59.00EUR

Glases Innovation Plus
[CMINNOVATIONP]



Set de gafas, cristales, funda y trapo
Do you have to wear prescription glasses? Fed up with seeing your buddies turn up at the field with great looking and practical glasses you just can't wear? We have the answer in the form of these stylish prescription model flying sunglasses, which have been especially developed for radio control model use.

At the heart of the design is a polycarbonate frame that houses your prescription lenses; this clips onto a main frame, which in turn houses the coloured shades that simply clip on to a hinged section. These hinges allow you to temporarily turn up the outer lenses in order to closely inspect a model in the pits etc.

Innovation Plus are polarised sunglasses. The polarised cristals greatly reduce glare, which is an effect caused by light hitting horizontally flat surfaces. Polarised lenses filter out this light to greatly enhance your visibility.

The de-centred, scratch resistant lenses have been optically balanced to negate the effects their curvature would otherwise have on your vision. Conforming to US ANSI Z80.3 plus British and European safety standard EN1836, our sunglasses are factory impact-tested, and offer great protection against flying debris should you suffer a mishap. All of our glasses carry the CE (European Union standard) compliance mark. The interchangeable lenses are: yellow (category 1) low light - these actually enhance light and contrast; beige (category 2) average sunlight; smoked mirror (category 3) bright sunlight; dark smoked (category 4), very bright conditions.

The glasses come with the interchangeable lenses, a cleaning cloth and a superb carry case with belt clip. All frames and the carry case display our 'Model Glasses' logo.

WILL THEY WORK FOR ME? - If you have a prescription (SPH) requirement that's less than plus or minus 4.00, our glasses will work just fine for you. Stronger prescriptions can cause distortion, due to the curvature of the tinted lenses when placed in front of the flat prescription clip. The de-centring calibration loses its effect where stronger prescriptions are required. If you have a requirement greater than plus or minus 4, please do not buy these glasses. Bi-focals, varifocals and prismatic lenses can be added - if in doubt, please consult your optician for advice.

IMPORTANT NOTE
When wearing Innovation Plus, some users may find they cannot see certain types of LCD or other electronic / digital transmitter displays. This is a normal cause of wearing polarised glasses. We recommend using the glasses with the front section flipped up, or the glasses removed, when model trimming prior to use.


few units
few units

Reviews

Customers who bought this product also purchased
Fiberglass plate 350x150x0.5 mm
Fiberglass plate 350x150x0.5 mm

few units
few units

Tape GFK 50 mm
Tape GFK 50 mm

few units
few units

Tape GFK 25 mm
Tape GFK 25 mm

few units
few units

MAX BEC
MAX BEC

few units
few units

Connectors DEANS (T)
Connectors DEANS (T)

few units
few units

Conector FUTABA Servo male  (10 pcs)
Conector FUTABA Servo male (10 pcs)

