36.16EUR

Epoxy Casting Resin + Hardener "water-clear" (300 min)
[R1071023]


Epoxy Casting Resin + Hardener "water-clear" (300 min)

General information about the System Epoxy Casting Resin + Hardener "water-clear):
Two-component clear, colourless epoxy system.
The following properties distinguish it from the predecessor EP cast resin “crystal clear”:
Excellent UV resistance for epoxy resins*)
Supertransparent constituents
Polishable, hard surface
Excellent impact strength
Completely tackfree curing even in thin coats
Ideal for transparent coatings
Also suitable as a laminating resin system with a very long pot life
The system's reactivity was raised for smaller initial and casting quantities. An initial batch size of 400 g can be cast per mould without the surface collapsing. Casting thicknesses up to 40 mm are possible with larger initial quantities.

Like all reactive resin systems the casting quantity is limited by the generated reaction heat (exothermal reaction): often a lower curing temperature (e.g. at an ambient night temperature lower than 20 °C) can counteract too great an exothermal reaction.

Pot life : approx. 300 minutes

Mixing ratio:
100 : 37 parts by weight of resin to hardener
100 : 47 parts by volume of resin to hardener

Curing time: approx. 24–48 h

Processing:
Resin and hardener are homogenised for about two minutes at room temperature (23 °C). Afterwards the mixture is left to rest for approx. 20 minutes.
Leave the ready mixture on a flat surface for 48 hours. Please do not mix or otherwise move the product. The total curing time ranges from 24 to 48 hours.
Expertise for the resin system casting resin + hardener "water-clear": this system is not cytotoxic (cell damaging), important for applications in medical purposes!
*) This system has very good UV resistance for EP resins, but, like all epoxy resins, it can turn more or less yellow over time under high UV exposure. Therefore only conditionally suitable for outdoor applications or permanent exposure to artificial light sources.
Typical areas of application: Indoor: railway models, works of art, stage decorations, etc. (only occasionally exposed to UV sources).


temporarily out of stock
temporarily out of stock

Reviews
Categories
* OFFER MONTH *
Planes->
Sailplanes->
Autogyros->
Helicopters->
UAVs - RPAs->
Multicopters->
Hardware->
  
