Top » Catalog » Outlet Zone » Accesories »

59.00EUR 19.90EUR

Servo Controller Fibra optica

Servo controller based on fibre-optic transmission, allows to place e.g. throttle servo right next to the ignition without anxiety about disruptions “transfer” to the RC receiver.

Fibre-optic servo controller was designed as complement to the fibre-optic ignition cutoff. However, nothing stands on the way to exploit it independently.

The main task of controller is a possibility to place throttle servo close to the engine, so the throttle control link is short. Typically disadvantage of such installation is small servo distance and its wires from the engine ignition unit. Taking into account the adverse impact of electromagnetic noise caused by the ignition, which could get to the RC circuit, controller communicates with the receiver exclusively by fibre-optic which is resistant to electromagnetic disruptions. Thanks to that there is a minimum 30 cm distance between the ignition and the RC circuit in the model. In this case throttle servo is powered by the same package as the ignition unit.

Fibre-optic servo controller can be used also for other purposes than controlling the throttle. It will work everywhere where long wires are adversely affecting the electronics operation. With its help it is possible to control the servo move being in a significant distance or everywhere where a galvanic isolation of implementation servo elements from steering electronics is required.

FORCE Servo controller correctly works with voltage range from 3.6 V on the RC receiver side, and 3.6 V on the servo power supply side. Maximum allowed supply voltage on both sides is 16.0 V. It is necessary to remember not to exceed the allowed servo voltage, and if necessary to use appropriate voltage regulator.

FORCE Servo controller consists of the fibre-optic transmitter module plugged in the RC receiver and powered directly from it. Fibre-optic receiver module powered from the ignition battery. Fibre-optic wire*. For correct operation the device requires separate channel from the receiver (in most cases CH3).

Technical data:
Fiber Optic transmitter
– dimensions: 35mm x 11mm x 13mm
– receiver plug: Futaba, female 300mm
– power supply: 3,6V – 13,0V
* 2 – 3 x (LiPo/Li-Ion/LiFe)
* 4 – 9 x (NiMh/NiCd)
– weight: ~ 10,0 gram

Fiber Optic receiver
– dimensions: 47mm x 21mm x 13 mm
– battery plug: Futaba / JR male 150mm
– servo plug: Futaba / JR male 150mm
– power supply: 3,6V – 13,0V
* 2 – 3 x (LiPo/Li-Ion/LiFe)
* 4 – 9 x (NiMh/NiCd)
– weight: ~ 15,0 gram
– load capacity: constant 5 A, temporarily 30 A