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x 20 mm carbon horn
1 x Horn 16,5x20 mm (2 pcs)
1 x Clip mini fixing for wing (2 pcs)
2 x Horn with ball 55x40
1 x Brass control horn M4 short for wire (10pcs)
1 x 5 mm M2 variable horn
1 x Aluminun wheel collar 4 mm Ø (4 uds)
1 x Cabin latch Fox MDM1 4m (pair)
1 x Aluminun wheel collar 5 mm Ø (4 uds)
1 x Horn 6/35 with M3 Bearing
2 x Cable grommet Ø 6.4 mm (4 uds)
1 x Horn mando long (2 pcs)
1 x Horn F3A de Titanium 16 mm (2 units)
1 x Allen wheel collar M3x3
1 x Brass control horn M2 short for wire (2 pcs)
1 x Control horn long w/ball
1 x Horn mando small (2 pcs)
1 x Adjustable brass horn threaded M3
2 x Cable grommet Ø 4 mm (4 uds)
1 x 100 mm rods set for direction control
1 x Canopy Lock V1 M3 Red (2 pcs)
2 x Allen wheel collar M3x5
1 x 38x4,5 mm wires output (2 pcs)
1 x Cable control set
1 x 90 mm rods + T patellas set for direction control
1 x Fully Threaded Steel Rod M2,5 (2 uds)
2 x Cable grommet Ø 5 mm (4 uds)
1 x 5 mm M2 variable inclined horn
1 x Clip fixing for wing (2 pcs)
1 x Aluminun wheel collar 3 mm Ø (4 uds)
1 x Horn for flap control (1 pcs)
1 x Canopy Latch
1 x Aluminun wheel collar 6 mm Ø (4 uds)
2 x Aluminun wheel collar 3.5 mm Ø (4 uds)
1 x Brass control horn M4 short for wire (4 pcs)
1 x Extra long horn 60x30
1 x Duralumium F3A horn 30x10x23,5 mm (2 pcs)
1 x Horn 6/27 with M3 Bearing
1 x Canopy Lock V1 M3 Blue (2 pcs)
1 x Horn micro type4 Ø 0,5 (2 pcs)
1 x 250 mm / 16 mm Airbrakes
1 x Aluminium alloy coupler for carbon tube 6/M4
1 x Horn 6/20 with M3 Bearing
1 x Cable grommet 9.5 mm (4 uds)
1 x Cable with accesories
2 x Allen wheel collar M4x4
1 x 6 mm M3 variable horn
1 x 45 mm rods set for direction control
1 x Cable tie mounts 4.3 (4 uds)
1 x 11 mm Rubber pads (14 pcs)
1 x Brass control horn M4 long for wire (4 pcs)
1 x 100 mm rods + T patellas set for direction control
1 x 140 mm rods + T patellas set for direction control
1 x Horn 13,5x16 mm (2 pcs)
1 x 6 mm M3 variable inclined horn
1 x Horn DUBRO 1/2A
1 x Brass control horn M2 long for wire (10pcs)
1 x Cockpit aluminium closing
1 x Horn 5/10 with M2 Bearing
1 x Horn 5/20 with M2 Bearing
1 x Horn with ball 40x30
1 x 6 mm aluminium horn with patella
1 x SE Ring 200 mm (2 pcs)
1 x SE Ring 480 mm (2 pcs)
1 x 10 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x Pad Screw Mount M3, up to 3mm / 0.12″, (10 pcs)
1 x Cinta Goldfix 1m
1 x SE Ring HACKER 300 mm (2 pcs)
1 x 20x1000 mm Ring Strap Back To Back
1 x Foil for sticking flaps and ailerons
1 x 14x60 mm Mini rings Tie Wraps (4 pcs)
1 x Cable-Tie 1.66x71mm / 0.07x2.8″ (20 pcs)
1 x 26 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x SE Ring 250 mm (2 pcs)
1 x 13 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x SE Ring 360 mm (2 pcs)
1 x 13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x 5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x Marker ties (20 pcs)
1 x Tape GFK 50 mm
1 x SE Ring 330 mm (4 pcs)
1 x 20x200 mm battery rings
1 x SE Ring 400 mm (2 pcs)
1 x SE Ring 450 mm (2 pcs)
1 x Aluminium tube (L 1000 mm, Ø3.0 mm, Ø2.1 mm)
1 x Conector BEC male (10 pcs)
1 x Conector MR-60 (pareja)
1 x ABS tube 16.0x14.0x1000 mm
1 x Conector XT-30 (hembra)
1 x Conector XT-30 (macho)
1 x Connectors banana oro 6,0 mm Ultralight (M/F)
1 x ABS tube 7.0x6.0x1000 mm
1 x Connectors banna gold 5,5 mm (M/F)
1 x Carbon tube (L 1000 mm, Ø14 mm, Ø12 mm)
1 x Carbon tube (L 1000 mm, Ø18 mm, Ø16 mm)
1 x Conector JR Servo male (50 pcs)
1 x Conector AS150 7mm antichispazo (Set: 2 pares)
1 x Brass hexagonal rod Ø 3.5 mm x 1000 mm
1 x Steering arm 12 mm Ø 4 mm (2 uds)
1 x Landing gear frontal support 29x26x13,5
1 x Crimping sleeves for cable 0.85 mm (10 pcs)
1 x Straightened rod Ø 1.0 mm x 1000 mm
1 x Straightened rod Ø 6.0 mm x 1000 mm
1 x Straightened rod Ø 1.2 mm x 1500 mm
1 x Straightened rod Ø 5.5 mm x 1000 mm
1 x Screw-lock pushrod conn snap Ø 1.5 mm (2 uds)
1 x Straightened rod Ø 2.0 mm x 1000 mm
1 x 28x5 mm wires output (2 pcs)
1 x 41x5,5 mm wires output (2 pcs)
1 x Lead with adhesive (2 pcs)
1 x Control for forward wheel (MINI)
1 x Tip wing protector 40x14 (2 pcs)
1 x Split pin 1x8 mm (10 uds)
1 x Straightened rod Ø 1.5 mm x 1000 mm
1 x Straightened rod Ø 0.5 mm x 1000 mm
1 x Straightened rod Ø 1.5 mm x 1500 mm
1 x Straightened rod Ø 14.0 mm x 1000 mm
1 x Straightened rod Ø 3.0 mm x 1000 mm
1 x Locking cable tie 2.5x100 (uds)
1 x Crimping sleeves for cable 0.70 mm (10 pcs)
1 x Snap pin for micro clevis (10 uds)
1 x Tip wing protector 30x10 (2 pcs)
1 x Brass hexagonal rod Ø 5 mm x 1000 mm
1 x Steering arm 16 mm Ø 4 mm
1 x Xplorer1 anemometro
1 x Xplorer4 anemometro
1 x Xplorer3 anemometro
1 x 1/6 Pilot "Garry"
1 x Piloto Jet "Green" 1/6 Scale
1,112.11EUR
Manufacturers
Languages
Español English
Currencies