum Controller
1 x Interface Jack Adapter IKARUS
1 x Lock washer 3.2 mm (20 pcs)
1 x Silicone 0,50 qmm servos wire Graupner(100 m)
1 x Mahogany wood slat 3.0x3.0x1000 mm
1 x Set fresas corte acero-carburo Ø 0.5/1.8 mm (2 pcs)
1 x Screwdriver for Torx® TX8
2 x Sub-D Plug Mold
1 x 
2 x 3,0x60 mm allen screwdriver
2 x Set brocas Ø 1.5-2.0-2.5-3.0 mm (4 pcs)
1 x Soldering tip for KAVAN soldering iron KAV66.8338
1 x Tube bender
1 x Set brocas Ø 0.4-0.6-0.8-1.0 mm (4 pcs)
3 x 25 mm Sandpaper file
2 x Fresa corte diamante Ø 2.35mm (flame)
1 x Fresa corte diamante Ø 2.7mm (bola)
1 x Kwik link unmount tool
2 x Wooden mouth spatulas (150 x 18 x 1.5 mm), 100 pcs
1 x Pegamento Pu R 50g polyuretano
1 x UHU Por 50ml/40g
1 x Heat-conducting adhesive (2x2ml), WLK DK 4
1 x Disposable Injector Bags (30x16cm) 100 pcs
1 x Propeller RABOESCH M4 55 mm (5 Blades) (Right hydropropeller)
1 x Strip 2,0x2,0x330 mm
1 x Propeller RABOESCH M5 65 mm (4 Blades) (Right hydropropeller)
1 x Solvent Plasti Dip 1000 ml
1 x Nitroverdu 500 ml
1 x Release wax 250ml
1 x 20 g tin paste
1 x 
1 x Spray adhesive AEROFIX 2
1 x Spannlack 1000 ml
1 x Hobbylite Filler, Balsa colour
1 x Spray YELLOW Inca Lexan 150ml
1 x Plasti Dip Liquid Tape 429 ml orange
1 x Paint gun for sprays
1 x 1000 ml sealer (DOPE)
1 x FesEx-Uni8 System
1 x Propeller RABOESCH M4 55 mm (5 Blades) (Left hydropropeller)
1 x Strip 1,5x1,5x330 mm
1 x Propeller RABOESCH M4 60 mm (5 Blades) (Right hydropropeller)
1 x Propeller RABOESCH M4 55 mm (5 Blades) (Left hydropropeller)
1 x ABS Strip 1.0x2.0x1000 mm
1 x Propeller RABOESCH M4 65 mm (4 Blades) (Right hydropropeller)
1 x Propeller RABOESCH M4 45 mm (3 Blades pr) (Left hydropropeller)
1 x Propeller RABOESCH M5 90 mm (4 Blades) (Left hydropropeller)
1 x GameCommander USB Universal
1 x Aramid fibre shears Proton®, 21 cm / 8" length
1 x Propeller diller for DA50, DLE55 red
1 x PROXXON - SAW BLADE DIAMOND OZI/E
1 x Tool for entel
2 x Set fresas corte Vanadium Ø 2.3/2.35 mm (3 pcs)
1 x Fresa corte diamante Ø 1.4mm (bola)
1 x Fresa corte diamante Ø 2.3mm (bola)
1 x Mold plugs XT-30
1 x Universal Filter
1 x Battery LiFe -3800/25C-3S 9.9V
1 x JETCENTRAL ECU LIFE BATTERY 3800 MAH
1 x FIALA Propeller 19x12 Electric
1 x Air Intake manifold 90° - Large
1 x Foam air filter Ø 48 mm, blue
1 x Starter EM Gear Power 250
1 x Welder 100W/200V
1 x silverlot 45% - 1,50x500 mm solder rods (2 pcs)
2 x Pump hose (Ø 6/8 mm) transparent
1 x EC-Cutter
1 x Boxed KIT OF 7 Rotary Burrs FINE
1 x 22 mm Cut Disc Proxxon/Dremmel
1 x PROXXON - DRILL SET 0,5-3,2MM (10PCS.)
1 x Pistola termica MH 550 micro
1 x PROXXON - SANDING BELTS FOR BSL 220/E 180 GRIT (5 pcs)
1 x Schul-Malpinsel Gr.5
1 x Set brocas Ø 2.0-2.2-2.4-2.6 mm (4 pcs)
1 x Propeller drill jig DA 100/85/120/150/200 and VM 60-210
1 x XT-60 Plug Mold
1 x Hot Glue Stick BLACK
1 x Digital scale up to 40 kg
1 x Tachometer HANGAR 9 digital
1 x MPX plug mold V1
1 x Set fresas corte Vanadium Ø 2.3/2.35 mm (3 pcs)
1 x Goma arrancador Ø36 mm x 30 mm
1 x PERMAGRIT Sanding Block 45° 140x51 mm
1 x Heat Seal Iron
1 x Dean-T Plug Mold
1 x Handle for PERMAGRIT lime
1 x Extra Hard Titanium Herxagon Screwdrivers
1 x FIALA Propeller 23x8 Electric
1 x Turbina KINGTECH K320 G5
1 x GSU Kingtech
1 x Kerostarter K30G
1 x Turbina KINGTECH K180 G4+
1 x KingTech Turbineoil 10L
1 x Colador RABBIT
1 x Epoxy MID-CURE™ 15 min (130g)
1 x VITAPROP CARBON FOLDING PROP 15x9.5"
1 x Turbine KINGTECH K85 G4
1 x Adhesive epoxy structures RESOLTECH 3350 (1 kg)
1 x A60 Motor Mount Alu complete set
1 x Backmountset complete A40
1 x Glases Moritz
1 x Glases Flitemaster
15,782.12EUR
Manufacturers
Languages
Español English
Currencies