40.00EUR

NF-3m Heli Kit
[NF-3m Heli Kit]


The NF-3m Heli Kit is unit with cables and LEDs ready to install into an indoor helicopter. Length of cables correspond to models like EasyCopter, Blade or Lama. There are 6 lights (LEDs 3mm) installed : two position lights (Red and Green), two flashing lights (Red and White) and two landing lights (White).

NF-3m Heli Kit has cable into a receiver. This is ready to work with helicopters having a free channel to control the lights by a pilot. Operational voltage is expected by BEC, typical voltage is 5,0 V. Works from 4,5 V to 5,5 V.

The circuit is to be connected with a Graupner or Hitec connector directly to the receiver, being supplied with a voltage of 5V and with BEC circuit tolerance. The circuit has no other protection against reversed polarity than a connector lock. Diodes are supplied with this voltage. The output conntacts have a joint positive pole. Each output can be connected with one diode.
The F1 and F2 circuits (see manual) flash with one second period. Using three jumpers ( 1, 2, 4 ), one of the eight preset flashing combinations can be achieved i.e. one, two or three separated flashings. You can set the order number of the combination from 0 to 7 by means of the jumpers as follows: all jumpers, when disconnected, sum up to 0. The sum of number of the connected jumpers represents the number of the selected combination.

The unit NF-3m can also be connected as an uncontrolled unit when disconnecting the orange signal contact on the connector on the receiver. This can be either cut off or you can gently try to lift the lock on the connector and pull the contact out of the connector. Then isolate against touching by chance. If necessary, you can always push the contact back again. When connecting the unit as an uncontrolled one (without the orange contact) the position and the flashing lights are permanently switched on and the jumper "2p/3p" switches the landing lights.

The total average current consumption by all lights on is between 12 mA from a BEC. During 10 minutes of fly the light circuits burn only a little bit more than 1 % of capacity of a 700 mAh accumulator. Position and number of the installed LEDs depends on your own decision. However, you should keep in mind that, according to conventions, position lights are correspond with the green diode on the right and the red one on the left, in the flying direction. Usually the flashing light on the body is red and on the tail is white.

The NF-3m, besides control circuit, includes 1x3 mm 10 mAh green LED, 2x3 mm 10 mAh red LEDs and 3x3 mm 10 mAh white LEDs


temporarily out of stock
temporarily out of stock

Reviews

Customers who bought this product also purchased
Servo slow down unit (0,7-14,7 sec )
Servo slow down unit (0,7-14,7 sec )