  3D IMPRESION
  ABS Rods-Strips
  ABS/GFK/CFK plate
  Actuator
  Adapters->
  Adhesives/Resin/Epoxy->
    Cianocrylate->
    Epoxy->
      EMC-Vega
      KAVAN
      Loctite
      Resoltech
      Epoxy BSI
      Epoxy R-G
    Resin/Gelcoat
    Glass Bubbles
    Contact adhesive
  Altimeters->
  Amperimeters
  Anemometer
  Auto-Pilot
  Bags/Covers
  Batteries->
  BEC/Cables/Conectors/Interruptor
  Bungee Launchers
  Cables
  Cameras->
  Carbon rod
  Carbon/Brass/Steel/ABS/Aluminium
  Catalogues
  Chargers->
  Clevis
  Combustible->
  Connectors
  Control horns
  Controlers->
  Coverings/Thermoretrac
  Decals
  Extension
  Extinguisher
  Ferritas
  Glasses
  Hardware
  Hinges
  Instruments / Panels
  Lights/Ilumination->
  Linkages
  Merchandising
  Motor
  Pilots
  Pinion extractor
  Power supply system/Data Recordi->
  Profiles
  Propelers->
  Screws
  Servos->
  Simulators
  Smoke/Rocketry/Fireworks
  Spinners->
  Spray/Painting/Dope/Solder Paste
  Steel/brass Rod/Aluminium
  Support/CG/Incidenc.
  Tapes/Closed/Bridles
  Tools
  Towing
  Transmitters/Receivers->
  Undercarriage->
  Wheels & Axles->
  Wing Joiner
  Wood
Car/Trucks->
Motors & Turbines->
Gas. Motor Paramotors
Acces. for Motors->
Paragliders/Parachutes/Windsock
Boats/Naval units->
FPV->
Robots->
CNC cut
Roof BOX
Crash kits
Outlet Zone->
Used
Merchandising HA
We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
3 x Small Crow DLE-170M
2 x Motor DLE 200cc Premium Muffler
1 x Silicone 0,50 qmm servos wire Futaba (100 m)
1 x SCHARNHORST accessories
1 x Nut M1,6
1 x Aluminium alloy coupler for carbon tube 6/M4
3 x Me-163
1 x Flat washer 1.7 mm (20 pcs)
1 x Aluminium cap bolt washer M3 green (8 pcs)
1 x OLED-Display for PowerBox Mercury SRS
1 x 90x75 mm standart servo cover
2 x Covered closure or fairings
1 x ‎Reed valve for DA-60/70
1 x Reed valve for DA 50-R
1 x Savox HV Brushless Servo SB-2270SG (Swashplate)
1 x BlueCom™ Adapter (Android / WP)
1 x Tirpiz Battleship 1:200
1 x Screw-lock pushrod conn snap Ø 1.5 mm (2 uds)
1 x Silicone red 0,75 qmm wire ( 25 m)
1 x Aluminium wide washer M4 Blue (4 pcs)
1 x Swift S1 De-luxe JEPPESEN 3.140 mm
3 x VBar NEO
1 x Lock washer 4.3 mm (20 pcs)
1 x Walnut wood slat 1.5x1.5x1000 mm
1 x Digital Air Speed Sensor And Pitot Tube Set
1 x MVVS exhaust gasket 26cc
1 x Quicklock washer 1 mm (10 pcs)
1 x Nose wheel 62 mm
1 x Motor Mount for TITAN ZG45 and ZG62, length 36 mm
1 x Silicone 0,14 qmm servos wire Graupner (5 m)
1 x Birch plywood plate 600x300x3.0 mm
1 x Servo TT ACE SHV 1504 MG
1 x Spring lock washer 4.1 mm (20 pcs)
1 x Steering arm 16 mm Ø 3 mm (2 uds)
2 x Stainless steel cable Ø 0.52 mm - 15 kp (10 m)
1 x Steel tube (L 1000 mm Ø6 mm, Ø5,7 mm)
1 x Cierva C30 spanish decoration Stickers
1 x 1 m servo "Premium" wire (white/red/blue)
1 x Canister combo DLE 120 cc
1 x Servo TOPMODEL S7520 MG
1 x PPM Encoder Module
1 x Servo Fork
1 x Circlik for shaft 1.9 mm (10 pcs)
1 x A/C quality beech plywood 600x300x1.5 mm
1 x 5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x Stickers-digit for marking
1 x Walnut wood slat 2.0x2.0x1000 mm
1 x Locking cable tie 3.2x142 (uds)
1 x Head upper part
1 x Fox MDM 1 6000 mm
1 x Aluminium wide washer M4 Gold (4 pcs)
2 x 
1 x Superlight wheel 125 mm with valve (2 pcs)
