59.00EUR

Glases Innovation Plus
[CMINNOVATIONP]



Set de gafas, cristales, funda y trapo
Do you have to wear prescription glasses? Fed up with seeing your buddies turn up at the field with great looking and practical glasses you just can't wear? We have the answer in the form of these stylish prescription model flying sunglasses, which have been especially developed for radio control model use.

At the heart of the design is a polycarbonate frame that houses your prescription lenses; this clips onto a main frame, which in turn houses the coloured shades that simply clip on to a hinged section. These hinges allow you to temporarily turn up the outer lenses in order to closely inspect a model in the pits etc.

Innovation Plus are polarised sunglasses. The polarised cristals greatly reduce glare, which is an effect caused by light hitting horizontally flat surfaces. Polarised lenses filter out this light to greatly enhance your visibility.

The de-centred, scratch resistant lenses have been optically balanced to negate the effects their curvature would otherwise have on your vision. Conforming to US ANSI Z80.3 plus British and European safety standard EN1836, our sunglasses are factory impact-tested, and offer great protection against flying debris should you suffer a mishap. All of our glasses carry the CE (European Union standard) compliance mark. The interchangeable lenses are: yellow (category 1) low light - these actually enhance light and contrast; beige (category 2) average sunlight; smoked mirror (category 3) bright sunlight; dark smoked (category 4), very bright conditions.

The glasses come with the interchangeable lenses, a cleaning cloth and a superb carry case with belt clip. All frames and the carry case display our 'Model Glasses' logo.

WILL THEY WORK FOR ME? - If you have a prescription (SPH) requirement that's less than plus or minus 4.00, our glasses will work just fine for you. Stronger prescriptions can cause distortion, due to the curvature of the tinted lenses when placed in front of the flat prescription clip. The de-centring calibration loses its effect where stronger prescriptions are required. If you have a requirement greater than plus or minus 4, please do not buy these glasses. Bi-focals, varifocals and prismatic lenses can be added - if in doubt, please consult your optician for advice.

IMPORTANT NOTE
When wearing Innovation Plus, some users may find they cannot see certain types of LCD or other electronic / digital transmitter displays. This is a normal cause of wearing polarised glasses. We recommend using the glasses with the front section flipped up, or the glasses removed, when model trimming prior to use.


few units
few units

Reviews

Customers who bought this product also purchased
MAX BEC
MAX BEC

few units
few units

Fiberglass plate 350x150x0.5 mm
Fiberglass plate 350x150x0.5 mm

few units
few units

Tape GFK 50 mm
Tape GFK 50 mm

few units
few units

Tape GFK 25 mm
Tape GFK 25 mm

few units
few units

Conector FUTABA Servo male  (10 pcs)
Conector FUTABA Servo male (10 pcs)

few units
few units

Conector FUTABA Servo female BLUE silicon (10 pcs)
Conector FUTABA Servo female BLUE silicon (10 pcs)

