15.06EUR

Opto Gas Engine Kill Switch
[ROI142KS]


This kill switch is Optically Coupled to isolate your ignition system from your radio system. (No Interference!!) this device features the following:

•Includes a remote mountable bright LED to indicate when the ignition is armed.
• Optically Coupled input/output is Isolated.
• 8 Bit PIC Controller.
• Li-Po/Li-Ion/A123/Ni-Mh/NiCad Input.
• Up to 20 Volt 15 amp MOS-FET output.
• DSP Noise/Loss of signal Filtering.
• PPM-PCM 2048 – 1024 & 2.4Ghz Interface Support.
• Low Voltage Drop – Less than 150mv.
• 100% Surface Mount Technology.
• Heavy Gauge Wires, universal connectors.
• Small and light weight – only 12 Grams!

This device plugs into a spare receiver channel.

This is a must have safety device for any gas powered plane! This device allows you to safely kill your engine at anytime (on the ground, or inthe air!)


few units
few units

Reviews

Customers who bought this product also purchased
Propeller MENZ-S 18x12
Propeller MENZ-S 18x12

few units
few units

Cylidric hinge 33 mm Ø 2 mm (5 pcs)
Cylidric hinge 33 mm Ø 2 mm (5 pcs)

few units
few units

MPS Gas-Cap-Powerswitch
MPS Gas-Cap-Powerswitch

few units
few units

Propeller MENZ-S 17x10
Propeller MENZ-S 17x10

few units
few units

Straightened rod Ø 1.0 mm x 1000 mm
Straightened rod Ø 1.0 mm x 1000 mm

few units
few units

Tacometer mini ignition RCEXL
Tacometer mini ignition RCEXL

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Aluminun wheel collar 4 mm Ø (4 uds)
1 x 100 mm rods set for direction control
1 x 45 mm rods set for direction control
1 x Cable grommet Ø 6.4 mm (4 uds)
1 x Aluminun wheel collar 3.5 mm Ø (4 uds)
1 x 140 mm rods + T patellas set for direction control
1 x Canopy Lock V1 M3 Red (2 pcs)
1 x Cabin latch Fox MDM1 4m (pair)
1 x 45 mm rods + T patellas set for direction control
1 x 41x5,5 mm wires output (2 pcs)
1 x Cable tie mounts 4.3 (4 uds)
1 x Allen wheel collar M3x3
1 x Allen wheel collar M3x5
1 x 38x4,5 mm wires output (2 pcs)
1 x Aluminun wheel collar 6 mm Ø (4 uds)
1 x Clip fixing for wing (2 pcs)
1 x Aluminun wheel collar 2 mm Ø (4 uds)
1 x 11 mm Rubber pads (14 pcs)
1 x Aluminium alloy coupler for carbon tube 6/M4
1 x Aluminun wheel collar 5 mm Ø (4 uds)
1 x Cable grommet Ø 3.2 mm (4 uds)
1 x Canopy Latch
1 x 90 mm rods + T patellas set for direction control
1 x Allen wheel collar M4x6
1 x 250 mm / 16 mm Airbrakes
1 x 140 mm rods set for direction control
1 x Cable grommet 9.5 mm (4 uds)
1 x Aluminun wheel collar 2.5 mm Ø (4 uds)
1 x Crimping tool
1 x Fully Threaded Steel Rod Duralumin 100 mm M3 (2 pcs)
1 x Silent-blocks DLE 170M
1 x Fully Threaded Steel Rod alumin 60 mm M3 (2 pcs) knurled
1 x Fully Threaded Steel Rod Duralumin 34 mm M3 (2 pcs)
1 x Pushrod octagone 3/2 with coupler M2
1 x Big Crow DLE-170M
1 x Pushrod greyline 4/3 with coupler M3
1 x Fully Threaded Steel Rod alumin 60 mm M2,5 (2 pcs)
1 x Fully Threaded Steel Rod alumin 30 mm M3 (2 pcs)
1 x Pushrod octagone 4/3 with coupler M3
1 x Fully Threaded Steel Rod alumin 40 mm M2,5 (2 pcs)
1 x Fully Threaded Steel Rod M2,5 (2 uds)
1 x EXTRA NG 74" white/red/blue (Skywing RC)
1 x Fully Threaded Steel Rod Duralumin 40 mm M3 (2 pcs)
1 x Fully Threaded Steel Rod alumin 100 mm M3 (2 pcs)
1 x Fully Threaded Steel Rod alumin 30 mm M2,5 (2 pcs)
1 x Fully Threaded Steel Rod Duralumin 110 mm M3 (2 pcs)
1 x Fully Threaded Steel Rod SUS303 70mm M3 (2 pcs)
1 x Fully Threaded Steel Rod Duralumin 90 mm M3 (2 pcs)
1 x Servo GO-1035MG 16 kg.cm 0.08s/60º
1 x Motor DLE 170 M- Paramotors
1 x Fully Threaded Steel Rod alumin 50 mm M3 (2 pcs)
1 x Fully Threaded Steel Rod Duralumin 80 mm M3 (2 pcs)
1 x Pushrod octagone 4/3
1 x Vasa model Catapult
1 x Adapter lead MPX/XT60
1 x TrainerCord (master-learner)
1 x Balanceradapter JST-XH (Heli 47G) 2-6 c.
1 x Balance "Y" Wire 6S, 2x JST-XH / 1x JST-EH
1 x Bec MR UBEC 5A (5v/6v/7v)
1 x Black copper lacquer wire Ø0,2 mm (5 m)
1 x Red copper lacquer wire Ø0,2 mm (5 m)
1 x CC 05
1 x Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm)
1 x Dean "T" - Futaba Adapter
1 x MPX-Dean "T" Adapter
1 x Copper lacquer wire Ø0,2 mm (5 m)
1 x 3 LiPo XH>EH adapter
1 x Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH
3,138.67EUR
Manufacturers
Manufacturer Info
Roi-Import
Roi-Import Homepage
Other products
Languages
Español English
Currencies