40.00EUR

NF-3m Heli Kit
[NF-3m Heli Kit]


The NF-3m Heli Kit is unit with cables and LEDs ready to install into an indoor helicopter. Length of cables correspond to models like EasyCopter, Blade or Lama. There are 6 lights (LEDs 3mm) installed : two position lights (Red and Green), two flashing lights (Red and White) and two landing lights (White).

NF-3m Heli Kit has cable into a receiver. This is ready to work with helicopters having a free channel to control the lights by a pilot. Operational voltage is expected by BEC, typical voltage is 5,0 V. Works from 4,5 V to 5,5 V.

The circuit is to be connected with a Graupner or Hitec connector directly to the receiver, being supplied with a voltage of 5V and with BEC circuit tolerance. The circuit has no other protection against reversed polarity than a connector lock. Diodes are supplied with this voltage. The output conntacts have a joint positive pole. Each output can be connected with one diode.
The F1 and F2 circuits (see manual) flash with one second period. Using three jumpers ( 1, 2, 4 ), one of the eight preset flashing combinations can be achieved i.e. one, two or three separated flashings. You can set the order number of the combination from 0 to 7 by means of the jumpers as follows: all jumpers, when disconnected, sum up to 0. The sum of number of the connected jumpers represents the number of the selected combination.

The unit NF-3m can also be connected as an uncontrolled unit when disconnecting the orange signal contact on the connector on the receiver. This can be either cut off or you can gently try to lift the lock on the connector and pull the contact out of the connector. Then isolate against touching by chance. If necessary, you can always push the contact back again. When connecting the unit as an uncontrolled one (without the orange contact) the position and the flashing lights are permanently switched on and the jumper "2p/3p" switches the landing lights.

The total average current consumption by all lights on is between 12 mA from a BEC. During 10 minutes of fly the light circuits burn only a little bit more than 1 % of capacity of a 700 mAh accumulator. Position and number of the installed LEDs depends on your own decision. However, you should keep in mind that, according to conventions, position lights are correspond with the green diode on the right and the red one on the left, in the flying direction. Usually the flashing light on the body is red and on the tail is white.

The NF-3m, besides control circuit, includes 1x3 mm 10 mAh green LED, 2x3 mm 10 mAh red LEDs and 3x3 mm 10 mAh white LEDs


temporarily out of stock
temporarily out of stock

Reviews

Customers who bought this product also purchased
Servo slow down unit (0,7-14,7 sec )
Servo slow down unit (0,7-14,7 sec )

temporarily out of stock
temporarily out of stock

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x EXTRA NG 74" white/red/blue (Skywing RC)
1 x Adaptadores carga 6s JST-XH
1 x Extension MPX-MPX 20 cm
1 x Starter EM Gear Power 80
1 x Turbina KINGTECH K320 G5
1 x EXTRA NG 74" yello/blue/red (Skywing RC)
1 x Gear for D 54
1 x Servo Dymond D 37 Eco
2 x HPP-21 PLUS PC Programmer for Hitec Digital Servos
2 x Servo Tester
1 x Servo inverter
1 x HITEC DPC-11 programmer
1 x Servo MKS HV747
1 x Servo MKS HV6130
1 x Brazo servo MKS X8 Metal L:1.25/1.5 inc
1 x HV6150 Digital Servo
1 x Servo MKS HV69
1 x Servo MKS HV 777A+
1 x Servo MKS 6100 DS
1 x Servo MKS HV1220
1 x Servo MKS HBL599 SL
1 x Flat washer 1.7 mm (20 pcs)
1 x Extinguisher CO2 - 2 Kg
1 x PARTALL® Hi-Temp Wax, 340 g
1 x Aluminium wide washer M3 red (4 pcs)
1 x 
1 x 500 ml sealer (DOPE)
1 x Lock washer 4.3 mm (20 pcs)
1 x Plasti Dip Liquid Tape 429 ml black
1 x Universal Colour Paste signal white (RAL 9003) 1 Kg
1 x Nitroverdu 500 ml
1 x Quicklock washer 3.5 mm (10 pcs)
1 x Aluminium wide washer M4 Blue (4 pcs)
1 x Presto SF Light Filler styrene-free (420 g)
1 x Aluminium wide washer M4 Black (4 pcs)
1 x Universal Colour Paste deep black 50 g
1 x Flat washer 3.2 mm (20 pcs)
1 x Aluminium cap bolt washer M3 red (8 pcs)
1 x Paint gun for sprays
1 x Partall paste 650 g
1 x Flat washer 4.3 mm (20 pcs)
1 x Plasti Dip Liquid Tape 429 ml black
1 x Aluminium wide washer M4 Gold (4 pcs)
1 x Aluminium wide washer M3 blue (4 pcs)
1 x Aluminium wide washer M4 Red (4 pcs)
1 x Flat washer 2.2 mm (20 pcs)
1 x Painting GHT Lexan Black 150 ml
1 x Circlik for shaft 1.5 mm (10 pcs)
1 x Kwik link AL M2,5 L:23 mm (2 pcs) + Pin Ø 1,6 mm
1 x Aluminium tube (L 1000 mm, Ø3.0 mm, Ø2.1 mm)
1 x Receptor CORE PBR-26XS 26ch
1 x Gear for D 200 BX
1 x Servo GO-12S69MG 26kg.cm 0.10s/60º
1 x Threaded insert M5 (10 pcs)
1 x Lock nut M2 (10 pcs)
1 x Nut for mounting M3 (4 pcs)
1 x Threaded insert M4 (4 pcs)
1 x Blue Aluminium lock nut M2 (4 pcs)
1 x Anodized aluminium servo M4x5/8 screw (4 lilac pcs)
1 x Servo GO-12S70MG 20.5kg.cm 0.06s/60º
1 x Servo GO-02 Digital 1.8g
1 x Aro pasacable Ø25 mm (4 pcs)
1 x Servo KST X10 MINI wing 10mm 23g 7.5Kg
1 x Servo KST HS08A Wing Servo - 5.2Kg.cm 0.11s 11.0g 8mm
1 x Aro pasacable Ø20 mm (4 pcs)
1 x Support FUEL DOT V3
1 x Support pump Xicoy X45
1 x Recessed MPX connector support (6 pcs)
1 x Brazo servo aluminio KST 25T-5V2,3515,325,125,135,145X10,X12,A13
1 x Servo KST DS125MG servo ala 10mm 28g 7Kg
1 x Big Crow DLE-170M
1 x Small Crow DLE-170M
1 x Futaba BLS152 - Upper Case
1 x Servo FUTABA BLS173 SV
1 x Servo FUTABA S 3071 HV S-Bus
1 x Futaba S3010 Servo - Standard BB 0.16s/6.5kg
8,285.98EUR
Manufacturers
Manufacturer Info
Night Fly
Night Fly Homepage
Other products
Languages
Español English
Currencies