133.50EUR

Rainbow Autogyro
[MEGARAIN]



Aut. Rainbow con 4 palas

Aut. Rainbow con 4 palas

Aut. Rainbow con 4 palas

Aut. Rainbow con 3 palas

Aut. Rainbow con 3 palas

Aut. Rainbow con 3 palas
Autogyro was first built in 1923 by Spanish engineer Juan de la Cierva. Its development went on during thirties and in Second World War II was used in armies usually for observation purposes. In Czechoslovakia was then flown by Bata company.
Autogyro model RAINBOW is designed for model builders who has basic experiences with motor modelc comntrolled by elevator and rudder (or ailerons). No problems with starts form hand or grassy field. Landing si easy even with autogyro flying only with autorotation. Thanks to relatively big rotor diameter is flying very straightforward. In the air you can handle situations in which other models would be practically lost. Side movements of autogyro RAINBOW are made by rotor tilt. Elevator works well in the whole range of speeds and in autorotation mode allows almost vertical and very slow landing. For trasportation of autogyro it is possible to turn rotor blades back over the airframe (by slackening of two blade bolts)
Flying time varies from 10 to 20 minutes (battery 3xLion,1350mAh , motor MEGA RC 400/15/7, propeller APC10x5 E). You can use rechargeable batteries with both higher or lower capacity.
It is absolutely necessary to take off and land against the wind!

Available Options:

Combos:



