Top » Catalog » Outlet Zone » Accesories »

59.00EUR 19.90EUR

Servo Controller Fibra optica

Servo controller based on fibre-optic transmission, allows to place e.g. throttle servo right next to the ignition without anxiety about disruptions “transfer” to the RC receiver.

Fibre-optic servo controller was designed as complement to the fibre-optic ignition cutoff. However, nothing stands on the way to exploit it independently.

The main task of controller is a possibility to place throttle servo close to the engine, so the throttle control link is short. Typically disadvantage of such installation is small servo distance and its wires from the engine ignition unit. Taking into account the adverse impact of electromagnetic noise caused by the ignition, which could get to the RC circuit, controller communicates with the receiver exclusively by fibre-optic which is resistant to electromagnetic disruptions. Thanks to that there is a minimum 30 cm distance between the ignition and the RC circuit in the model. In this case throttle servo is powered by the same package as the ignition unit.

Fibre-optic servo controller can be used also for other purposes than controlling the throttle. It will work everywhere where long wires are adversely affecting the electronics operation. With its help it is possible to control the servo move being in a significant distance or everywhere where a galvanic isolation of implementation servo elements from steering electronics is required.

FORCE Servo controller correctly works with voltage range from 3.6 V on the RC receiver side, and 3.6 V on the servo power supply side. Maximum allowed supply voltage on both sides is 16.0 V. It is necessary to remember not to exceed the allowed servo voltage, and if necessary to use appropriate voltage regulator.

FORCE Servo controller consists of the fibre-optic transmitter module plugged in the RC receiver and powered directly from it. Fibre-optic receiver module powered from the ignition battery. Fibre-optic wire*. For correct operation the device requires separate channel from the receiver (in most cases CH3).

Technical data:
Fiber Optic transmitter
– dimensions: 35mm x 11mm x 13mm
– receiver plug: Futaba, female 300mm
– power supply: 3,6V – 13,0V
* 2 – 3 x (LiPo/Li-Ion/LiFe)
* 4 – 9 x (NiMh/NiCd)
– weight: ~ 10,0 gram

Fiber Optic receiver
– dimensions: 47mm x 21mm x 13 mm
– battery plug: Futaba / JR male 150mm
– servo plug: Futaba / JR male 150mm
– power supply: 3,6V – 13,0V
* 2 – 3 x (LiPo/Li-Ion/LiFe)
* 4 – 9 x (NiMh/NiCd)
– weight: ~ 15,0 gram
– load capacity: constant 5 A, temporarily 30 A

