| 1 x | T-Motor U7-V2.0 Kv420 |
| 1 x | T-Motor MN705-S Kv125 (pack 2 uds) |
| 1 x | Camera Sony 4140+673 CCD with Built-in 200mw TX + antenna |
| 1 x | Pilot "Adolf" Legends Series (Slimline) |
| 1 x | Pine wood slat 2.0x10.0x1000 mm |
| 1 x | Aluminium wide washer M4 Blue (4 pcs) |
| 1 x | Threaded coupler ALU M3 Ø 4 (2 uds) |
| 1 x | ABS I Strip 20x10x1000 mm |
| 1 x | BALSA trip 5.0x5.0x1000 mm |
| 1 x | Round Rod 1,0x1000 mm |
| 1 x | ABS angle 10,0x10,0x1000 mm |
| 1 x | |
| 1 x | ABS Strip 1.5x4.0x1000 mm |
| 1 x | Flat washer 1.7 mm (20 pcs) |
| 1 x | ORACOVER Fluor red (2 m) |
| 1 x | Civilian pilot "Curt" size 9cm (Slimline) |
| 1 x | Silicone adhesive ELASTOSIL® E4, tube/ 90 ml |
| 1 x | Horn 16,5x20 mm (2 pcs) |
| 1 x | BALSA triangular 8x8x1000 mm |
| 1 x | Carbon fiber rod 16 mm x 1000 mm |
| 1 x | 68 mm PVC transparent battery termo-retract 68 mm (1 m) |
| 1 x | ABS Strip 1.0x4.0x1000 mm |
| 1 x | Horn 6/27 with M3 Bearing |
| 1 x | Couple M4 for wire (10 pcs) |
| 1 x | Beech dowels 3.0 x 1000 mm |
| 1 x | Militarian pilot "Kamikaze" size 9cm (Slimline) |
| 1 x | Linden wood slat 2.0x2.0x1000 mm |
| 1 x | 1/10 Pilot "Jack" |
| 1 x | L-Connector 1.5 mm x 1000 mm |
| 1 x | LOWER TOW HOOK |
| 1 x | Pine wood slat 10x10x1000 mm |
| 1 x | Carbon fiber rod 1.5 mm x 1000 mm |
| 1 x | Horn 20x28,5 mm (2 pcs) |
| 1 x | Aluminium coupler M2,5/2 with ball bearing (1 pcs) |
| 1 x | Liston HAYA 8 x 8 x 1000 mm |
| 1 x | Quicklock washer 2.5 mm (10 pcs) |
| 1 x | Pine wood slat 3.0x5.0x1000 mm |
| 1 x | BALSA trip 8.0x8.0x1000 mm |
| 1 x | Strip ABS 2.0x5.0x1000 mm |
| 1 x | Joint with bearing M2,5 22x5,5 |
| 1 x | Threaded coupler ALU Left M2,5 Ø 3 (2 uds) |
| 1 x | Aluminium wide washer M4 Red (4 pcs) |
| 1 x | 800TVL CMOS camera for FPV |
| 1 x | 4 mm M3 red control terminal (4 pcs) |
| 1 x | Pilot JAN 1/4 Saiplanes |
| 1 x | ABS I Strip 10x5x1000 mm |
| 1 x | M3-M4 rubber washer (8 pcs) |
| 1 x | Kwik link AL M3 L:30 mm (2 pcs) + Pin Ø 2,0 mm |
| 1 x | ABS angle 2,0x2,0x1000 mm |
| 1 x | Ball link duraluminium M3 V1 (10 pcs) |
| 1 x | ABS angle 6,0x6,0x1000 mm |
| 1 x | Clevis plastico I=30 mm / hole 2.5mm / pin 1 (2 pcs) |
| 1 x | Threaded coupler ALU M2 Ø 4 (2 uds) |
| 1 x | Aluminium cap bolt washer M4 red (8 pcs) |
| 1 x | Round Rod 3,0x1000 mm |
| 1 x | Carbon fiber rod 10 mm x 1000 mm |
| 1 x | Profile ABS half cane 4x2.5x1000 mm |
| 1 x | Spray Graphit 33 |
| 1 x | Ball link M3 (10 pcs) |
| 1 x | 1/12 Pilot "Cougar" |
| 1 x | Spray adhesive INFUTAC (Clear) 500 ml |
| 1 x | 6,4x1000 mm 2:1 black termoretract tube |
| 1 x | Long ball link M3 (6 uds) |
| 1 x | Quicklock washer 3 mm (10 pcs) |
| 1 x | Monokote BLANCO jet (1.8x0.65m) |
| 1 x | Carbon fiber rod 5.0 mmx1000 mm |
| 1 x | Circlik for shaft 1.5 mm (10 pcs) |
| 1 x | 58 mm PVC transparent battery termo-retract 68 mm (1 m) |
| 1 x | Short ball link M3 (6 uds) |
| 1 x | Circlik for shaft 2.3 mm (10 pcs) |
