439.01EUR

PowerBox Competition SR2
[POWER4450]


Features

22 channels
High-performance battery backer with high continuous load capacity
2.4” TFT screen, legible in sunlight
Bi-lingual menu system
Consistent duplication of all power electronics
Redundant electronic switch
Servo matching for all 22 outputs
Auto matching function
Two independent door sequencers with Setup Assistant
The latest integrated iGyro technology, using the iGyroSAT as gyro sensor
Twelve independent gyro outputs for: 4x aileron, 4x elevator, 4x rudder
Individual gain control for all twelve gyro outputs
Special regulatory algorithm for fixed-wing models
System detects all transmitter mixers
Four selectable output voltages: 6.0 V, 7.4 V, 7.8 V or unregulated
Graphic menu diagrams ensure ultra-simple programming
Fast basic setup procedure using the sophisticated Assistant
Optional GPS III for speed-dependent gyro compensation
Telemetry data for PowerBox P²BUS, Futaba S.BUS2, Jeti Ex-BUS, Spektrum SRXL2, Multiplex M-Link and Graupner HoTT
Transmission of battery, receiver and GPS* data
Virtually all features can be controlled from PowerBox and Jeti transmitters
Selectable servo frame rate: 10ms, 12ms, 14ms, 16ms, 18ms
Servo feedback current suppression
Latest 32-bit micro-processor for precise, high-speed signal processing
High-performance machined heat-sink for optimised heat diffusion
Machined, anodised aluminium switch and screen case
Compact dimensions

Technical Data
Operating voltage 4.0V - 9.0V
Power supply 2S LiPo, 2S LiIon, 2S LiFePo, 5S NiCd/NiMH
Current drain Power-on state 260mA
Current drain Standby 30µA
Maximum load current 2x40A (<30s)
Drop-out voltage 0.3V
Output voltage 6.0V, 7.4V, 7.8V, unregulated
Signal input serial
Supported RC systems PowerBox, Futaba, Jeti, Spektrum, M-Link and Hott
Receiver redundancy SRS
Channels 26
Servo sockets 22
Programmable servo outputs 22
Servo signal resolution 0,25µs
Signal frame rate 10ms, 12ms, 14ms, 16ms, 18ms
Gyro sensor type external iGyro SAT
Number of sensor axes 12
Screen TFT 320x240 pixels
Integral door sequencer yes
Supported telemetry systems P²BUS, S.BUS2, EX-Tele, SRXL2, M-Link, Hott

Dimensions 107 x 69 x 19 mm
Weight 115g
Weight Sensor Switch 15g
Weight of LCD screen 34g
Temperature range -30°C to +105°C


