18.00EUR

BATTWIN BATTERY REDUNDANCY SYSTEM
[SETBATTWIN]


BaTTwin was designed specifically for large RC models. It allows to use two identical batteries as the main power for the receiver and servos. Its main task is to diversify and power redundancy, thereby significantly reducing the risk of control loss in the case of failure of one battery or power pack. It should be added that BaTTwin it self also has two independent and redundant power circuits.

The device continuously monitors voltage level of both batteries and always charged the one with the higher momentary voltage - switching between battery is unobtrusive and cyclically without interruption to the power supply even at high power consumption. In case of use the same batteries they will be discharged simultaneously. The use of such two batteries for example. Lipo 7.4V 2200mAh - results that there is 4400mAh available for flight.

Protection against:
-In the case of an internal short-circuit in one battery, or contact one of the input side of BaTTwin (eg in a switch, or frayed wires). The receiver will constantly receive power from the second battery. Switching occurs transparently and without any interruption to the power supply and servos. However, in the case of short-circuit the battery, it is possible to catch fire of the battery. Shorting a one battery WILL NOT AFFECT efficient of a second battery.
-In case of failure of one battery (sudden voltage drop, or reduction in the capacity of the old package) receiver will constantly receive power from the second battery, switching takes place in a way that is not noticeable and without interruption to the power supply and servos.
-In case of disconnection of one battery (failure or malfunction in switch contacts). The receiver will continually receive power from the second battery, switching takes place in a way that is not noticeable and without interruption to the power supply and servos.
-Protection when connecting the battery in reverse polarity. There will be no voltage at the BaTTwin outputs.

Other functions
– BaTTwin has NO POWER CONSUMPTION in standby mode,
– designed primarily for high voltage receivers and servos (standard HV voltage 7.4V),
– possible to use with voltage regulator if necessary,
– prepared for additional chargin wires setup,
– high current capability up to 2x10A,
– wide range input voltage.


