15.06EUR

Opto Gas Engine Kill Switch
[ROI142KS]


This kill switch is Optically Coupled to isolate your ignition system from your radio system. (No Interference!!) this device features the following:

•Includes a remote mountable bright LED to indicate when the ignition is armed.
• Optically Coupled input/output is Isolated.
• 8 Bit PIC Controller.
• Li-Po/Li-Ion/A123/Ni-Mh/NiCad Input.
• Up to 20 Volt 15 amp MOS-FET output.
• DSP Noise/Loss of signal Filtering.
• PPM-PCM 2048 – 1024 & 2.4Ghz Interface Support.
• Low Voltage Drop – Less than 150mv.
• 100% Surface Mount Technology.
• Heavy Gauge Wires, universal connectors.
• Small and light weight – only 12 Grams!

This device plugs into a spare receiver channel.

This is a must have safety device for any gas powered plane! This device allows you to safely kill your engine at anytime (on the ground, or inthe air!)


few units
few units

Reviews

Customers who bought this product also purchased
Propeller MENZ-S 18x12
Propeller MENZ-S 18x12

few units
few units

Cylidric hinge 33 mm Ø 2 mm (5 pcs)
Cylidric hinge 33 mm Ø 2 mm (5 pcs)

few units
few units

MPS Gas-Cap-Powerswitch
MPS Gas-Cap-Powerswitch

few units
few units

Propeller MENZ-S 17x10
Propeller MENZ-S 17x10

few units
few units

Straightened rod Ø 1.0 mm x 1000 mm
Straightened rod Ø 1.0 mm x 1000 mm

few units
few units

Tacometer mini ignition RCEXL
Tacometer mini ignition RCEXL

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x ABS 500 x 400 x 2,0 mm (white)
1 x Breatex™ Non-woven absorber 300 g/m² Roll 41 m
1 x Buy Perforated film 100 cm / 20 m
1 x Breatex™ Non-woven absorber 150 g/m² Roll 50m
1 x Breatex™ Non-woven absorber 150 g/m² Roll 5 m
1 x Carbon Fiber TeXtreme® 80 g/m² (plain) 100 cm, roll/ 10 m
1 x ABS 500 x 400 x 1,5 mm (white)
1 x Carbon fabric 160 g/m² (plain weave) 100 cm x 2 m
1 x Breatex™ Non-woven absorber 150 g/m² Roll 100m
1 x Carbon fabric 200 g/m² (Aero, plain weave) 100 cm x 3m
1 x Carbon fibre tape 125 g/m², 3k, UD (25 mm) roll/ 10 m
1 x Buy Perforated film 100 cm / 10 m
1 x Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 10 m
1 x ARAMID honeycomb 1300x2600x2 mm
1 x Carbon fibre sandwich sheet 350x150x3 mm
1 x Breatex™ Non-woven absorber 150 g/m² Roll 20m
1 x Aluminium sheet 500x250x0,5mm
1 x Carbon fibre sleeve 12k 170 mm x 5m
1 x Conector BEC male (10 pcs)
1 x Connectors banna oro 8,0 mm 5 pcs(Female)
1 x Connectors banna oro 2 mm (M/F)
1 x Connectors banna oro 2 mm (M/F) (ultralight)
1 x XH male balance (3S) connector (2 pcs)
1 x Conector Servo female 4 pines
1 x Wing connector 8pin with pin strip, plug & socket
1 x EC5-Set female, simple quality, 2 x female pin, 1 x blue housing
1 x Optotronix Aurora Plug
1 x 2 mm male connector (2 pcs) with safety connector
1 x Xplorer4 anemometro
1 x XH male balance (2S) connector (2 pcs)
1 x 30 cm DEANS female connector
1 x 2 mm female connector (2 pcs) with safety connector
1 x Connectors DEANS (T)
1 x EC5-Set male, simple quality, 2 x female pin, 1 x blue housing
1 x Connectors banna oro 4 mm (M/F)
1 x Connectors banana oro 6,0 mm Ultralight (M/F)
1 x Connectors banna oro 8,0 mm (M/F)
1 x Banna gold connector 2,5 mm (M/F)
1 x Gold antispark 4 mm plug
1 x MPX Sub-D Adaptor
1 x Xplorer3 anemometro
1 x Xplorer1 anemometro
1 x XH female balance (5S) connector (2 pcs)
1 x Connector CAN 15
1 x Xplorer2 anemometro
1 x Connectors DEANS 4 pins (1 pair)
1 x Paramotor Trike XL
1 x Para-RC Mix
1 x Set cintas unión paracaídas 145 cm
1 x Windsock Ozone L - 700 mm
1 x Para-RC Trike "RC-Bullix"
1 x Trike XL motor set (motor+esc+prop)
1 x Paramotor BackPack XXS (without accessories)
1 x Paramotor Kit Camo H1.5/ Ben Red
1 x Windsock Ozone L -1200 mm
1 x Para-RC "RC-Evo-Cross" Rescue
1 x Pin type hinge Al 4,5x70 mm (2 pcs)
1 x Nylon hinge for flaps/gates 27x10,5 (2 pcs)
1 x Cylidric hinge 43 mm Ø 2,5 mm (5 pcs)
1 x Pin type hinge Al 6x98 mm (2 pcs)
1 x Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs)
1 x Long pinned hinge (12 uds)
1 x Gates hinge aluminium (1 pcs)
1 x 15 mm reinforced hinge
1 x Large flex hinge (12 uds)
1 x Nylon hinge 20x20x0,3 (10 pcs)
1 x Pin type hinge Al 4,5x70 mm demount (2 pcs)
1 x Micro flex hinge (12 uds)
1 x 76 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs)
1 x 48 x 10 mm cylidric hinge Ø 3,0 mm (10 pcs)
1 x Piloto jet 130 mm
1 x Civilian pilot "G-Man" size 9cm (Slimline)
1 x Pilot "Adolf" Legends Series (Slimline)
1 x Piloto RC Civil 1/5- 1/6 Scale 12"
1 x Civilian pilot "Joe" size 9cm (Slimline)
1 x Militarian pilot "Kamikaze" size 9cm (Slimline)
1 x Pilot "Duke" Legends Series (Slimline)
1 x Piloto JET 1:3,5
1 x 1/6 Pilot "Cindy"
1 x Bungee HLG Premium
1 x 1/12 Pilot "Cougar"
1 x Piloto Jet "Red" 1/6 Scale
1 x 1/12 Pilot "Langley"
1 x 1/6 Pilot "Buddy"
1 x Extinguisher CO2 - 2 Kg
1 x Vasa model Catapult
1 x Small Crow DLE-170M
1 x 3 LiPo XH>EH adapter
1 x MPX-Dean "T" Adapter
1 x Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm)
1 x TP/TopFuel - JST-EH 4/5S Adapter
1 x CM-3
1 x Adapter lead MPX/XT60
1 x Adapter lead MPX/EC3
1 x CC 03
1 x CellPRO 4S Adaptader (GP/KO up to 4S)
1 x Circlick securite
1 x 30 cm BEC cable (female)
1 x 3 copper lacquer wire Ø0,2 mm (1 m)
1 x Red copper lacquer wire Ø0,2 mm (5 m)
1 x Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm)
1 x DUPLEX USBa USB-Adapter for Jeti Duplex Items
1 x JETImodel SINGLE BEC
1 x CC 02
1 x USB HLS prog. interface
1 x CC 01
1 x Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm)
5,675.18EUR
Manufacturers
Manufacturer Info
Roi-Import
Roi-Import Homepage
Other products
Languages
Español English
Currencies