59.00EUR

Glases Innovation Plus
[CMINNOVATIONP]



Set de gafas, cristales, funda y trapo
Do you have to wear prescription glasses? Fed up with seeing your buddies turn up at the field with great looking and practical glasses you just can't wear? We have the answer in the form of these stylish prescription model flying sunglasses, which have been especially developed for radio control model use.

At the heart of the design is a polycarbonate frame that houses your prescription lenses; this clips onto a main frame, which in turn houses the coloured shades that simply clip on to a hinged section. These hinges allow you to temporarily turn up the outer lenses in order to closely inspect a model in the pits etc.

Innovation Plus are polarised sunglasses. The polarised cristals greatly reduce glare, which is an effect caused by light hitting horizontally flat surfaces. Polarised lenses filter out this light to greatly enhance your visibility.

The de-centred, scratch resistant lenses have been optically balanced to negate the effects their curvature would otherwise have on your vision. Conforming to US ANSI Z80.3 plus British and European safety standard EN1836, our sunglasses are factory impact-tested, and offer great protection against flying debris should you suffer a mishap. All of our glasses carry the CE (European Union standard) compliance mark. The interchangeable lenses are: yellow (category 1) low light - these actually enhance light and contrast; beige (category 2) average sunlight; smoked mirror (category 3) bright sunlight; dark smoked (category 4), very bright conditions.

The glasses come with the interchangeable lenses, a cleaning cloth and a superb carry case with belt clip. All frames and the carry case display our 'Model Glasses' logo.

WILL THEY WORK FOR ME? - If you have a prescription (SPH) requirement that's less than plus or minus 4.00, our glasses will work just fine for you. Stronger prescriptions can cause distortion, due to the curvature of the tinted lenses when placed in front of the flat prescription clip. The de-centring calibration loses its effect where stronger prescriptions are required. If you have a requirement greater than plus or minus 4, please do not buy these glasses. Bi-focals, varifocals and prismatic lenses can be added - if in doubt, please consult your optician for advice.

IMPORTANT NOTE
When wearing Innovation Plus, some users may find they cannot see certain types of LCD or other electronic / digital transmitter displays. This is a normal cause of wearing polarised glasses. We recommend using the glasses with the front section flipped up, or the glasses removed, when model trimming prior to use.


few units
few units

Reviews

Customers who bought this product also purchased
Tape GFK 50 mm
Tape GFK 50 mm

few units
few units

Tape GFK 25 mm
Tape GFK 25 mm

few units
few units

MAX BEC
MAX BEC

few units
few units

Fiberglass plate 350x150x0.5 mm
Fiberglass plate 350x150x0.5 mm

few units
few units

Connectors DEANS (T)
Connectors DEANS (T)

few units
few units

Conector FUTABA Servo male  (10 pcs)
Conector FUTABA Servo male (10 pcs)