temporarily out of stock
temporarily out of stock

Reviews

Customers who bought this product also purchased
3 blades set
3 blades set

temporarily out of stock
temporarily out of stock

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Futaba male 40 cm extension
1 x Extension silicon 30 cm female (Graupner)
1 x Extension silicon 10 cm (Futaba)
1 x Extension S-Bus 1-2 silicon 120 cm FUTABA
1 x Futaba Female 40 cm extension
1 x Extension silicon 75 cm (Futaba)
1 x Extension silicon 50 cm (Futaba)
1 x 0,14 mm PVC servo wire extension, ZH micro conector.
1 x Extension PVC 150 cm (Graupner)
1 x Cable silicona macho batt. receptor 30 cm (Graupner)
2 x Extension silicon 10 cm (Graupner)
1 x Cable silicona female batt. receptor 30 cm (Futaba)
1 x Extension silicon 50 cm (Graupner)
1 x Extension silicon 25 cm (Futaba)
1 x Cabel "Y" 30 cm (graupner)
1 x Extension silicon 35 cm (Futaba)
1 x Extension silicon 100 cm (Graupner)
1 x servo adapter lead, JST-SH socket - JR male Pin, for GR-12SH+HoT
1 x Extension silicon 100 cm (Futaba)
1 x silicon 100 cm Futaba Extension Ø 0,35 mm
2 x Futaba Female 40 cm extension
1 x Pine wood slat 10x10x1000 mm
1 x BALSA triangular 15x15x1000 mm
1 x Pine wood slat 5.0x5.0x1000 mm
1 x Liston HAYA 8 x 8 x 1000 mm
1 x OBECHI sheet 2.0x3.0x1000 mm
2 x Mahogany wood slat 3.0x3.0x1000 mm
3 x BALSA trip 10x10x1000 mm
1 x Beech dowels 2.0 x 1000 mm
2 x Liston HAYA 10 x 10 x 1000 mm
1 x BALSA trip 3.0x3.0x1000 mm
1 x Pine wood slat 2.0x2.0x1000 mm
1 x Linden wood slat 3.0x3.0x1000 mm
1 x Beech dowels 10 mm x 1000 mm
1 x BALSA triangular 6x6x1000 mm
1 x BALSA trip 5.0x5.0x1000 mm
1 x Linden wood slat 2.0x2.0x1000 mm
1 x BALSA trip 4.0x4.0x1000 mm
1 x BALSA trip 2.0x2.0x1000 mm
1 x BALSA trip 2.0x10.0x1000 mm
1 x Walnut wood slat 3.0x3.0x1000 mm
2 x BALSA triangular 8x8x1000 mm
1 x Pine wood slat 2.0x10.0x1000 mm
1 x Mahogany wood slat 2.0x2.0x1000 mm
1 x Walnut wood slat 2.0x2.0x1000 mm
1 x Pine wood slat 3.0x7.0x1000 mm
1 x Ventus 1:4 set of instruments
1 x Circlick securite
1 x Extension silicon 30 cm male (Futaba)
1 x Extension silicon 35 cm male (Futaba)
1 x Tube Pitot to PIXHAWK
1 x Yellow smoke canister 65 g
1 x ABS tube 5.0x4.0x156 mm
1 x CF tube set (Ø 38 mm y Ø 14 mm)
1 x Civilian pilot "Curt" size 9cm (Slimline)
1 x Extension silicon 25 cm (Graupner)
1 x Blue metalic ball link M2/2 azul (2 pcs)
1 x Ball link M2,5 (10 pcs)
1 x 14x60 mm Mini rings Tie Wraps (4 pcs)
1 x Cable S.BUS 3 salidas 300 mm
1 x Carbon fiber rod 1.0 mm x 1000 mm
1 x Balsa panel 2.0x100x1000 mm
2 x A/C quality beech plywood 600x300x6.0 mm
1 x A/C quality beech plywood 600x300x5.0 mm
1 x A/C quality beech plywood 600x300x5.0 mm
1 x Beech dowels 3.0 x 1000 mm
1 x Birch plywood plate 600x300x1.5 mm
1 x Pine wood slat 6.0x6.0x1000 mm
1 x 3 LiPo XH>EH adapter
1 x PVC 0,25 qmm 4 line servos wire JR/Graupner (5 m)
1 x Cabel "Y" 30 cm (Futaba)
1 x Silicone 0,25 qmm servos wire Graupner (5 m)
1 x Silicone 0,50 qmm servos wire Futaba (100 m)
1 x Cabel charger transmitter GRAUPNER
1 x Black copper lacquer wire Ø0,2 mm (5 m)
1 x PVC 0,08 qmm Graupner servos wire (5 m)
1 x 3 copper lacquer wire Ø0,2 mm (1 m)
1 x 2 LiPo XH>EH adapter
1 x Cable Cargador FUTABA
1 x Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH
1 x Red copper lacquer wire Ø0,2 mm (5 m)
1 x Silicone 0,14 qmm servos wire Graupner (100 m)
1 x Aluminium ignition bad (blue)
1 x Selfstarr DLE55, EME55/60, DLA56, SE 55
1 x Propeller POWER-PROP 7x7
1 x Power MULTIlight
1 x 10 mm gas motor standoff
1 x 110x55 mm C SLH KOVO wheel
1 x Junta humo metalica G55 (DLE55/DLE111/DLE222)
1 x 115x29 mm (4.50") Type jets aluminium core wheel
1 x 200 mm extensión servo HITEC/JR
1 x 1/12 Pilot "Langley"
1 x 1/7 Pilot "Japanese"
1 x 1/10 Pilot "Jimmy"
1 x 120x60 mm C SLH KOVO wheel
1 x 1/10 Pilot "Jack"
1 x Compact on-board starting system (9715)
1 x GLOW 2C + accesories
1 x Exhaust elbow for SAITO FA65/72/80/82a/91S/100/
1 x 1/4 Pilot "Heidi"
1 x O-ring Saito FG-73 5cyl
1 x 1/12 Pilot "Cougar"
1 x 1/12 Pilot "Tom"
1 x "Taxi Tank" Fuel Tank
1 x 160 mm carbon undercarriage (2pcs)
1 x 1/6 Pilot "Garry"
1 x 101x28 mm (4.0") Type jets aluminium core wheel
1 x 152x46 Ø6.0 mm aluminium core wheel
1 x Opto Gas Engine Kill Switch
1 x BALSA triangular 10x10x1000 mm
1 x Red aluminium servo arm V2-Futaba 1,25" inch M3
1 x aluminium servo arm V2-JR 2,0 inch M3
1 x 50x45 mm micro-mini servo cover
1 x Servo TOPMODEL S7520 MG
1 x Rudder 2_Tray 4~4.5 inch
1 x Red aluminium servo arm V3-Futaba 1,0inch
1 x Red aluminium servo arm V1-Futaba 15 mm iM2
1 x Blue aluminium servo arm V2-Hitec 1,0 inch M3
1 x Rudder 2_Tray 4.5~5 inch
1 x Red aluminium servo arm V1-Futaba 20 mm M2
1 x Rudder 2_Tray 3.5~4 inch
1 x Red aluminium servo arm V3-Futaba 1,25inch M3
1 x Red aluminium servo arm V2-Futaba 2,0 inch
1 x Blue aluminium servo arm V1-Hitec 1,25" inch M3
1 x Blue aluminium servo arm V1-Hitec 1,0" inch M2
1 x Blue aluminium servo arm V2-Hitec 1,75" inch M3
1 x Servo Mount S (red)
1 x Red aluminium servo arm V2-Futaba 17 mm iM2
1 x Oracover light Grey 2m
1 x Monokote ROJO misil (1.8x0.65m)
1 x Tapping Screw M2.2x13 (10 pcs)
1 x Screw M3x30 (10 pcs)
1 x Screw M3x8(10 pcs)
1 x 13 mm wing servo holder
1 x Digital Air Speed Sensor And Pitot Tube Set
1 x 12,7x1000 mm 2:1 green termoretract tube
1 x 30 cm BEC cable (male)
1 x 135 mm PVC transparent battery termo-retract 68 mm (1 m)
1 x 5 LiPo XH>EH adapter
1 x 2,0x50 mm allen screwdriver
1 x 58 mm PVC transparent battery termo-retract 68 mm (1 m)
1 x 2 mm male connector (2 pcs) with safety connector
1 x 2,4x1000 mm 2:1 black termoretract tube
1 x Concave-Convex sandpaper file 13 mm
1 x Battery LiPo GRE18 600 mAh 7.4v
1 x 
1 x Ciano KAVAN Medium 20g
1 x Cable coupler M2 (10 uds)
1 x Connectors banna gold 5,5 mm (M/F)
1 x DPSI 2001 RV
1 x DPSI Micro SingleBat 5.9V/7.2V F3A Edition magnetic switch
1 x 45 mm aluminium spinner (Kavan)
1 x 150 mm inflatable superlight deluxe wheel (2 pcs)
1 x Birch plywood plate 600x300x1.2 mm
1 x Combustible Glow "KAVAN" air/heli 15% nitro
1 x Combo KAVAN PRO 3536-1000 + RAY 40 SB
1 x Connectors MPX 8 pins with support (black) 1 pair (male-female)
1 x Extension 6 lipos XH > EH
1 x Contacto macho pin conector (10 pcs)
1 x 120x60 mm SLH KOVO wheel
1 x Propeller APC 11x6 Glow/Gas
1 x Compact on-board starting system (9713)
1 x Distanzstück motor OS 120 AX
1 x 10cm Flexible Stainless Steel Exhaust Tubing D=25mm
1 x 29x12 prop Super Silence
1 x Servo TOPMODEL DS1413 T
1 x Blades 330mm
3,678.65EUR
Manufacturers
Manufacturer Info
Mega Motor
Mega Motor Homepage
Other products
Languages
Español English
Currencies