| 1 x | Spring lock washer 2.6 mm (20 pcs) |
| 1 x | 20 mm carbon horn |
| 1 x | 6 mm ball link M3 (10 pcs) |
| 1 x | BALSA trip 4.0x4.0x1000 mm |
| 1 x | Civilian pilot "Joe" size 9cm (Slimline) |
| 1 x | Trailing edge BALSA 35x8x1000 mm |
| 1 x | Profile ABS half cane 4x1000 mm |
| 1 x | ABS "T" angle 2.0x2.0x1000 mm |
| 1 x | 12,7x1000 mm 2:1 green termoretract tube |
| 1 x | 1/6 Pilot "Garry" |
| 1 x | Ball link M1.6 (6 uds) |
| 1 x | Carbon rectangular rod 10.0 mm x 1.0 x 1000 mm |
| 1 x | Carbon rectangular rod 3.0 mm x 1.0 x 1000 mm |
| 1 x | Carbon fiber rod 7.0 mmx1000 mm |
| 1 x | 1/6 Pilot "John" |
| 1 x | 3,2x1000 mm 2:1 red termoretract tube |
| 1 x | Spray YELLOW Inca Lexan 150ml |
| 1 x | Small aluminium horn blue (2pcs) |
| 1 x | Nitroverdu 500 ml |
| 1 x | Carbon fiber rod 0.8 mmx1000 mm |
| 1 x | M3 INDUSTRIAL ball link (2 uds) |
| 1 x | Spray EC Red 400ml |
| 1 x | Circlik for shaft 1.9 mm (10 pcs) |
| 1 x | 500 ml sealer (DOPE) |
| 1 x | Joint with bearing M3 22x5,5 |
| 1 x | M2/M1/6 3Diam short black ball link V1 (6 pcs) |
| 1 x | Release wax 250ml |
| 1 x | 105 mm PVC transparent battery termo-retract 68 mm (1 m) |
| 1 x | Truck-trailer for gliders 720 x 239 mm |
| 1 x | Round Rod 6,0x1000 mm |
| 1 x | Oracover Brown 2 m |
| 1 x | Lock washer 2.2 mm (20 pcs) |
| 1 x | Walnut wood slat 2.0x2.0x1000 mm |
| 1 x | BALSA trip 2.0x2.0x1000 mm |
| 1 x | Truck-trailer for gliders 720 x 285 mm |
| 1 x | Carbon fiber rod 4.0 mmx1000 mm |
| 1 x | ABS "T" angle 8.0x8.0x1000 mm |
| 1 x | ABS Strip 1.5x6.0x1000 mm |
| 1 x | 2,4x1000 mm 2:1 red termoretract tube |
| 1 x | Paint gun for sprays |
| 1 x | Quicklock washer 4 mm (10 pcs) |
| 1 x | Carbon fiber rod 6.0 mmx1000 mm |
| 1 x | ABS "T" angle 6.0x6.0x1000 mm |
| 1 x | Carbon fiber flat 1000x6.0x0.8 mm |
| 1 x | Futaba Female 40 cm extension |
| 1 x | Carbon tube (L 1000 mm, Ø1.5 mm, Ø0.7 mm) |
| 1 x | Carbon tube (L 1000 mm, Ø16 mm, Ø12 mm) |
| 1 x | Slave-cable USB Easy Sim |
| 1 x | Sun Cover BULL Mo1 2.6 (Hispano Aviacion) |
| 1 x | SIMtransmitter 6 Mode 2 |
| 1 x | ABS tube 6.0x5.0x1000 mm |
| 1 x | Carbon tube (L 1000 mm, Ø16 mm, Ø14 mm) |
| 1 x | Carbon fibre tube -TAPERED- 3k-PW (10 x 5 x 0.3) x 880 mm |
| 1 x | Vasa model Catapult |
| 1 x | ABS tube 20.0x18.0x1000 mm |
| 1 x | Carbon tube (L 1000 mm, Ø12 mm, Ø10 mm) |
| 1 x | SE Ring 350 mm (2 pcs) |
| 1 x | 13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
| 1 x | SE Ring 480 mm (2 pcs) |
| 1 x | Foil for sticking flaps and ailerons |
| 1 x | RUDDOG Protection and Heat Shield Tape (2mx50mm) |
| 1 x | SE Ring 240 mm (2 pcs) |
| 1 x | SE Ring 300 mm (2 pcs) |
| 1 x | SE Ring 250 mm (2 pcs) |
| 1 x | Pad Screw Mount M3, up to 3mm / 0.12″, (10 pcs) |
| 1 x | 20x1000 mm Ring Strap Back To Back |
| 1 x | VITAPROP CARBON FOLDING PROP 15x9.5" |
| 1 x | MULTIPLEX - TUNING SPINNER (67MM) FOR MULTIPLEX FUNRACER |
| 1 x | PowerBox 12 |
| 1 x | Extension for SensorSwitch 60cm |
 |
| 2,472.91EUR |