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Adjustable launching hook
2 x Unmounted aluminium pin 6x98 mm (2 pcs)
2 x Pin type hinge Al 3,0x50 mm demount (2 pcs)
1 x Nylon hinge for flaps 33x9 (2 pcs)
1 x Pin type hinge Al 4,5x70 mm (2 pcs)
3 x Nylon hinge 20x15x0,3 (10 pcs)
1 x 25 mm reinforced hinge
1 x Zurich Sport Sunglasse Dark Sensity BROWN Glasses
1 x Cylidric hinge 43 mm Ø 2,5 mm (5 pcs)
2 x Miniature brass strap hinge, 1 m
1 x 48 x 10 mm cylidric hinge Ø 3,0 mm (10 pcs)
1 x Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm)
1 x APM2.6 Power module with 5.3V DC BEC
1 x Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH
2 x Xplorer3 anemometro
1 x Xplorer2 anemometro
1 x Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH
1 x CC 01
1 x 30 cm BEC cable (female)
1 x Adapter lead MPX/EC3
1 x Balanceradapter JST-XH (Heli 47G) 2-6 c.
1 x CC 05
1 x Copper lacquer wire Ø0,2 mm (5 m)
1 x Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm)
2 x Xplorer4 anemometro
1 x 4 LiPo XH>EH adapter
1 x CellPRO 4S Adaptader (GP/KO up to 4S)
1 x Adapter lead MPX/XT60
1 x Futaba External voltage input cable Futaba CA-RVIN-700
1 x Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm)
1 x MPX-Dean "T" Adapter
2 x Xplorer1 anemometro
1 x 30 cm BEC cable (male)
1 x 3 LiPo XH>EH adapter
1 x CC 03
1 x 5 LiPo XH>EH adapter
2 x TP/TopFuel - JST-EH 4/5S Adapter
1 x 3 copper lacquer wire Ø0,2 mm (1 m)
2 x USB HLS prog. interface
1 x Cabel charger transmitter GRAUPNER
1 x SE Ring 450 mm (2 pcs)
1 x SE Ring HACKER 300 mm (2 pcs)
1 x RUDDOG Protection and Heat Shield Tape (2mx50mm)
1 x Tape GFK 25 mm
1 x Ring 320 mm length (5 pcs)
1 x Pad self adhesive, up to 3mm / 0.12″, (10 pcs)
1 x Tape GFK 38 mm
1 x 20x200 mm battery rings
1 x Foil for sticking flaps and ailerons
1 x SE Ring 480 mm (2 pcs)
1 x Pad Screw Mount M3, up to 3mm / 0.12″, (10 pcs)
1 x Straightened rod Ø 4.5 mm x 1000 mm
1 x Pine wood slat 1.5x3.0x1000 mm
1 x BALSA trip 3.0x3.0x1000 mm
1 x ABS Strip 1.5x4.0x1000 mm
1 x Streamline Stainless Steel Tubing 10.5x5.7x1000 m
1 x Cable servo PREMIUM MAXI 10m (blanco/rojo/azul) PVC
1 x Sun Cover PC 21 XXL (JMB Jets)
1 x 2 LiPo XH>EH adapter
1 x Mixers smoke bombs AX-60 (5 pcs)
1 x AX-60 starters (5 pcs)
1 x SE Ring 240 mm (2 pcs)
1 x "S" set for planes
1 x SE Ring 330 mm (4 pcs)
1 x Smoke set "M"
1 x Nylon hinge 15x0,3 (10 pcs)
1 x Servo slow down unit (0,7-14,7 sec )
1 x Opto Gas Engine Kill Switch
1 x Retract undercarriage for gliders up to 2 Kg
1 x TP/TopFuel - XH 2/3S Adapter
1 x Prolonguer for Balancer Thunder Power 6S
1 x Pin hinge 39x20 mm (10 uds)
1 x Glider retract undercarriage 8-16 Kg 2.5-3.2(140 mm wheel with b
2 x PSC 6
2 x Opto Gas Engine Kill Switch
1 x Aluminun wheel collar 2.5 mm Ø (4 uds)
1 x Body for landing gear Ø 4 mm
1 x Fast'n EZ-CA-Hinge, lite (12 uds)
1 x Small flex hinge (12 uds)
1 x Long pinned hinge (6 uds)
1 x PSC 5
1 x Nylon gear block Ø 6 mm (2 uds)
1 x Nylon hinge for flaps/gates 27x10,5 (2 pcs)
1 x Magnetic Interruptor MULTIPLEX
1 x Gates hinge
1 x Aero shocks
1 x Male prolonguer XH 30 cm 6 cell cable of silicone 0,25 mm
1 x Faucet FESTO
1 x 67 mm cylidric hinge Ø 4,5 mm (5 pcs)
1 x Nylon threaded block M6 (2 uds)
1 x Carbon tube (L 1000 mm, Ø12 mm, Ø10 mm)
1 x Carbon tube (L 1000 mm, Ø14 mm, Ø12 mm)
1 x ABS tube 14.0x10.0x1000 mm
1 x Nylon gear block Ø 5 mm (2 uds)
1 x Interruptor SPS 70v 60/120A
1 x USB interface ALTIS
1 x SBEC Jeti
1 x Festo 6mm Tubing Holder (10 uds)
1 x Aluminun wheel collar 3.5 mm Ø (4 uds)
1 x TrainerCord (master-learner)
1 x Flap hinge 33x9 mm (6 pcs)
1 x Three-position switched channel, short
1 x Aluminun wheel collar 5 mm Ø (4 uds)
1 x Pin type hinge Al 3,0x50 mm (2 pcs)
1 x Male Prolonger TP 4/5S
2 x MPS Gas-Cap-Powerswitch
1 x SBEC 40
1 x Large flex hinge (12 uds)
1 x PWC4 wing/fuselage connector for 4 servos
1 x Gates hinge black 30x16 mm (2 pcs)
1 x Landing gear axle Ø 4 mm (2 uds)
1 x 33 x 8 mm cylidric hinge Ø 2,5 mm (10 pcs)
3,056.15EUR
Manufacturers
Languages
Español English
Currencies