Top » Catalog » Hardware » BEC/Cables/Conectors/Interruptor » ROI142KS

15.06EUR

Opto Gas Engine Kill Switch
[ROI142KS]

This kill switch is Optically Coupled to isolate your ignition system from your radio system. (No Interference!!) this device features the following:

•Includes a remote mountable bright LED to indicate when the ignition is armed.
• Optically Coupled input/output is Isolated.
• 8 Bit PIC Controller.
• Li-Po/Li-Ion/A123/Ni-Mh/NiCad Input.
• Up to 20 Volt 15 amp MOS-FET output.
• DSP Noise/Loss of signal Filtering.
• PPM-PCM 2048 – 1024 & 2.4Ghz Interface Support.
• Low Voltage Drop – Less than 150mv.
• 100% Surface Mount Technology.
• Heavy Gauge Wires, universal connectors.
• Small and light weight – only 12 Grams!

This device plugs into a spare receiver channel.

This is a must have safety device for any gas powered plane! This device allows you to safely kill your engine at anytime (on the ground, or inthe air!)

few units

Reviews

Customers who bought this product also purchased

Cylidric hinge 33 mm Ø 2 mm (5 pcs) few units	MPS Gas-Cap-Powerswitch few units	Propeller MENZ-S 17x10 few units
Propeller MENZ-S 18x12 few units	Tacometer mini ignition RCEXL few units	Cyano SUPER - GOLD™ (12g) few units

Categories

* OFFER MONTH *
Planes->
Sailplanes->
Autogyros->
Helicopters->
UAVs - RPAs->
Multicopters->
Hardware->

  3D IMPRESION
  ABS Rods-Strips
  ABS/GFK/CFK plate
  Actuator
  Adapters->
  Adhesives/Resin/Epoxy->
  Altimeters->
  Amperimeters
  Anemometer
  Auto-Pilot
  Bags/Covers
  Batteries->
  BEC/Cables/Conectors/Interruptor
  Bungee Launchers
  Cables
  Cameras->
  Carbon rod
  Carbon/Brass/Steel/ABS/Aluminium
  Catalogues
  Chargers->
  Clevis
  Combustible->
  Connectors
  Control horns
  Controlers->
  Coverings/Thermoretrac
  Decals
  Extension
  Extinguisher
  Ferritas
  Glasses
  Hardware
  Hinges
  Instruments / Panels
  Lights/Ilumination->
  Linkages
  Merchandising
  Motor
  Pilots
  Pinion extractor
  Power supply system/Data Recordi->
  Profiles
  Propelers->
  Screws
  Servos->
  Simulators
  Smoke/Rocketry/Fireworks
  Spinners->
  Spray/Painting/Dope/Solder Paste
  Steel/brass Rod/Aluminium
  Support/CG/Incidenc.
  Tapes/Closed/Bridles
  Tools
  Towing
  Transmitters/Receivers->
  Undercarriage->
  Wheels & Axles->
  Wing Joiner
  Wood
Car/Trucks->
Motors & Turbines->
Gas. Motor Paramotors
Acces. for Motors->
Paragliders/Parachutes/Windsock
Boats/Naval units->
FPV->
Robots->
CNC cut
Roof BOX
Crash kits
Outlet Zone->
Used
Merchandising HA

What's New?

Beaver DHC-2 DeHavilland 3000mm White/Black CYMODEL
975.02EUR

Information

Shipping & Returns
Privacy Notice
Conditions of Use
Financing
Point Program FAQ
Contact Us

We Accept

Quick Find

Shopping Cart

1 x	Connectors banna oro 8,0 mm 5 pcs(Female)
1 x	Threaded coupler ALU Left M2,5 Ø 3 (2 uds)
1 x	Cable control set
1 x	Cable silicona macho batt. receptor 30 cm (Graupner)
1 x	Extension 30 cm (Futaba)
2 x	Threaded coupler ALU M2,5 Ø 3 (2 uds)
1 x	LH long aluminium horn L31xH30 (2pcs)
1 x	RH long aluminium horn (2pcs)
1 x	Threaded coupler ALU Left M2,5 Ø 4 (2 uds)
1 x	Canopy Lock V1 M3 Blue (2 pcs)
1 x	2 mm female connector (2 pcs) with safety connector
1 x	0,14 mm PVC servo wire extension, ZH micro conector.
1 x	Stainless steel cable Ø 0.62 mm (10 m)
1 x	Brass control horn M4 short for wire (4 pcs)
1 x	Banna gold connector 2,5 mm (100 M/F pairs)
1 x	Connectors banna oro 2 mm (M/F)
1 x	Extension 15 cm (Futaba)
1 x	Horn 13,5x16 mm (2 pcs)
1 x	Screw-lock pushrod conn snap Ø 1.5 mm (2 uds)
1 x	Connectors banna oro 3 mm (M/F)
1 x	XH male balance (4S) connector (2 pcs)
1 x	Screw-lock connector Ø 2 mm (2 uds)
1 x	Horn 6/20 with M3 Bearing
1 x	Canopy Lock V1 M3 Red (2 pcs)
1 x	Cockpit plastic closing
1 x	Extension S-Bus 1-2 silicon 30 cm FUTABA
1 x	Threaded coupler ALU M2 Ø 3 (2 uds)
1 x	Gold antispark 4 mm plug
1 x	Futaba Female 40 cm extension
1 x	Locking cable tie 4.6x203 (uds)
1 x	Connectors DEANS (T)
1 x	Support Pitot JETI
1 x	Tube support Ø 6mm (10 pcs)
1 x	Stainless steel cable Ø 0.5 mm (10 m)
1 x	Crimping sleeves for cable 0.70 mm (10 pcs)
2 x	XH male balance (3S) connector (2 pcs)
1 x	Support Antena 2.4 Ghz (2 pcs)
1 x	Tube Pitot to PIXHAWK
1 x	CNC FPV Display screen&Transmitter Holder Vertical
1 x	ESC ALPHA 60A HV
1 x	T-Motor MN705-S Kv125 (pack 2 uds)
1 x	PIX Hawk with accesories
1 x	Digital Air Speed Sensor And Pitot Tube Set
1 x	Spinner Alumin. fixed propeller 40 mm / 4,0 mm
1 x	Spinner NUT M4
1 x	Spinner Alumin. fixed propeller 40 mm / 5,0 mm
1 x	Spinner NUT M6
1 x	Spinner NUT M5
1 x	Spinner NUT M6
1 x	Spinner Alumin. fixed propeller 30 mm / 3,2 mm
1 x	Spinner Alumin. fixed propeller 40 mm / 3,0 mm
1 x	XH male balance (5S) connector (2 pcs)
2 x	Banna gold connector 2,5 mm (M/F)
1 x	Fully Threaded Steel Rod Duralumin 40 mm M3 (2 pcs)
1 x	Small aluminium horn red (2pcs)
1 x	Fully Threaded Steel Rod alumin 70 mm M3 (2 pcs)
1 x	Propeller 10x4,7 SlowFlyer
1 x	Propeller APC 13x4 Electric Pusher
1 x	Propeller 8x4 Electric
1 x	Connector CAN 15
1 x	XH male balance (2S) connector (2 pcs)
1 x	Wing connector 8pin with pin strip, plug & socket
1 x	Conector JR Servo female (10 pcs)
1 x	Soporte carbono MR30 (2 pcs)
1 x	Conector FUTABA Servo male BLUE silicon (10 pcs)
1 x	XH female balance (9S) connector (2 pcs)

1,371.18EUR