few units

Reviews

Quick Find

Shopping Cart

2 x	Green smoke canister 100 g
2 x	Red smoke canister 140 g
2 x	3l Smoke oil
2 x	Ventral support for AX-18/AX-60
3 x	White smoke canister 100 g
2 x	Green smoke canister 140 g
1 x	Parachutist
3 x	B4-0 rocket charges (6 pcs)
1 x	Parachute expulsion foam
3 x	White smoke bombs AX-9 (10 pcs)
1 x	Smoke set "S"
2 x	Blue smoke canister 140 g
2 x	Initior Receiver FRX2 Wireless
2 x	"M" set
2 x	Smoke set "M"
3 x	Initior Transmitter FTX2 Wireless
3 x	Plastic caps for AIR BURTS (30 pcs)
1 x	"S" set for planes
2 x	Red smoke canister 65 g
2 x	White smoke bombs AX-3 (10 pcs)
1 x	Stainless steel cable Ø 1.3 mm (10 m)
2 x	Mixers smoke bombs AX-60 (5 pcs)
1 x	White smoke canister 140 g
1 x	Electric rocket starters (6 pcs)
1 x	1/12 Pilot "Fighter"
1 x	White smoke bombs AX-18 (5 pcs)
1 x	Yellow smoke canister 100 g
1 x	Steering arm 12 mm Ø 4 mm (2 uds)
1 x	Screw-lock pushrod conn snap Ø 1.5 mm (2 uds)
1 x	Remote electric ignition system
3 x	1/4 Pilot "Heidi"
2 x	Civilian pilot "Curt" size 9cm (Slimline)
1 x	Locking cable tie 3.2x142 (uds)
1 x	Piloto WWII USAAF 12" Scale 1/6 - 1/5
1 x	1/12 Pilot "Cougar"
2 x	Wing tips support for AX-18/AX-60 (2 pcs)
1 x	Stainless steel cable Ø 0.52 mm - 15 kp (10 m)
1 x	Canopy Lock V1 M3 Blue (2 pcs)
1 x	Cierre cabina aluminio Ø5, I=16 mm
1 x	AX-60 starters (5 pcs)
1 x	"S" set for boats
1 x	Covered closure or fairings
1 x	Steering arm 16 mm Ø 4 mm
1 x	Stainless steel cable Ø 0.62 mm (10 m)
1 x	1/6 Pilot "Buddy"
1 x	Steering arm 12 mm Ø 3 mm (2 uds)
1 x	Yellow smoke canister 140 g
1 x	Civilian pilot "Joe" size 9cm (Slimline)
1 x	L cockpit anchor "tipe F3A" (2 pcs)
1 x	Piloto Jet "Red" 1/6 Scale
2 x	Yellow smoke bombs AX-60 (5 pcs)
1 x	Yellow smoke canister 65 g
3 x	Pilot WWII US Navy Pacific 12" Scale 1/6-1/5
1 x	Screw-lock connector Ø 2 mm (2 uds)
1 x	Red smoke bombs AX-60 (5 pcs)
2 x	1/6 Pilot "Garry"
1 x	Militarian pilot "Kamikaze" size 9cm (Slimline)
1 x	Screw-lock connector M2 (2 uds)
2 x	Steering arm 12 mm Ø 4 mm
1 x	Crimping sleeves for cable 1.3 mm (10 pcs)
1 x	Crimping sleeves for cable 0.85 mm (10 pcs)
4 x	1/6 Pilot "Tony"
1 x	Crimping sleeves for cable 0.70 mm (10 pcs)
1 x	Cockpit plastic closing
2 x	Pilot "Goose" (Slimline)
1 x	1/4 Pilot "Mike"
1 x	1/6 Pilot "John"
2 x	Cierre cabina aluminio Ø4, I=10 mm
1 x	Piloto jet 130 mm
1 x	67 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs)
1 x	67 mm cylidric hinge Ø 4,5 mm (5 pcs)
1 x	Nylon hinge 15x0,3 (10 pcs)
1 x	Gates hinge 30x16 mm (2 pcs)
1 x	Pin type hinge Al 4,5x70 mm to wire (2 pcs)
2 x	Flap hinge (6 pcs)
2 x	Flap hinge 33x9 mm (6 pcs)
1 x	Fast'n EZ-CA-Hinge (12 uds)
2 x	Cylidric hinge 33 mm Ø 2 mm (5 pcs)
2 x	Gates hinge black 30x16 mm (2 pcs)
1 x	Nylon hinge for flaps 33x9 (2 pcs)
2 x	Micro flex hinge (12 uds)
1 x	15 mm reinforced hinge
1 x	Aluminum Bayonet / strongal D25 mm / 1 m
1 x	67 mm cylidric hinge Ø 5 mm (4 pcs)
1 x	48 mm cylidric hinge Ø 2,5 mm (5 pcs)
1 x	Large flex hinge (12 uds)
1 x	Long pinned hinge (6 uds)
1 x	Nylon hinge 20x15x0,3 (10 pcs)
1 x	Long pinned hinge (12 uds)
1 x	Nylon hinge 20x20x0,3 (10 pcs)
1 x	Pin type hinge Al 4,5x70 mm demount (2 pcs)
1 x	Pin type hinge Al 3,0x50 mm demount (2 pcs)
1 x	33 x 8 mm cylidric hinge Ø 2,5 mm (10 pcs)
1 x	Vest clothes Hispano Aviación
2 x	Shirt Hispano Aviación
1 x	Cap Hispano Aviación
1 x
1 x	Crimping tool
1 x	Cut tube
1 x	Ball Link Plier
1 x	1,5x50 mm allen screwdriver
1 x	Vacuum pump 12 CFM
1 x	Digital precision scale up to 2000 g
1 x	Starter Sullivan-STAR 603 DINATRON
1 x	Vacuum Connection VA 1 (for hose Ø 6 mm)
1 x	Screwdriver for Torx® TX8
1 x	Vacuum pump P1-N
1 x	Tape GFK 25 mm
1 x	Oracover Verde 2 m
1 x	Profile ABS half cane 2.5x1000 mm
1 x	Medidor ángulos y/o incidencias
1 x	Green smoke canister 65 g
1 x	Jeti Black cap
1 x	ABS tube 16.0x14.0x1000 mm
3 x	PCARD Wireless System
2 x	Red smoke canister 100 g
1 x	Steering arm 16 mm Ø 3 mm
1 x	Steering arm 16 mm Ø 3 mm (2 uds)
1 x	38x4,5 mm wires output (2 pcs)
2 x	One touch canopy lock
2 x	AX-60 starters (5 pcs)
1 x	Civilian pilot "Gramps" size 9cm (Slimline)
1 x	Smoke set "Glider"
1 x	1/6 Pilot "Cindy"
1 x	Pilot "Anthony" (Slimline)
1 x	Allen wheel collar M3x5
1 x	White smoke canister 65 g
1 x	Clip mini fixing for wing (2 pcs)
1 x	Fully Threaded Steel Rod alumin 70 mm M3 (2 pcs)
1 x	Fully Threaded Steel Rod Duralumin 70 mm M3 (2 pcs)
1 x	Blue smoke canister 100 g
1 x	Clip fixing for wing (2 pcs)
1 x	Fully Threaded Steel Rod alumin 40 mm M3 (2 pcs)
1 x	45 mm rods set for direction control
1 x	Fully Threaded Steel Rod alumin 60 mm M3 (2 pcs) knurled
1 x	90 mm rods + T patellas set for direction control
1 x	Pushrod octagone 4/3
1 x	Power supply NT 25 Amp.
1 x	43 x 10 mm cylidric hinge Ø 2,5 mm (10 pcs)
1 x	Pin type hinge Al 4,5x70 mm (2 pcs)
1 x	Robart Door Hinge (Pk2)
1 x	Cylidric hinge 43 mm Ø 2,5 mm (5 pcs)
1 x	Black smoke bombs AX-60 (5 pcs)
1 x	Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs)
1 x	120x60 mm SLH KOVO wheel
1 x	1/12 Pilot "Tom"
1 x	Locking cable tie 4.6x203 (uds)
1 x	100g Flux Paste for Silver Solder
1 x	Dremel PERMAGRIT 18 mm round lime
1 x	2,5x60 mm allen screwdriver
1 x	Piloto RC Civil 1/5- 1/6 Scale 12"
1 x	Fresa corte diamante Ø 2.3mm (bola)

7,402.26EUR

Manufacturers

Manufacturer Info


-	SETLO Homepage
-	Other products

Notifications

Notify me of updates to Servo Controller Fibra optica

Reviews

Write a review on this product!

Languages

Currencies

Insurance