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Silent-blocks DLE 170M
1 x Motor DLE 200cc Premium Muffler
2 x Small Crow DLE-170M
2 x Big Crow DLE-170M
1 x Motor DLE 170 M- Paramotors
1 x Motor DLE 430 cc - Paramotors
1 x Propeller FALCON 32,5x11 PUSHER Carbono
1 x Straightened rod Ø 1.5 mm x 1000 mm
1 x Profile ABS half cane 4x2.5x1000 mm
1 x Straightened rod Ø 0.5 mm x 1000 mm
1 x APM2.6 Power module with 5.3V DC BEC
1 x Interface Jack Adapter IKARUS
1 x CM-3
1 x Glases Nimbus
1 x Glases Stratus
1 x Extension silicon 75 cm (Graupner)
1 x Extension 90 cm (Futaba)
1 x Glases Innovation Plus
1 x 80 mm rods set for direction control
1 x 41x5,5 mm wires output (2 pcs)
1 x Monokote BLANCO jet (1.8x0.65m)
1 x 45 mm rods + T patellas set for direction control
1 x Extension silicon 25 cm (Graupner)
1 x ORACOVER Fluor red (2 m)
1 x Cable S.BUS 3 salidas 100 mm
1 x Cable tie mounts 4.3 (4 uds)
1 x Vasa model Catapult
1 x Extension 7.5 cm
1 x Extension silicon 10 cm (Graupner)
1 x 5 LiPo XH>EH adapter
1 x Glases Ace
1 x 38x4,5 mm wires output (2 pcs)
1 x 1,2x1000 mm 2:1 black termoretract tube
1 x MYLAR film A350 (1000x500 mm)
1 x Fresa corte diamante Ø 2.3mm (bola)
1 x Aluminun wheel collar 3.5 mm Ø (4 uds)
1 x 19 mm 2:1 black termoretract tube
1 x Cabin latch Fox MDM1 4m (pair)
1 x Extension silicon 50 cm (Futaba)
1 x PVC 0,25 qmm servos wire Graupner (5 m)
1 x Silicone 0,50 qmm servos wire Graupner(5 m)
1 x XH female balance (2S) connector (2 pcs)
1 x Carbon wing joinner 13,4 mm Ø 0,48 mm
1 x Connectors banna oro 4 mm (M/F)
1 x Connectors banna oro 3,5 mm (M/F)
1 x Silicone red 0,25 mm² wire (25 m)
1 x Brass control horn M2 short for wire (2 pcs)
1 x Threaded coupler ALU M2,5 Ø 6 (2 uds)
1 x LH long aluminium horn L31xH30 (2pcs)
1 x Horn 13,5x16 mm (2 pcs)
1 x Brass control horn M3 short for wire (2 pcs)
1 x Threaded coupler ALU M2,5 Ø 4 (2 uds)
1 x Carburetor DLE 170M
1 x Carbon blade 230 mm
1 x Carbon blade 3D 230 mm
1 x CILINDER FOR DLE55, DLE111, DLE222
1 x DLE-55RA Ignition unit
1 x DLE Ignition 111/120/170
1 x Cooler motor type 280
1 x DLE 85/111/120 Crankshaft keyway
1 x 57 mm micro-mini servo cover
1 x 65 mm mini servo cover
1 x Canister combo DLE 170 cc
1 x Flybar support metal LAMA
1 x Charger Li Polymer Multi-Cell Multi-Rate Charger (MCMR)
1 x Canister combo DLE 120 cc
1 x CENTRAL PROPELLER BOLT FOR DLE85/111/120
1 x 
1 x Cargador para AA/AAA Ni-MH & Ni-Cd
1 x VBar NEO VLink 6.x Express, neon-yellow
1 x DLE 111 Old Crankshaft keyway
1 x Cooler motor type 300
1 x Swashplate metal LAMA
1 x DLE 111 Carb gasket (V1)
1 x DLE-111 Crankcase V2 Conversion Kit
1 x Propeller APC 11x4.5 Electric Pusher
1 x Propeller APC 10x4.7 SF Pusher
1 x Propeller APC 14x12 Electric
1 x Propeller APC 11x8.5 Electric
1 x Propeller APC 10x6 Electric Pusher
1 x Propeller APC 12x6 Electric Pusher
1 x Propeller APC 11x4.7 SF Pusher
1 x Propeller APC 11x4.7 SF
1 x Male connector for 6 pines AWG
1 x DUPLEX USBa USB-Adapter for Jeti Duplex Items
1 x Female connector for 6 pines AWG
1 x Female connector for 20 pines AWG
1 x Female connector JST SH 1.0mm with 10 cm wire
1 x Oracover Yellow CADMIO 10 m
1 x Oracover White 10 m
1 x Ply-Span 450x600/13g Red
1 x Actuador lineal HLS12-100210-7.4v
1 x PVC termo-retract battery 45 mm black transparent (1 m)
1 x Conector JR Servo male (10 pcs)
1 x Extension for SensorSwitch 30cm
1 x BlueCom™ Adapter (Android / WP)
1 x Cable servo PREMIUM MAXI 50m (blanco/rojo/azul) PVC
1 x Conector JR Servo male (50 pcs)
1 x Aluminun wheel collar 2.5 mm Ø (4 uds)
1 x Carbon fiber flat 1000x3.0x0.5 mm
1 x FX three-position switched channel, long
1 x Male Prolonger TP 4/5S
1 x Extension 2/3 lipos JST - JST/C
1 x Female connector for 12 pines AWG
1 x PROFICOVER 5m
13,399.08EUR
Manufacturers
Languages
Español English
Currencies