Reviews
We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Aluminium coupler M3/2 with ball bearing (1 pcs)
1 x Kwik link AL M2,5 L:23 mm (2 pcs) + Pin Ø 1,6 mm
1 x Fully Threaded Steel Rod M2,5 (2 uds)
1 x Kwik link aluminio IZD. M3 L: 30mm (2 uds) pin Ø 2 mm
1 x Aluminium red ball links M3 V1 (10 pcs)
2 x Clevis plastico I=45 mm / hole 3mm / pin 1 (2 pcs)
1 x Cable coupler M2 (10 uds)
2 x Couple M4 for wire (10 pcs)
2 x Kwik link AL M4 L:40 mm (2 pcs) + Pin Ø 2,5 mm
3 x M4xM2,5xL30 nylon clevis and arm (10 uds)
1 x Metal ball clevis M3 (10 uds)
1 x Cable coupler M2,5 (2 pcs)
1 x Crimping sleeves for 1.1 mm cable (10 pcs)
1 x Black large kwik link (10 pcs)
1 x Kwik link AL M4 con Clip (2 pcs)
1 x Cable coupler M3 (10 uds)
2 x Kwik link AL M3 L:23 mm (2 pcs) + Pin Ø 1,6 mm
1 x Kwik link AL M3 L:30 mm (2 pcs) + Pin Ø 2,0 mm
2 x Aluminium coupler M2,5/2 with ball bearing (1 pcs)
1 x Kwik link AL M3 L:30 mm (2 pcs) + Pin Ø 1,6 mm
1 x Aluminium coupler M2/2 with ball bearing (1 pcs)
1 x Kwik link AL Ø2 mm L:23 mm (2 pcs) + Pin Ø 1,6 mm
1 x Screw-lock connector Ø 2 mm (2 uds)
1 x Vertical cockpit anchor "tipe F3A" (2 pcs)
1 x Steering arm 16 mm Ø 4 mm
1 x Cierre cabina aluminio Ø5, I=16 mm
1 x Covered closure or fairings
1 x Steering arm 16 mm Ø 4 mm (2 uds)
1 x Canopy Lock V1 M3 Blue (2 pcs)
1 x Stainless steel cable Ø 0.5 mm (20 m)
1 x Cockpit plastic closing
1 x Crimping sleeves for cable 1.3 mm (10 pcs)
1 x Crimping sleeves for cable 0.85 mm (10 pcs)
1 x Stainless steel cable Ø 0.52 mm - 15 kp (10 m)
1 x Stainless steel cable Ø 1.3 mm (10 m)
1 x Cap closure 33/23.5mm (2 uds)
1 x Cabin latch Fox MDM1 4m (pair)
1 x Steering arm 16 mm Ø 3 mm
1 x Electric spoiler 250 mm (2 pcs)
1 x Screw-lock pushrod conn snap Ø 1.5 mm (2 uds)
1 x Micro screw-lock pushrod conn snap Ø 1 mm (2 uds)
1 x Steering arm 12 mm Ø 4 mm (2 uds)
1 x Screw-lock connector M2 (2 uds)
1 x Horizontal cockpit anchor "tipe F3A" (2 pcs)
1 x Stainless steel cable Ø 0.88 mm - 60 kp (10 m)
1 x Locking cable tie 2.5x100 (uds)
1 x Steering arm 12 mm Ø 3 mm (2 uds)
1 x L cockpit anchor "tipe F3A" (2 pcs)
1 x Ball link Aluminio M3 (2 pcs)
1 x Clevis plastico I=26 mm / hole 2mm / pin 1 (2 pcs)
1 x Z type of cable coupler Ø 1.8 (2 uds)
1 x Kwik link with arm M5xM2,5xL30
1 x Ball Link ALU M3 - RH (1 pcs)
1 x Threaded coupler ALU M2 Ø 4 (2 uds)
1 x Ball link duraluminium M3 V1 (10 pcs)
1 x Ball link Aluminio M3 x 3 x 5 x 18mm (6 uds)
2 x Clevis plastico I=30 mm / hole 2.5mm / pin 1 (2 pcs)
1 x Pulley brass 10/2 (2 pcs)
1 x Kwik link with arm M3xM2xL24
1 x Ball link Aluminio M4 x 4 x 6 x 26mm (4 uds)
1 x BRASS CONTROL HORN M3x16 mm 2pcs
1 x Threaded coupler ALU M2,5 Ø 3 (2 uds)
1 x Threaded coupler M2,5 Ø 2 mm (10 pcs)
1 x Threaded coupler Micro M2 Ø 0,8 (10 pcs)
1 x Z type of cable coupler Ø 1 (2 uds)
1 x Threaded coupler ALU M3 Ø 5 (2 uds)
1 x Threaded coupler ALU M2,5 Ø 4 (2 uds)
1 x Kwik link AL M3 con Clip (2 pcs)
1 x Threaded coupler ALU M2,5 Ø 6 (2 uds)
1 x Ball link V1 Ø7 M4/3 (6 uds)
1 x Threaded coupler ALU M3 Ø 6 (2 uds)
1 x Threaded coupler ALU M3 Ø 4 (2 uds)
1 x Threaded coupler Micro M2 Ø 0,8 mm (10 pcs)
1 x Pulley brass 6/1,5 (2 pcs)
1 x Pulley brass 5/1,5 (2 pcs)
1 x Porta Kwik link M4 3 mm (2 pcs)
1 x Kwik link aluminio IZD. M2.5 L: 23mm (2 uds) pin Ø 1.6
1 x Ø 2 mm pin for Kwik link MPJ2162/2163 (6 pcs)
1 x Pulley brass 12/2 (2 pcs)
1 x Red copper lacquer wire Ø0,2 mm (5 m)
1 x Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm)
1 x Balanceradapter JST-XH (Heli 47G) 2-6 c.
1 x Piloto Jet "Green" 1/6 Scale
1 x CC 02
1 x Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm)
1 x Civilian pilot "Curt" size 9cm (Slimline)
1 x USB HLS prog. interface
1 x Pilot "Adolf" Legends Series (Slimline)
1 x CellPRO 4S Adaptader (GP/KO up to 4S)
1 x 1/4 Pilot "Heidi"
1 x Pilot "Dick" Legends Series (Slimline)
1 x TP/TopFuel - JST-EH 4/5S Adapter
1 x "Y" charging 4mm wire (2 IN-1 OUT).
1 x 1/4 Pilot "Mike"
1 x Civilian pilot "Joe" size 9cm (Slimline)
1 x 1/6 Pilot "Tony"
1 x Ventus 1:4 set of instruments
824.75EUR
Manufacturers
Languages
Español English
Currencies