1 x Dia. 25x5 mm tefon tube for escape
1 x LA500 front gear holder
2 x Canister combo DLE 111 cc
1 x Piston ring for ZG 26SC/EI, ZG 26SCM ZG 26SLH and Zenoah G260RC/
1 x Steel tube (L 1000 mm Ø8 mm, Ø7,7 mm)
1 x Lock washer 2.7 mm (20 pcs)
1 x Silicone 0,25 qmm servos wire Graupner (100 m)
1 x Piñon motor rotor LA-500
1 x 20x200 mm battery rings
1 x Aluminium cap bolt washer M4 red (8 pcs)
1 x Intake tube ZG 74/80, DA85, VM 170-420 with special screws
1 x Head lower part New
1 x Protective Cover for wires Ø 15 mm 1000 mm
1 x ZENOAH ZG 26SLH Helicopter Engine
1 x AL Axle Shaft 4.0x16 mm (2 uds)
1 x LO 100 ARC 3.3m,frame canopy
1 x DG-303 ACRO 3750 mm, winglets
1 x Straightened rod Ø 1.0 mm x 1000 mm
1 x Sparkplug Saito 400
1 x A/C quality beech plywood 498x247x2.0 mm
1 x Landing gear axle Ø 4 mm (2 uds)
1 x Carburetor for ZG45SL and ZG62/S/SL
1 x Superlight deluxe wheel 56 mm (2 pcs)
1 x PVC 0,08 qmm Futaba servos wire (5 m)
1 x Super Light Wheels(Sponge Tyre) Ø 50mm x 19mm (2pcs) axis Ø 3.5m
1 x Carburetor DLE 170M
1 x Extinguisher CO2 - 2 Kg
1 x Cierva C30 Body Spain
1 x Servo Controller Fibra optica
1 x Y Cable
1 x Kit repair carburator DLE-85/111/120/222
1 x PowerBUS Lead 90 cm
1 x Motor Mega AC 16/25/03
1 x Screw M4x12 (10 pcs)
1 x Propeller CFK 18x9
1 x BOSCH spark plug cap for DA 50-R, DA 100 and DA 150
1 x Servo FUTABA SBL 471 SV
1 x Protective open Cover for wires Ø 13 mm 1000 mm
1 x Class 30, Yellow wheel pants (SebART)
1 x "L" servo arm 65x49 mm (2 pcs)
1 x Suction funnel for carburetor DA70- MVVW 190cc (red)
1 x DA 85 / DA 100 / DA 100 L carburetor
1 x Cockpit plastic closing
1 x Propeller Pleg CAM Carbon 11x6
1 x Piston ring for ZG 20 and G240RC
1 x Spring Clip Ø25 mm
1 x Propeller Pleg CAM Carbon 10x7
1 x Motor Mega AC 16/15/04 COMBAT
1 x GPS Expander Module
1 x PowerBUS Lead 30 cm
1 x 14x60 mm Mini rings Tie Wraps (4 pcs)
1 x Sparkplug DLE CM6
1 x Aluminun wheel collar 4 mm Ø (4 uds)
1 x Propeller RF CFK 14.5x14
1 x Propeller CFK 17x18
1 x Offshore-Schleppwinde Bs
1 x Walbro carburetor for MVVS 26/30/35/40 cc
1 x Motor Mega AC 16/30/01
1 x Red aluminium servo arm V2-Futaba 1,5" inch M3
1 x ABS tube 6.0x4.0x1000 mm
1 x Indoor landing gear set
1 x Suction funnel for carburetor 90D-L (red)
1 x AngelS 30E YELLOW/BLACK (SebART)
1 x Mini neumatic retract 3 mm landing gear (Het-rc)
1 x LO 100 ARC 3.3m
1 x ESC XREG 80 Amp 2-6 LiPo BEC 5V/3A
1 x Shaft sleeve LAMA
1 x LO 100 Scale 1:2 - Modellbau Bruckmann
1 x Kit hydraulic brake
1 x Modulo telemetria 500 mW/100 mw Radio aire/Tierra Modulo 915 MHz
1 x Motor B50-10L Competition + 6,7:1
1 x THERMIK XXXL 4,9m CFK Electric
1 x Exhaust K45TP
1 x Para-RC "RC-Evo-Cross" Rescue
1 x Muffler DLE-120 Right
1 x Piston ring for DLE-20
1 x DLE 55 RA pipe plug
1 x T-shape holder metal LAMA
1 x 21x12D BIELA propeller (3-blades)
1 x 4" - 102 x 45 mm Ø5 mm aluminium core wheel
1 x Turbine KingTech K30G Restart
1 x TopFuel LiPo 35C-POWER-X 2400mAh 2S
1 x Motor DLE 430 cc - Paramotors
1 x PVC transparent battery termo-retract 195 mm (1 m)
1 x MIG 29 EDF
1 x Foreman, scale 1:32
1 x DLE 111 pipe plug
1 x Silent-blocks DLE 170M
1 x Cabel PVC 2 x 0.25 mm2 (5 m) red-black
31,442.21EUR
Manufacturers
Manufacturer Info
R-G.de
R-G.de Homepage
Other products
Languages
Español English
Currencies