temporarily out of stock
temporarily out of stock

Reviews
We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Hovercraft sailcloth
1 x Parachute PV6 for F3J
2 x Paramotor Trike XL
1 x Para-RC "RC-Evo-Cross" Rescue
2 x Parachute P4
1 x Windsock Ozone L - 700 mm
1 x Paramotor BackPack XXS 2
1 x Paramotor Kit Camo H1.5/ Ben Red
1 x LUCAS pilot ARTF
1 x ABS I Strip 10x5x1000 mm
1 x 38x4,5 mm wires output (2 pcs)
1 x Aluminium M2x12 mm screw (4 pcs)
1 x ABS Strip 1.5x2.0x1000 mm
1 x 800TVL CMOS camera for FPV
1 x Round Rod 3,0x1000 mm
1 x Opale Rucksack
1 x Para-RC Mix
1 x Windsock Ozone L -1200 mm
1 x Servo Arm aluminium ALU-STAR
1 x Receiver Crystal 35 Mc/s Ch 62
1 x Crystal RX 35.120 Ch 72
1 x Crystal TX 35.150 Ch 75
1 x ABS Strip 1.0x3.0x1000 mm
1 x Extra-long adjustable aluminium control horn 2,8x34
1 x Strip 3,5x1,75x330 mm
1 x Brass hexagonal rod Ø 5 mm x 1000 mm
1 x Anodized aluminium servo M4x5/8 screw (4 blue pcs)
1 x 20 mm carbon horn
1 x Brass control horn M4 short for wire (4 pcs)
1 x Blind nut M6 (4 pcs)
1 x SE Ring HACKER 300 mm (2 pcs)
1 x Anodized aluminium M3x0,5x20 mm Sokect Head screw (4 lilac pcs)
1 x Optical RPM Sensor
1 x Aluminium wide washer M3 blue (4 pcs)
1 x Aluminun wheel collar 5 mm Ø (4 uds)
1 x Horn micro type4 Ø 0,5 (2 pcs)
1 x Connectors DEANS (T)
1 x Connectors banna gold 5,5 mm (M/F)
1 x Interface Jack Adapter IKARUS
1 x ABS Strip 1.0x2.0x1000 mm
1 x XH male balance (4S) connector (2 pcs)
1 x Glases Innovation Plus
1 x Cable grommet 9.5 mm (4 uds)
2 x Glases Moritz
1 x Blind nut M3 (4 pcs)
1 x ABS Strip 1.0x4.0x1000 mm
1 x Brass control horn M2 large for wire (2pcs)
1 x XH female balance (2S) connector (2 pcs)
1 x 15 mm floating pad (30 pcs)
1 x Horn DU-BRO 1/2 (2 pcs)
1 x ABS Strip 1.5x3.0x1000 mm
1 x Straightened threaded rod M3 - 1m
1 x Nose OPTIMA 2.200 mm (Elec or Glider)
1 x Propeller POWER-PROP 7x7
1 x Crystal Universal RX 35.140 Ch 74
1 x Indoor Brushed motor kit
1 x 
1 x Servo FUTABA S 3072 HV S-Bus
1 x SERVO DES 588 BB MG
1 x SERVO S9177SV HV S-Bus2 Programable
1 x Futaba 3010 - Gear Set
1 x Futaba S3010 Servo - Standard BB 0.16s/6.5kg
1 x SERVO DES 707 BB MG, Pignons
1 x Servo FUTABA BLS 272SV
1 x Servo FUTABA BLS 276SV
1 x Servo FUTABA BLS173 SV
1 x SERVO DES 806 Pignons
1 x Servo HBS 690BB HV Digital
1 x Futaba 25 mm servo arm with ball link
1 x Bag connector 2 mm
1 x Conector BEC female (10 pcs)
1 x Conector FUTABA Servo male (10 pcs)
1 x Futaba 14/20 mm servo pull-pull double arm with ball link
1 x Conector AS150 7mm antichispazo (Set: 2 pares)
2 x EasyFLY Addon
1 x 2000A 12V Lithium Jump Starter with 150PSI Air inflator
1 x Wing OXY 0,5 pulgadas2
1 x SERVO HOLDER
1 x Tornillo cabeza boton M4x12 mm (5 pcs)
1 x Strip 2,5x1,25x330 mm
1 x Tapping Screw M2.9x9.5 (10 pcs)
1 x SERVO DES 707 BB MG
1 x Programador FUTABA USB CIU-3
1 x Servo FUTABA HPS-A700 Digital S-Bus
1 x Futaba BLS255/272/471SV - Gear Set
1 x Soporte metal para servos
1 x Servo FUTABA BLS172 SV
1 x Futaba S9650/9670SV - Upper Case
1 x SERVO DES 658 BB MG
1 x Futaba BLS152 - Upper Case
1 x Servo FUTABA BLS175 SV
1 x Servo FUTABA S 9670 SV
1 x USB Interface REVOLECTRIX for CellPRO 10s
1 x SERVO DES 568 MG
1 x Servo FUTABA S 3071 HV S-Bus
1 x Truck-trailer for gliders 720 x 239 mm
1 x Conector JAPAN G2 Set 5 pares
1 x Angle measurer
1 x Conector JR/Uni Servo male BLUE silicon (10 pcs)
1 x 17 mm servo arm with ball link DES Graupner
1 x Adapter rotula M3
1 x Futaba 76/92 mm servo pull-pull double arm with ball link
1 x Surface Indicator Gauge Small
1 x 9x4.7 * 22x12 carbon propeller
1 x Motor A30-12 L V4
1 x Motor A60-7XS V4 28-pole kv330
1 x Tow hook for tug
1 x Motor A50-12 L V4
1 x Ferrita 14x8x5.5 mm
1 x Motor A40-10 L V2 14-Pole Glider
1 x Motor A20-6 XL 10-Pole EVO + 4,4:1
1 x ABS I Strip 20x10x1000 mm
1 x Round Rod 2,0x1000 mm
1 x Esc KOSMIK 200+ HV
1 x Circlik for shaft 3.2 mm (10 pcs)
2 x Blind nut M5 (4 pcs)
2 x Baseplate servo
1 x Spring lock washer 4.1 mm (20 pcs)
1 x Screw M2.5x10 (10 pcs)
1 x Glases Nimbus "Black"
2 x Zurich Sport Sunglasse Dark Sensity BROWN Glasses
1 x Screw M2x6 (10 pcs)
7,472.42EUR
Manufacturers
Manufacturer Info
Setlo
Setlo Homepage
Other products
Languages
Español English
Currencies