40.20EUR

MPS Gas-Cap-Powerswitch
[EMCA17051]


MPS Gas-Cap-Powerswitch (MPS = Magnetic Power Switch)

- Nicely shaped electronically power switch in Gas-Cap design for receiver sets, ignitions etc.
- The show stopper: turning On/Off is done with external magnet
- An inserted magnet means consumer is off, removing it turns it on ("remove before flight")
- The magnetically actuator is automatically tightened in its " Gas-Cap" by means of magnetically force
- The operating system is indicated by a bright shining blue ring
- Absolutely fail safe system concept due to a combination of Reed-Contact and Hall-Sensor
- The perfect switch - no ugly holes in the fuselage!
- Input voltage 6.0V ... 12.6V (up to 3S LiPo!)
- Continuous current 5A, peak current 20A
- Version including Robbe/Futaba connector (input and output)
- Highly flexible silicone strand with 0.5 mm2 cross section, about 30cm long
- High grade gold plated contacts (FCI)
- Mounting diameter: 15.5 mm, installation depth about 35mm

Delivery includes switching magnet, key ring, stainless steel screws, counter flange and operating instructions


temporarily out of stock
temporarily out of stock

Reviews

Customers who bought this product also purchased
Propeller MENZ-S 18x12
Propeller MENZ-S 18x12

temporarily out of stock
temporarily out of stock

Cylidric hinge 33 mm Ø 2 mm (5 pcs)
Cylidric hinge 33 mm Ø 2 mm (5 pcs)

temporarily out of stock
temporarily out of stock

Opto Gas Engine Kill Switch
Opto Gas Engine Kill Switch

temporarily out of stock
temporarily out of stock

Propeller MENZ-S 17x10
Propeller MENZ-S 17x10

temporarily out of stock
temporarily out of stock

Cable coupler M3 (10 uds)
Cable coupler M3 (10 uds)

temporarily out of stock
temporarily out of stock

Connectors banna oro 2 mm (M/F)
Connectors banna oro 2 mm (M/F)

temporarily out of stock
temporarily out of stock

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Propeller POWER-PROP 14x9
1 x Sandwich carbon + poplar 4mm + carbon 480x290 mm
1 x Straightened rod Ø 14.0 mm x 1000 mm
2 x Propeller POWER-PROP 13x9
1 x Propeller APC 14x8.5 Electric Pusher
1 x 3.2 mm Prop Adapter M6
1 x Sandwich carbon + poplar 3mm + carbon 290x160 mm
1 x Oracover light Grey 2m
1 x Conector MR-60 (pareja)
1 x Crimping tool
1 x Prop Holder AXI 41xx V2
1 x Profile ABS Square 3 x 1000 mm
1 x Sandwich carbon + poplar 2mm + carbon 290x160 mm
1 x Extension MPX-MPX 20 cm
1 x Straightened rod Ø 0.5 mm x 1000 mm
1 x Cable servo PREMIUM MAXI 1 m (blanco/rojo/azul) PVC
1 x Xplorer1 anemometro
1 x APM2.6 Power module with 5.3V DC BEC
1 x Straightened rod Ø 5.0 mm x 1000 mm
1 x Blue silicone 0,5 qmm wire (50 m)
1 x Straightened rod Ø 8.0 mm x 1000 mm
1 x 6 mm aluminium horn with patella
1 x RF9 Flight Simulator with Spektrum Controller
1 x 100m servo "Premium" wire (white/red/blue)
1 x Aramid fibre shears Proton®, 21 cm / 8" length
1 x Camera Sony 4140+673 CCD with Built-in 200mw TX + antenna
1 x Fresa corte diamante Ø 2.35mm (flame)
1 x 50m servo "Premium" wire (white/red/blue)
1 x A/C quality beech plywood 1520x750x4.0 mm
1 x Brass control horn M3 short for wire (2 pcs)
1 x Propeller balancer
1 x Balsa panel 2.0x100x1000 mm
1 x Horn micro type4 Ø 0,5 (2 pcs)
1 x Aluminium wide washer M4 Red (4 pcs)
1 x Extension silicon 50 cm (Futaba)
2 x Pilot JAN 1/4 Saiplanes
1 x ABS Strip 1.0x4.0x1000 mm
1 x BALSA trip 5.0x5.0x1000 mm
1 x Anodized aluminium servo M3x16 screw (4 red pcs)
1 x 5 mm M2 variable horn
1 x Fully Threaded Steel Rod M2,5 (2 uds)
1 x Carbon fabric 200 g/m² (Aero, plain weave) 100 cm x 5m
1 x Straightened rod Ø 4.0 mm x 1000 mm
1 x Straightened rod Ø 2.0 mm x 1000 mm
1 x Green silicone 0,25 mm² wire (25 m)
1 x Copier 2x20 cm pcs
1 x Ferrita 14x8x5.5 mm
1 x Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 10 m
1 x Aluminium cap bolt washer M3 black (8 pcs)
1 x LOWER TOW HOOK
1 x Brass hexagonal rod Ø 3 mm x 1000 mm
1 x Anodized aluminium servo M4x5/8 screw (4 lilac pcs)
1 x Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 20 m
1 x Round Rod 6,0x1000 mm
1 x Ball link V1 Ø7 M4/3 (6 uds)
1 x Kwik link AL M4 L:40 mm (2 pcs) + Pin Ø 2,5 mm
1 x 3,2 mm Prop Adapter M6
1 x 29,0 mm propeller (rigth propeller)
1 x 290 mm M4/4 mm Prop shaft
1 x 12 mm mast holder
1 x 10 mm Prop Adapter M12
1 x EDGE 540-A 105" (2660 mm)
1 x Propeller electric carbon 8.5x5
1 x Propeller 9x7 SlowFlyer
1 x 25 mm Sandpaper file
1 x Glider retract undercarriage 8-16 Kg 2.5-3.2(127 mm wheel)
1 x Ball Link Plier
1 x 1,5x50 mm allen screwdriver
1 x Piloto RC Civil 1/5- 1/6 Scale 12"
1 x 1/4 Pilot "Heidi"
1 x Propeller POWER-PROP 13x10
1 x Dumper propeller 6/8 mm
1 x Propeller POWER-PROP 15x8
1 x Propeller electric carbon 10.5x6
1 x Futaba Female 40 cm extension
1 x Prolongador S-Bus JR/JR 10cm
1 x Fresa corte diamante Ø 1.0mm (bola)
1 x Cable silicona female batt. receptor 30 cm (Futaba)
1 x Cut tube
1 x Extension 15 cm (Futaba)
1 x Boxed KIT OF 7 Rotary Burrs FINE
1 x Mudguard wheels 112/127 mm
1 x Concave-Convex sandpaper file 13 mm
1 x Extension silicon 30 cm female (Futaba)
1 x Extension silicon 30 cm male (Futaba)
1 x Dremel PERMAGRIT 18 mm round lime
1 x Fresa corte diamante Ø 1.4mm (bola)
1 x GM Propellers Folding propeller Scale 20x13 Carbon white 1 pair
1 x Battery LiFe TopFuel 3100 mAh 4s MTAG 30C
1 x USB Mini Camera endoscope
1 x Extension silicon 25 cm (Futaba)
3,967.13EUR
Manufacturers
Manufacturer Info
Emcotec
Emcotec Homepage
Other products
Languages
Español English
Currencies