temporarily out of stock
temporarily out of stock

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x EXTRA NG 74" white/red/blue (Skywing RC)
1 x Extension MPX-MPX 20 cm
1 x EXTRA NG 74" yello/blue/red (Skywing RC)
1 x Conector MR-60 (pareja)
1 x Servo GO-1035MG 16 kg.cm 0.08s/60º
1 x Crimping tool
1 x Nylon hinge for flaps/gates 27x10,5 (2 pcs)
1 x Vacuum sealing tape, 2.5 x 12 mm (up to 140 °C) 15 m
1 x A/C quality beech plywood 1520x750x4.0 mm
1 x Pilatus PC-21 50E, GLOW set conversion (SebArt)
1 x Avanti S Jet , Exhaust for JetCat P-140 (SebArt)
1 x Long pinned hinge (12 uds)
1 x PROPELLER ELECTRIC glass 9,5x6
1 x A/C quality beech plywood 600x300x0.8 mm
1 x Extension silicon 100 cm (Futaba)
1 x BALSA trip 3.0x5.0x1000 mm
1 x Motor OS 3820-1200 electric
1 x Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH
1 x USB Mini Camera endoscope
1 x BULL MØ1 2.600mm "AeroPANDA"
1 x OPUS-V / Jet-CC-BF
1 x Extension S-Bus 1-2 silicon 120 cm FUTABA
1 x Skyray (RBC Kits)
1 x DRACO 2.0m Helice 14.5x9 4-Blade
1 x Pilatus PC-21 50E, wings carrying bags (SebArt)
1 x Circlick securite
1 x Cylidric hinge 43 mm Ø 2,5 mm (5 pcs)
1 x ABS tube 8.0x6.0x1000 mm
1 x 200 mm extensión servo HITEC/JR
1 x Brass hexagonal rod Ø 3 mm x 1000 mm
1 x ABS tube 10.0x8.0x1000 mm
1 x Aluminium tube (L 1000 mm, Ø5.0 mm, Ø4.1 mm)
1 x Extension 90 cm (Futaba)
1 x Straightened rod Ø 5.5 mm x 1000 mm
1 x Ventus 1:4 set of instruments
1 x Avanti XS Jet , Fuselage Stand (SebArt)
1 x Extension silicon 30 cm male (Futaba)
1 x Carbon fibre tape 125 g/m², 3k, UD (25 mm) roll/ 10 m
1 x AIREX® Sheets C 70.55 (YELLOW) 1200x550x6.0 mm (5 pcs)
1 x Miss ULTIMATE 50E Red/Black
1 x Avanti S Jet , Field folding model stand (SebArt)
1 x Pin type hinge Al 3,0x50 mm (2 pcs)
1 x A/C quality beech plywood 600x300x8.0 mm
1 x BALSA trip 3.0x3.0x1000 mm
1 x Propeller electric carbon 10x8
1 x 1/12 Pilot "Fighter"
1 x BALSA triangular 6x6x1000 mm
1 x Avanti XS Jet , Tank for Keroseno (SebArt)
1 x 4 LiPo XH>EH adapter
1 x Cessna SKYLANE T182 1.75m - Seagull Model
1 x Propeller electric carbon 9.5x6
1 x CM-3
1 x Straightened threaded rod M2-1m
1 x Sun Cover BULL Mo1 2.6 (Hispano Aviacion)
1 x DC-3 Douglas (DAKOTA) 1800 mm
1 x Pilot "Goose" (Slimline)
1 x Cable S.BUS 3 salidas 100 mm
1 x CC 05
1 x Cable servo PREMIUM MAXI 200m (blanco/rojo/azul) PVC
1 x Nylon hinge 15x0,3 (10 pcs)
1 x DORNIER DO 335 EP ARF 1724 mm
1 x Xplorer1 anemometro
1 x Small pinned hinge (12 uds)
1 x WINGO 2 ARF
1 x BALSA trip 10x10x1000 mm
1 x BULLIT Wing 1095 mm
1 x 67 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs)
1 x BALSA triangular 10x10x1000 mm
1 x Avanti S 1.8m Jet FREECE TRICOLORI + Landing gear
1 x Cable silicona macho batt. receptor 30 cm (Graupner)
1 x White silicone 0,25 qmm wire (100 m)
1 x DRACO 2.0m landing gear
1 x FIALA Propeller 19x12 Electric
1 x Propeller FIALA 15x8 3-Blade
1 x Balsa panel 10x100x1000 mm
1 x 8Wx2 Gears-Spotlight, UltraPower, 20mm White
1 x Propeller CFK 14x10
1 x XH 30 cm Male extension 0,25 mm2 silicone cable for 2 cell
1 x Protective Cover for wires Ø 20 mm 1000 mm
1 x Cable set PREMIUM Maxi, SUB-Done 4three fuselage/wing 200 cm
1 x Propeller CFK 20x13
1 x Extension silicon 30 cm male (Graupner)
1 x Extension silicon 10 cm (Graupner)
1 x FIALA Propeller 23x8 Electric
1 x Sun Cover ULTIMATUM 2.0 (Hispano Aviacion)
1 x Sun Cover PC 21 XXL (JMB Jets)
1 x Hitec 20 mm servo arm
1 x Futaba 50/60 mm servo pull-pull double arm with ball link
1 x Balsa panel 4.0x100x1000 mm
1 x Balsa panel 8.0x100x1000 mm
1 x Futaba 25 mm servo arm with M3 ball link
1 x A/C quality beech plywood 600x300x1.5 mm
1 x Motor XPOWER F2919/10 F5J Light
1 x Extension silicon 30 cm female (Graupner)
1 x Camera Sony 4140+673 CCD with Built-in 200mw TX + antenna
1 x XH 30 cm Male extension 0,25 mm2 silicone cable for 5 cell
1 x Pilatus PC-21 50E BLUE/WHITE (SebArt)
1 x Extension silicon 100 cm (Graupner)
15,374.22EUR
Manufacturers
Manufacturer Info
Night Fly
Night Fly Homepage
Other products
Languages
Español English
Currencies