few units

Reviews

Quick Find

Shopping Cart

1 x	Long ball link M2 (6 uds)
2 x	Short ball link M2 (6 uds)
1 x	Short ball link M3 (6 uds)
2 x	M2/M1/6 3Diam short black ball link V1 (6 pcs)
1 x	Ball link M3 (10 pcs, flat ball)
1 x	Long ball link M3 (6 uds)
1 x	Socket head ball link M3 (2 uds)
1 x	Ball link M1.6 (6 uds)
3 x	M2,5 5Diam metal ball link V3 (2 pcs)
1 x	M2,5 5Diam black ball link V2 (2 pcs)
1 x	M2/M1/6 3Diam long black ball link V1 (6 pcs)
2 x	M2,5 Diam metal ball link V3 (2 pcs)
3 x	Joint with bearing M3 22x5,5
1 x	Tape GFK 25 mm
2 x	Tape GFK 50 mm
1 x	20x200 mm battery rings
3 x	Cinta Goldfix 1m
1 x	Tape GFK 38 mm
1 x	Pad Screw Mount M3, up to 3mm / 0.12″, (10 pcs)
1 x	Ring 320 mm length (5 pcs)
2 x
2 x	Pad self adhesive, up to 3mm / 0.12″, (10 pcs)
1 x	Foil for sticking flaps and ailerons
1 x	SE Ring 330 mm (4 pcs)
2 x	10 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
2 x	Marker ties (20 pcs)
1 x	5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x	Blue smoke canister 100 g
1 x	Green smoke canister 65 g
1 x	Blue smoke canister 140 g
1 x	Yellow smoke bombs AX-60 (5 pcs)
1 x	Red smoke canister 140 g
1 x	Yellow smoke canister 65 g
2 x	PPM Encoder Module
1 x	Papel japones 12 grs/m2 760x510 mm JAPICO
1 x	ORACOVER Fluor red (2 m)
1 x	Oracover Green10 m
2 x	Monokote BLUE metalizado (1.8x0.65m)
1 x	Oracover Yellow CUB 10 m
1 x	ORACOVER Ferrari red (2 m)
1 x	Oratex White 2m
1 x	Monokote ROJO misil (1.8x0.65m)
1 x	Oracover Yellow CADMIO 10 m
1 x	Oracover Red 2 m
1 x	Oracover Orange 2 m
1 x	Oracover light Grey 2m
1 x	Oracover Brown 2 m
1 x	Oratex Antik 2m
1 x	Glases Flitemaster
1 x	Pin hinge 34x16 mm (10 uds)
1 x	48 x 10 mm cylidric hinge Ø 3,0 mm (10 pcs)
1 x	Nylon hinge 15x0,3 (10 pcs)
1 x	Rocket cardboard tube 50mm x 48mm x 250mm
2 x	Blue metalic ball link M2/2 azul (2 pcs)
2 x	Long ball link M1.6 (6 uds)
1 x	Socket head long ball link M3 (2 uds)
1 x	M3/5 Diam metal short ball link V3 (2 pcs)
1 x	Carbon plate 350x150x1.0 mm
1 x	Blue metalic ball link M3/3 azul (2 pcs)
1 x	Ball link M3 (6 uds)
1 x	M2 5Diam short black ball link V2 (2 pcs)
1 x	M2,5 / 5Diam metal short ball link V3 (2 pcs)
2 x	SE Ring 250 mm (2 pcs)
1 x	Waterproof adhesive tape, width 19mm, length 25m
1 x	Joint with bearing M2 22x5,5
1 x	Socket head ball link M3 (2 uds)
1 x	M2,5 5Diam short black ball link V2 (2 pcs)
1 x	M2/M1/6 3Diam long black ball link V1 (2 pcs)
1 x	Motor OS 3820-1200 electric
1 x	PIX Hawk with accesories
1 x	14x60 mm Mini rings Tie Wraps (4 pcs)
1 x	RUDDOG Protection and Heat Shield Tape (2mx50mm)
1 x	SE Ring 240 mm (2 pcs)
1 x	20 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x	SE Ring 300 mm (2 pcs)
1 x	Digital Air Speed Sensor And Pitot Tube Set
1 x	13 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x	SE Ring HACKER 300 mm (2 pcs)
1 x	SE Ring 350 mm (2 pcs)
1 x	3,2x1000 mm 2:1 red termoretract tube
1 x	PVC transparent battery termo-retract 85 mm (1 m)
1 x	PVC termo-retract battery 45 mm black transparent (1 m)
1 x	PVC termo-retract battery 45 mm transparent orange (1 m)
1 x	12,7x1000 mm 2:1 green termoretract tube
1 x	Ply-Span 450x600/13g Yellow
1 x	Solarfilm Lite blue transp. 5m
1 x	Oracover ROYAL RED 2m
1 x	PVC blue transparent battery termo-retract 68 mm (10 m)
1 x	6,4x1000 mm 2:1 red termoretract tube
1 x	37 mm PVC transparent battery termo-retract (1 m)
1 x	1,6x1000 mm 2:1 black termoretract tube
1 x	Oracover Black 10 m
1 x	ORACOVER transparent Yellow (10 m)
1 x	Monokote PLATINO metalizado (1.8x0.65m)
1 x	Servo SAVOX SV-1254 MG HiVolt Low Profile
1 x	5 mm Prop Adapter M8
1 x	Dumper propeller 6/8 mm
1 x	POLARON EX 800w charger
1 x	Charger LiPo Charger4
1 x	SCHARNHORST accessories
1 x	Prop Shaft Adapter 6 mm/M8 "long" 35 mm
1 x	3,2 mm Prop Adapter M6
1 x	5 mm Prop Adapter M8
1 x	Prop Shaft Adapter 8 mm/M12 "long"
1 x	Prop Shaft Adapter 5 mm "long"
1 x	3,2 mm Prop Adapter M6
1 x	Prop Shaft Adapter 5 mm/M8 "long"
1 x	Aero-Master (Aero-naut)
1 x	3 mm Prop Adapter M6
1 x	10 mm Prop Adapter M12
1 x	Propeller hub spacer 8/5.5
1 x	3,2 mm Prop Adapter M8
1 x	3.2 mm Prop Adapter M8
1 x	Aero-Master Cabine (Aero-naut)
1 x	2 mm Prop Adapter M6
1 x	La Capitania di Venetia accesories
1 x	3.2 mm Prop Adapter M6
1 x	MG cannon 1.8 cm (5 pcs)
1 x	4 mm Prop Adapter M8
1 x	3.17 mm Prop Adapter CN-Spinner
1 x	6 mm Prop Adapter M8
1 x	2,3 mm Prop Adapter M6

3,519.60EUR

Manufacturers

Manufacturer Info


-	SETLO Homepage
-	Other products

Notifications

Notify me of updates to Servo Controller Fibra optica

Reviews

Write a review on this product!

Languages

Currencies

Insurance