15.06EUR

Opto Gas Engine Kill Switch
[ROI142KS]


This kill switch is Optically Coupled to isolate your ignition system from your radio system. (No Interference!!) this device features the following:

•Includes a remote mountable bright LED to indicate when the ignition is armed.
• Optically Coupled input/output is Isolated.
• 8 Bit PIC Controller.
• Li-Po/Li-Ion/A123/Ni-Mh/NiCad Input.
• Up to 20 Volt 15 amp MOS-FET output.
• DSP Noise/Loss of signal Filtering.
• PPM-PCM 2048 – 1024 & 2.4Ghz Interface Support.
• Low Voltage Drop – Less than 150mv.
• 100% Surface Mount Technology.
• Heavy Gauge Wires, universal connectors.
• Small and light weight – only 12 Grams!

This device plugs into a spare receiver channel.

This is a must have safety device for any gas powered plane! This device allows you to safely kill your engine at anytime (on the ground, or inthe air!)


few units
few units

Reviews

Customers who bought this product also purchased
Propeller MENZ-S 17x10
Propeller MENZ-S 17x10

few units
few units

Propeller MENZ-S 18x12
Propeller MENZ-S 18x12

few units
few units

Cylidric hinge 33 mm Ø 2 mm (5 pcs)
Cylidric hinge 33 mm Ø 2 mm (5 pcs)

few units
few units

MPS Gas-Cap-Powerswitch
MPS Gas-Cap-Powerswitch

few units
few units

Straightened rod Ø 1.0 mm x 1000 mm
Straightened rod Ø 1.0 mm x 1000 mm

few units
few units

Tacometer mini ignition RCEXL
Tacometer mini ignition RCEXL

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH
2 x Horn with ball 40x30
1 x Big-Malibu XL Roof box with surfboard rack GREY
1 x DLE 111 Old Crankshaft keyway
1 x Cilinder DLE 30 - DLE 60
1 x Aluminium alloy coupler for carbon tube 6/M4
1 x Head lower part
1 x Cierre cabina aluminio Ø5, I=16 mm
1 x Brass control horn M4 short for wire (10pcs)
2 x Cierre cabina aluminio Ø4, I=10 mm
1 x Suncover 100cc Red
1 x 6 mm red aluminium threaded horn with patella
1 x Stainless steel cable Ø 0.5 mm (2 m)
1 x Steering arm 16 mm Ø 4 mm
1 x Nut M1,6
1 x Balls 4 mm
1 x Autogyro Cierva C30 Spain
1 x Stainless steel cable Ø 0.52 mm - 15 kp (10 m)
1 x SUS wire 3m (nylon coated)
1 x Screws M1,6x6 Allen
1 x Cabin latch Fox MDM1 4m (pair)
1 x Horn DUBRO 1/2A
1 x Head lower part New
1 x Horn micro type4 Ø 0,5 (2 pcs)
1 x Control horn long w/ball
1 x Blade holder upper
1 x Cable with accesories
1 x Stainless steel cable Ø 0.5 mm (10 m)
1 x Horn 6/20 with M3 Bearing
2 x Covered closure or fairings
1 x Tube support Ø 6mm (10 pcs)
1 x Support conector MPX (6 pcs)
1 x Pin type hinge Al 6x98 mm (2 pcs)
1 x Fast'n EZ-CA-Hinge (12 uds)
1 x Support Flush MPX Conector (6 pcs)
1 x Recessed MPX connector support (6 pcs)
1 x 67 mm cylidric hinge Ø 5 mm (4 pcs)
1 x Soporte grifo FESTO vertical (1 pcs)
1 x Nylon hinge 20x20x0,3 (10 pcs)
1 x Gates hinge black 30x16 mm (2 pcs)
1 x Large flex hinge (12 uds)
1 x Support FUEL DOT V3
1 x Motor DLE 55 cc
1 x 45 mm white plastic spinner for fixed propeller / 4,0 mm axi
1 x Carburator Moki S250
1 x Captador RCEXL para DA
1 x ZENOAH/ZG 20cc
1 x 42 mm white plastic spinner for fixed propeller
1 x UMS radial-engine, 7 cylinder 90ccm, gas
1 x Exhaust gasket Valach 85
1 x 50 mm gas motor standoff
1 x Oils Pumps Empty (1 liter)
1 x Motor Saito FG-14, 13,47 cc
1 x Motor Saito FG-60 R3, 60 cc
1 x Gasket set DLE-20
1 x DLE 30 complete electronic ignition
1 x Piston ring EME 35cc
1 x Gasket set DLE-120
1 x DLE Ignition 111/120/170
1 x DLE 55-RA Muffler
1 x Motor EME 60 cc
1 x O-ring Saito FG-73 5cyl
1 x CDI EME 120cc
1 x Escape DLE-60 Dcha
1 x Servo HITEC HS-5125 MG Slim Metal Gear Wing Servo
1 x Horn 20x28,5 mm (2 pcs)
1 x Micro flex hinge (12 uds)
1 x Cap closure 33/23.5mm (2 uds)
1 x ROBART POINT HINGE 4,7mm (5 pcs)
1 x SAVOX SH 0255 MG servo
1 x Propeller Pleg CAM Carbon 10x4
1 x Propeller Pleg CAM Carbon 13x10
1 x Propeller Pleg CAM Carbon 11x8
1 x Propeller Pleg CAM Carbon 14x8
1 x Support pump Xicoy X45
1 x Miniature brass strap hinge, 1 m
1 x Pin type hinge Al 4,5x70 mm to wire (2 pcs)
1 x Flap hinge 33x9 mm (6 pcs)
1 x Spinner NUT M5
1 x 20cm Flexible Stainless Steel Exhaust Tubing D=25mm
1 x 45 mm gas motor standoff
1 x 10 mm gas motor standoff
7,922.56EUR
Manufacturers
Manufacturer Info
Roi-Import
Roi-Import Homepage
Other products
Languages
Español English
Currencies