54.24EUR

NF-3 RC set
[NF-3RC Set]



Funcionamiento del NF-3

Esquema de conexi�n
NF-3RC extends the capabilities of the NF-2RC unit with a greater number of circuits and more flash lights regimes. Just as NF-2RC it has two position lights circuits. It has also two landing lights circuits and two flash light circuits. Switching on/off of the second landing lights circuit is delayed by 1 second against he first circuit. That produces an effect of phased switching by the pilot. Eight different combinations of flashing can be selected for the two flash light circuits. Three couplers (jumpers) are used for selection.

One second is split into 16 parts. It is possible to set during which parts the light should be on (1) and off (0) to both flash circuits. Such a couple of sequences of 16 ones and zeros represents one combination of flashes. Eight such combinations (couples of sequences) are saved in the unit. By default, the unit contains six combinations of 1, 2 and three mutually shifted flashes plus two flashing modes 1:1, one with the period 1s, the other twice faster. The last two regimes are designed especially for helicopters owners.

A coupler is used for selection of 2- and 3-positional control regime as in NF-2RC. If the 2-position control is selected, in the first position the position and ant-collision lights light, in the second position the landing lights get switched on, too. In the three-position regime, in the first position, all lights are off, in the second position the position lights and anti-collision flash lights are on and in the third position, all lights are on. The unit can be used also in no-control mode. In that mode, position and flash lights are permanently turned on and the coupler for regime selection switches the landing lights.

Thanks to a galvanic separation of the receiver’s and power circuits (by an opto-member), the illumination can be powered both from a common source or from an independent accumulator. The NF-3RC unit can be used also as a basis for your own constructions for excitation of MOSFET power transistors.

The circuit is extended with detection of failure of the receiver's signal - it is indicated by permanent flashing of the anti-collision flash lights and the landing lights.

The NF-3RC, besides control circuit, includes 1x5 mm 20 mAh green LED, 2x5 mm 20 mAh red LEDs and 6x5 mm 20 mAh white LEDs


temporarily out of stock
temporarily out of stock

Reviews

Customers who bought this product also purchased
NF-1 RC set
NF-1 RC set

temporarily out of stock
temporarily out of stock

Connectors MPX female
Connectors MPX female

temporarily out of stock
temporarily out of stock

Connectors MPX male
Connectors MPX male

temporarily out of stock
temporarily out of stock

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Steering arm 12 mm Ø 4 mm (2 uds)
1 x Electric spoiler 250 mm (2 pcs)
1 x L cockpit anchor "tipe F3A" (2 pcs)
1 x Steering arm 12 mm Ø 4 mm
1 x Screw-lock pushrod conn snap Ø 1.5 mm (2 uds)
1 x Cierre cabina aluminio Ø4, I=10 mm
1 x Screw-lock connector Ø 2 mm (2 uds)
1 x Screw-lock connector M2 (2 uds)
1 x Canopy Lock V1 M3 Blue (2 pcs)
1 x Crimping sleeves for cable 0.85 mm (10 pcs)
1 x Cabin latch Fox MDM1 4m (pair)
1 x Locking cable tie 2.5x100 (uds)
1 x Covered closure or fairings
1 x Locking cable tie 4.6x203 (uds)
1 x Steering arm 16 mm Ø 4 mm
1 x Stainless steel cable Ø 0.5 mm (2 m)
1 x Stainless steel cable Ø 0.88 mm - 60 kp (10 m)
1 x Steering arm 16 mm Ø 3 mm (2 uds)
1 x Steering arm 16 mm Ø 4 mm (2 uds)
1 x Cap closure 33/23.5mm (2 uds)
1 x Fiberglass plate 350x150x1.5 mm
1 x Aluminium alloy coupler for carbon tube 6/M4
1 x Cierre cabina aluminio Ø5, I=16 mm
1 x Stainless steel cable Ø 0.5 mm (10 m)
1 x Crimping sleeves for cable 1.3 mm (10 pcs)
1 x Cinta Goldfix 1m
1 x SE Ring HACKER 300 mm (2 pcs)
1 x SE Ring 200 mm (2 pcs)
1 x 
1 x SE Ring 360 mm (2 pcs)
1 x 14x60 mm Mini rings Tie Wraps (4 pcs)
1 x Spikes Band (5 m)
1 x RUDDOG Protection and Heat Shield Tape (2mx50mm)
1 x SE Ring 450 mm (2 pcs)
1 x Marker ties (20 pcs)
1 x SE Ring 240 mm (2 pcs)
1 x Pine wood slat 3.0x5.0x1000 mm
1 x LH long aluminium horn L31xH30 (2pcs)
1 x BALSA trip 2.0x10.0x1000 mm
1 x BALSA triangular 8x8x1000 mm
1 x Threaded coupler ALU Left M2,5 Ø 3 (2 uds)
1 x BALSA trip 4.0x4.0x1000 mm
1 x 6 mm red aluminium threaded horn with patella
1 x Pine wood slat 10x10x1000 mm
1 x Trailing edge BALSA 35x8x1000 mm
1 x Brass control horn M3 short for wire (2 pcs)
1 x Beech dowels 2.0 x 1000 mm
1 x Beech dowels 10 mm x 1000 mm
1 x RH long aluminium horn (2pcs)
1 x Brass control horn M4 short for wire (10pcs)
1 x Pine wood slat 3.0x10.0x1000 mm
1 x Solvent Plasti Dip 1000 ml
1 x Painting GHT Lexan Black 150 ml
1 x Spannlack 1000 ml
1 x Spray EC Red 400ml
1 x Spray Graphit 33
1 x Plasti Dip Liquid Tape 429 ml black
1 x Paint gun for sprays
1 x Nitroverdu 500 ml
1 x Release wax 250ml
1 x 
1 x Partall paste 650 g
1 x Spray YELLOW Inca Lexan 150ml
1 x Gates hinge 30x16 mm (2 pcs)
1 x Gates hinge black 30x16 mm (2 pcs)
1 x Micro flex hinge (12 uds)
1 x Nylon hinge 20x20x0,3 (10 pcs)
1 x 15 mm reinforced hinge
1 x 76 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs)
1 x Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs)
1 x Nylon hinge for flaps/gates 27x10,5 (2 pcs)
1 x 67 mm cylidric hinge Ø 4,5 mm (5 pcs)
1 x Pin type hinge Al 6x98 mm (2 pcs)
1 x Fast'n EZ-CA-Hinge (12 uds)
1 x Pin type hinge Al 3,0x50 mm (2 pcs)
1 x Pin type hinge Al 4,5x70 mm (2 pcs)
1 x Pin type hinge Al 4,5x70 mm to wire (2 pcs)
1 x Cylidric hinge 33 mm Ø 2 mm (5 pcs)
1 x Pin type hinge Al 3,0x50 mm demount (2 pcs)
1 x 48 mm cylidric hinge Ø 2,5 mm (5 pcs)
1 x Nylon hinge 15x0,3 (10 pcs)
580.50EUR
Manufacturers
Manufacturer Info
Night Fly
Night Fly Homepage
Other products
Languages
Español English
Currencies