439.01EUR

PowerBox Competition SR2
[POWER4450]


Features

22 channels
High-performance battery backer with high continuous load capacity
2.4” TFT screen, legible in sunlight
Bi-lingual menu system
Consistent duplication of all power electronics
Redundant electronic switch
Servo matching for all 22 outputs
Auto matching function
Two independent door sequencers with Setup Assistant
The latest integrated iGyro technology, using the iGyroSAT as gyro sensor
Twelve independent gyro outputs for: 4x aileron, 4x elevator, 4x rudder
Individual gain control for all twelve gyro outputs
Special regulatory algorithm for fixed-wing models
System detects all transmitter mixers
Four selectable output voltages: 6.0 V, 7.4 V, 7.8 V or unregulated
Graphic menu diagrams ensure ultra-simple programming
Fast basic setup procedure using the sophisticated Assistant
Optional GPS III for speed-dependent gyro compensation
Telemetry data for PowerBox P²BUS, Futaba S.BUS2, Jeti Ex-BUS, Spektrum SRXL2, Multiplex M-Link and Graupner HoTT
Transmission of battery, receiver and GPS* data
Virtually all features can be controlled from PowerBox and Jeti transmitters
Selectable servo frame rate: 10ms, 12ms, 14ms, 16ms, 18ms
Servo feedback current suppression
Latest 32-bit micro-processor for precise, high-speed signal processing
High-performance machined heat-sink for optimised heat diffusion
Machined, anodised aluminium switch and screen case
Compact dimensions

Technical Data
Operating voltage 4.0V - 9.0V
Power supply 2S LiPo, 2S LiIon, 2S LiFePo, 5S NiCd/NiMH
Current drain Power-on state 260mA
Current drain Standby 30µA
Maximum load current 2x40A (<30s)
Drop-out voltage 0.3V
Output voltage 6.0V, 7.4V, 7.8V, unregulated
Signal input serial
Supported RC systems PowerBox, Futaba, Jeti, Spektrum, M-Link and Hott
Receiver redundancy SRS
Channels 26
Servo sockets 22
Programmable servo outputs 22
Servo signal resolution 0,25µs
Signal frame rate 10ms, 12ms, 14ms, 16ms, 18ms
Gyro sensor type external iGyro SAT
Number of sensor axes 12
Screen TFT 320x240 pixels
Integral door sequencer yes
Supported telemetry systems P²BUS, S.BUS2, EX-Tele, SRXL2, M-Link, Hott

Dimensions 107 x 69 x 19 mm
Weight 115g
Weight Sensor Switch 15g
Weight of LCD screen 34g
Temperature range -30°C to +105°C


Reviews
We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x F450/550 Quadcopter, landing gear
1 x Motor brushless 1806 - 2300 Kv Cuadracopter
1 x Futaba Female 40 cm extension
1 x Extension silicon 30 cm male (Futaba)
1 x 1/6 Pilot "Garry"
1 x Cable-Tie 1.66x71mm / 0.07x2.8″ (20 pcs)
1 x BALSA trip 2.0x2.0x1000 mm
1 x Ball link Aluminio M3 (2 pcs)
1 x 200 mm extensión servo HITEC/JR
1 x 13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x Aluminium cap bolt washer M3 red (8 pcs)
1 x Aluminium wide washer M4 Red (4 pcs)
1 x Ball link duraluminium M3 V1 (10 pcs)
1 x Threaded coupler M2 (10 uds)
1 x Threaded coupler Micro M2 Ø 0,8 mm (10 pcs)
1 x Threaded coupler M2,5 Ø 3 mm (10 pcs)
1 x XH female balance (5S) connector (2 pcs)
1 x Piloto RC Civil 1/5- 1/6 Scale 12"
1 x BALSA leading edge 8x10x1000 mm
1 x Z type of cable coupler Ø 1.8 (2 uds)
1 x Extension silicon 35 cm male (Futaba)
1 x SE Ring HACKER 300 mm (2 pcs)
1 x Carbon fiber rod 10 mm x 1000 mm
1 x Aluminium blue ball links M3 V1 (10 pcs)
1 x 20x200 mm battery rings
1 x Threaded coupler ALU M3 Ø 6 (2 uds)
1 x Ball link Aluminio M4 x 4 x 6 x 26mm (4 uds)
1 x Panasonic Eneloop AA 1,2 V battery 19>00 mAh
1 x Strip 3,5x1,75x330 mm
1 x Carbon fiber rod 6.0 mmx1000 mm
1 x 20x1000 mm Ring Strap Back To Back
1 x L cockpit anchor "tipe F3A" (2 pcs)
1 x Futaba Female 40 cm extension
1 x Extension S-Bus 1-2 silicon 30 cm FUTABA
1 x Prolongador S-Bus JR/JR 10cm
1 x Pine wood slat 1.5x3.0x1000 mm
1 x BALSA trip 3.0x5.0x1000 mm
1 x 1/4 Pilot "Mike"
1 x Aluminium cap bolt washer M4 blue (8 pcs)
1 x Quicklock washer 4 mm (10 pcs)
1 x Linden wood slat 3.0x3.0x1000 mm
1 x MPX Sub-D Adaptor
1 x Aluminium coupler M2/2 with ball bearing (1 pcs)
1 x Aluminium wide washer M3 blue (4 pcs)
1 x Circlik for shaft 1.9 mm (10 pcs)
1 x Carbon fiber rod 2.5 mmx1000 mm
1 x Xplorer4 anemometro
1 x M3 black washers (4 pcs)
1 x 10 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x ABS Strip 1.0x5.0x1000 mm
1 x RUDDOG Protection and Heat Shield Tape (2mx50mm)
1 x Aluminium coupler M2,5/2 with ball bearing (1 pcs)
1 x Threaded coupler ALU M2 Ø 4 (2 uds)
1 x Angled clevis with threaded rod M3
1 x Flat washer 4.3 mm (20 pcs)
1 x Ball link Aluminio M3 (6 uds) 27x11.9x5.9 mm
1 x Ball link Aluminio M3 x 3 x 5 x 18mm (6 uds)
1 x Connectors DEANS 4 pins (1 pair)
1 x Pad self adhesive, up to 3mm / 0.12″, (10 pcs)
1 x Strip ABS 2.0x5.0x1000 mm
1 x Piloto JET 1:3,5
1 x ABS I Strip 20x10x1000 mm
1 x Aceite DELUXE turbine Jet Oil 1 litro
1 x 800TVL CMOS camera for FPV
1 x Carbon fiber rod 5.0 mmx1000 mm
1 x Cable S.BUS 3 salidas 100 mm
1 x Conector BEC male (10 pcs)
1 x Carbon fiber rod 8.0 mmx1000 mm
991.81EUR
Manufacturers
Languages
Español English
Currencies